RESUMEN
Evaluating factors that may influence the nose dimensions and, therefore, contribute to the singularity of a person, is important for obtaining a precise facial reconstruction (FR) in forensic anthropology. Thus, the aim in this study was to evaluate the influence of sex, skeletal class, and facial type on nose dimensions of Brazilian individuals using cone-beam computed tomography (CBCT) scans. CBCT images of 54 males and 67 females were classified according to skeletal class (class I, II, or III) and facial type (brachycephalic, dolichocephalic and mesocephalic). Linear and angular measurements of the nose were performed using the CS 3D Imaging software. The measurements obtained for males and females were compared by one-way ANOVA. Two-way ANOVA was used to compare the measurements in the different skeletal classes and facial types. Significance level was set at 5%. All linear measurements were greater in males (p < 0.05); the angular measurements, however, did not differ between sexes (p > 0.05). Linear and angular measurements of class III males were significantly different from the other classes; the same was observed for the angular measurements in females (p < 0.05). Regarding facial types, some linear measurements were significantly greater in dolichocephalics males (p < 0.05). For females, there was no influence of facial type (p > 0.05), except for the nasal convexity angle. Nose dimensions differed in specific points among different skeletal classes and facial types, and there was sexual dimorphism in all linear nose dimensions. This information may be applicable for nose reconstructions, allowing more reliable FR.
Asunto(s)
Tomografía Computarizada de Haz Cónico Espiral , Brasil , Tomografía Computarizada de Haz Cónico , Cara/diagnóstico por imagen , Femenino , Humanos , Imagenología Tridimensional , Masculino , Nariz/diagnóstico por imagenRESUMEN
The aim in this study was to evaluate the influence of skeletal class, facial type, and sex on soft tissue thickness (STT) of the craniofacial midline in a Brazilian subpopulation. Thus, 121 cone beam computed tomography (CBCT) scans (54 males and 67 females, age 21 to 40 yrs) composed the study sample. Patients were classified according to skeletal class (class I, II, and III) and facial type (brachycephalic, mesocephalic, and dolichocephalic), and STT was measured (mm) in 10 landmarks in the craniofacial midline for each CBCT scan. Multivariate analysis of covariance evaluated facial STT with regard to multiple independent variables (sex, age - covariate, facial type, and skeletal class). TEM and rTEM assessed the intra-examiner agreement. STT was significantly greater in males than in females for all regions measured (p < 0.05), except for the pogonion-pogonion' landmark (p>0.05). In general, class III individuals had significantly thicker soft tissue in the maxilla - subspinale-subnasale', prosthion-labrale superius', and incision-stomion' regions, while class II subjects had thicker soft tissue in the infradentale-labrale inferius' mandibular landmark (p < 0.05). Regarding facial type, dolichocephalic individuals showed significantly thicker soft tissue in the supramentale-supramentale' mandibular landmark, whereas brachycephalic subjects had thicker soft tissue in maxillary regions - prosthion-labrale superius' and incision-stomion' (p < 0.05). rTEM values were below 5% for most landmarks, and all TEM values were below 1 mm. Skeletal class and facial type influence STT, showing a soft tissue compensation, with deeper soft tissue in areas with lower skeletal development, and/or where bone is positioned more posteriorly.