RESUMEN

Farmers focus on reducing the cost of production and aim to increase profit. The objective of this study was to quantify the reduction of pesticides applied to soybean (Glycine max (L.) Merrill) and maize (Zea mays L.) crops in several stages of the production cycle using a site-specific spraying application based on real-time sensors in the Brazilian Cerrado region. The sprayers were equipped with a precision spraying control system based on a real-time sensor. The spraying operations were performed not only for herbicide, but also for fungicide and insecticides applications. The maps recorded the percentage of the spray boom when the application was turned on (on/off spray system) with nozzle-to-nozzle control. The precision spraying system based on real-time sensors reduced the volume of pesticides (including herbicides, insecticides, and fungicides) applied to soybean and maize crops. There was a more significant reduction in the volume of pesticides applied post-emergence of the crops in the initial stages of soybean and maize when the crops had less leaf area or less foliage coverage between the rows. The cost reduction achieved using this technology was 2.3 times lower than the cost associated with pesticide application over the entire area using a conventional sprayer. Under the experimental conditions, there were no differences in the average crop yield, compared to the historical productivity of soybean and maize crops by applying this technology because the recommended doses were not affected and the site of application was limited to points where the presence of plants was present was detected.

Asunto(s)

Fungicidas Industriales , Herbicidas , Plaguicidas , Productos Agrícolas , Plaguicidas/análisis , Zea mays

RESUMEN

Sowing density is one of the most influential factors affecting corn yield. Here, we tested the hypothesis that, according to soil attributes, maximum corn productivity can be attained by varying the seed population. Specifically, our objectives were to identify the soil attributes that affect grain yield, in order to generate a model to define the optimum sowing rate as a function of the attributes identified, and determine which vegetative growth indices can be used to predict yield most accurately. The experiment was conducted in Chapadão do Céu-GO in 2018 and 2019 at two different locations. Corn was sown as the second crop after the soybean harvest. The hybrids used were AG 8700 PRO3 and FS 401 PW, which have similar characteristics and an average 135-day cropping cycle. Tested sowing rates were 50, 55, 60, and 65 thousand seeds ha-1. Soil attributes evaluated included pH, calcium, magnesium, phosphorus, potassium, organic matter, clay content, cation exchange capacity, and base saturation. Additionally, we measured the correlation between the different vegetative growth indices and yield. Linear correlations were obtained through Pearson's correlation network, followed by path analysis for the selection of cause and effect variables, which formed the decision trees to estimate yield and seeding density. Magnesium and apparent electrical conductivity (ECa) were the most important soil attributes for determining sowing density. Thus, the plant population should be 56,000 plants ha-1 to attain maximum yield at ECa values > 7.44 mS m-1. In addition, the plant population should be 64,800 plants ha-1 at values < 7.44 mS m-1 when magnesium levels are greater than 0.13 g kg-1, and 57,210 plants ha-1 when magnesium content is lower. Trial validation showed that the decision tree effectively predicted optimum plant population under the local experimental conditions, where yield did not significantly differ among populations.