RESUMEN
The large open circuit voltage (VOC) loss and phase segregation are two main obstacles hindering the development of wide-bandgap perovskite solar cells (PSCs). Even though substantial progress has been made through crystallization regulation and surface modification on perovskite, the mechanism of VOC loss and phase segregation has rarely been studied. In this paper, we first investigate the halide ions distribution along the out-of-plane direction and find the initial inhomogeneous distribution of halide ions during the crystallization process is an important reason. It leads to the formation of an unfavorable potential well in PSCs, resulting in VOC loss as well as generation of strong strain exacerbating phase segregation. Through introducing melatonin (MT) into perovskite precursors, a homogeneous distribution of halide anions is realized due to the well-regulated crystallization. Consequently, the treated PSCs exhibit an optimized power conversion efficiency (PCE) of 22.88% with a VOC loss as low as 0.38 V, which are the best values for wide-bandgap PSCs up to now.
RESUMEN
Photovoltaics are being transformed by perovskite solar cells. The power conversion efficiency of these solar cells has increased significantly, and even higher efficiencies are possible. The scientific community has gained much attention due to perovskites' potential. Herein, the electron-only devices were prepared by spin-coating and introducing the organic molecule dibenzo-18-crown-6 (DC) to CsPbI2Br perovskite precursor solution. The current-voltage (I-V) and J-V curves were measured. The morphologies and elemental composition information of the samples were obtained by SEM, XRD, XPS, Raman, and photoluminescence (PL) spectroscopies. The distinct impact of organic DC molecules on the phase, morphology, and optical properties of perovskite films are examined and interpreted with experimental results. The efficiency of the photovoltaic device in the control group is 9.76%, and the device efficiency gradually increases with the increase of DC concentration. When the concentration is 0.3%, the device efficiency is the best, reaching 11.57%, short-circuit current is 14.01 mA/cm2, the open circuit voltage is 1.19 V, and the fill factor is 0.7. The presence of DC molecules effectively controlled the perovskite crystallization process by inhibiting the in-situ generations of impurity phases and minimizing the defect density of the film.