RESUMEN
Two-dimensional (2D) perovskite solar cells (PSCs) have attracted rapid growing attention due to their excellent environmental and operational stability. As an important type of 2D perovskite, Dion-Jacobson (DJ) 2D perovskites exhibit better structural integrity and more stable optoelectronic properties than those of Ruddlesden-Popper (RP) ones because of the elimination of weak van der Waals interactions. Random phase distribution, phase impurity, and weak crystallinity, however, can lead to severe nonradiative recombination losses in 2D perovskites and inferior device stability. Herein, formamidinium chloride (FACl) and lead chloride (PbCl2) are selected as additives to fabricate efficient and stable DJ 2D PSCs. The synergistic effect of additives could efficiently induce crystallization and suppress the low-n phase perovskites. The obtained 2D perovskites exhibit extended charge lifetime and enhanced charge transfer. The corresponding PSC device delivers an efficiency of 16.63% with a significantly improved open-circuit voltage (VOC) of 1.18 V and a fill factor (FF) of 81.65% than the control one. This PCE ranks the highest for inverted FA-based 2D DJ PSCs. Moreover, this device has exhibited exceptional long-term stability, which retains more than 95% of the initial efficiencies at about 50% relative humidity for 600 h.
RESUMEN
Surface electromyography (sEMG) is an important measurement for monitoring exercise and fitness. Because if its high sampling frequency requirement, wireless transmission of sEMG data is a challenge. In this article a wireless sEMG measurement system with a sampling frequency of 2 KHz is developed based upon a MSP 430 microcontroller and Bluetooth transmission. Standard isotonic and isometric muscle contraction are clearly represented in the receiving user interface. Muscle fatigue detection is an important application of sEMG. Traditional muscle fatigue is detected from the median frequency of the sEMG power spectrum. The regression slope of the linear regression of median frequency is an important muscle fatigue index. A more negative slope value represents a higher muscle fatigue condition. To test the system performance, muscle fatigue detection was examined by having subjects run on a pedaled-multifunctional elliptical trainer for approximately 30 minutes at three loading levels. Ten subjects underwent a total of 60 exercise sessions to provide the experimental data. Results showed that the regression slope gradually decreases as expected, and there is a significant gender difference.