RESUMEN
The capacity to predict in vivo responses to medical devices in humans currently relies greatly on implantation in animal models. Researchers have been striving to develop in vitro techniques that can overcome the limitations associated with in vivo approaches. This review focuses on a critical analysis of the major in vitro strategies being utilized in laboratories around the world to improve understanding of the biological performance of intracortical, brain-implanted microdevices. Of particular interest to the current review are in vitro models for studying cell responses to penetrating intracortical devices and their materials, such as electrode arrays used for brain computer interface (BCI) and deep brain stimulation electrode probes implanted through the cortex. A background on the neural interface challenge is presented, followed by discussion of relevant in vitro culture strategies and their advantages and disadvantages. Future development of 2D culture models that exhibit developmental changes capable of mimicking normal, postnatal development will form the basis for more complex accurate predictive models in the future. Although not within the scope of this review, innovations in 3D scaffold technologies and microfluidic constructs will further improve the utility of in vitro approaches.
Asunto(s)
Interfaces Cerebro-Computador , Encéfalo/fisiología , Técnicas de Cultivo de Célula/métodos , Electrodos Implantados , Animales , Humanos , Cicatrización de HeridasRESUMEN
Personnel records of over 1000 welders and electricians but only 235 caulkers and 557 platers employed at a shipyard in NE England between 1940 and 1968 were obtained and the mortality followed up to December 1982. The observed number of deaths (13 from mesothelial tumours, nine among the electricians) were compared with the number to be expected in the Newcastle connurbation. Welders and caulkers were most exposed to welding fumes, electricians to asbestos. The study was limited by the lack of accurate job exposure details, and there was no record of smoking habits, but welders and caulkers showed a higher standardised mortality ratio for all causes, lung cancer, ischaemic heart disease, pneumonia, and accidents than platers and electricians.
Asunto(s)
Enfermedades Profesionales/mortalidad , Soldadura , Contaminantes Ocupacionales del Aire , Inglaterra , Humanos , Masculino , NavíosRESUMEN
Cohort studies in three American asbestos factories were undertaken to investigate the effect of fibre type and manufacturing process on lung cancer, mesothelioma, and asbestosis. Reports have been published on a chrysotile textile plant in South Carolina and a mainly textile plant in Pennsylvania, which also used amphiboles. In the third plant in Connecticut friction products and packings were made from chrysotile only. In a cohort of 3641 men employed for one month or more, 1938-58, 3513 (96.5%) were traced, 1267 (36%) had died, and death certificates were obtained for 1228 (96.9%). Individual exposures were estimated (in mcpf . years) from impinger measurements. Life table analyses using Connecticut mortality rates gave an SMR for all causes of 108.5 (USA 107.9). The SMR (all causes) for men who had worked for less than a year was 129.9 and for those who had worked for a year or more, 101.2. The equivalent SMRs for respiratory cancer were 167.4 and 136.7 respectively. Excluding men who had worked for less than a year, there was possible evidence of some increase in risk of lung cancer with increasing exposure, supported also by a "log-rank" (case-control) analysis, of the same order as that observed in chrysotile mining and milling. These findings may be compared with chrysotile textile manufacture where the risk of lung cancer was some 50-fold greater. It is suggested that the differences in risk are perhaps related to the higher proportion of submicroscopic fibres in textile manufacture that may result from the traumatic carding , spinning, and weaving processes. No case of mesothelioma was found, consistent with a much lower risk of this tumour with chrysotile than with amphiboles. Twelve deaths (nine in men with very short and low asbestos exposure) were given ICD code 523 (pneumoconiosis); all but two were ascribed to anthracosilicosis or silicosis and none to asbestosis.
Asunto(s)
Amianto/efectos adversos , Enfermedades Profesionales/mortalidad , Adulto , Anciano , Asbestos Anfíboles , Asbestos Serpentinas , Asbestosis/mortalidad , Connecticut , Exposición a Riesgos Ambientales , Humanos , Neoplasias Pulmonares/etiología , Neoplasias Pulmonares/mortalidad , Masculino , Mesotelioma/etiología , Mesotelioma/mortalidad , Persona de Mediana Edad , Pennsylvania , Neumoconiosis/mortalidad , Dióxido de Silicio/efectos adversos , South Carolina , Industria TextilRESUMEN
Three parallel cohort studies of asbestos factory workers were undertaken to investigate the effects of mineral fibre type and industrial process on malignant mesothelioma, respiratory cancer, and asbestosis. This report describes the mortality of a cohort of 2543 men, defined as all those employed for at least a month from 1938 to 1958 in a textile plant in South Carolina in which chrysotile was the only type of asbestos used. Of these, 863 men (34%) had died before 31 December 1977, one from malignant mesothelioma. Twenty one deaths were ascribed to asbestosis and 66 to cancer of the lung. Compared with the number expected from South Carolina, there was an excess of 30 deaths from respiratory cancer (ICD 160-164) in men 20 or more years after first employment (SMR 199.5). In men employed five years or more, no SMRs for this category rose above 300. Individual exposures were estimated (in mpcf X years) from recorded environmental measurements. Life table analyses and "log-rank" (case-control) analyses both showed a steep linear exposure-response that was some 50-fold greater at similar accumulated dust exposures than in Canadian chrysotile mining and milling. These findings agree closely with those from another study in this plant and confirm that mesothelioma is rarely associated with chrysotile exposure. Cigarette smoking habits did not greatly differ between the textile workers and the Canadian miners and millers. The far greater risk of lung cancer in the textile industry, if not attributable to other identified cocarcinogens, may be related to major differences in the size distribution of fibres in the submicroscopic range which are not detected by the usual fibre or particle counting procedures.
Asunto(s)
Amianto/efectos adversos , Enfermedades Profesionales/mortalidad , Industria Textil , Adulto , Anciano , Asbestos Serpentinas , Asbestosis/etiología , Asbestosis/mortalidad , Polvo/efectos adversos , Humanos , Neoplasias Pulmonares/etiología , Neoplasias Pulmonares/mortalidad , Masculino , Mesotelioma/etiología , Mesotelioma/mortalidad , Persona de Mediana Edad , Enfermedades Profesionales/etiología , Factores de TiempoRESUMEN
This report describes the second in a series of three parallel cohort studies of asbestos factories in South Carolina, Pennsylvania, and Connecticut to assess the effects of mineral fibre type and industrial process on mortality from malignant mesothelioma, respiratory cancer, and asbestosis. In the present plant (in Pennsylvania) mainly chrysotile, with some amosite and a small amount of crocidolite, were used primarily in textile manufacture. Of a cohort of 4137 men comprising all those employed 1938-59 for at least a month, 97% were traced. By the end of 1974, 1400 (35%) had died, 74 from asbestosis and 70 from lung cancer. Mesothelioma was mentioned on the certificate in 14 deaths mostly coded to other causes. All these deaths occurred after 1959, and there were indications that additional cases of mesothelioma may have gone unrecognised, especially before that date. The exposure for each man was estimated in terms of duration and dust concentration in millions of dust particles per cubic foot (mpcf) from available measurements. Analyses were made both by life table and case referent methods. The standardised mortality ratio for respiratory cancer for the whole cohort was 105.0, but the risk rose linearly from 66.9 for men with less than 10 mpcf.y to 416.1 for those with 80 mpcf.y or more. Lines fitted to relative risks derived from SMRs in this and the textile plant studied in South Carolina were almost identical in slope. This was confirmed by case referent analysis. These findings support the conclusion from the South Carolina study that the risk of lung cancer in textile processing is very much greater than in chrysotile production and probably than in the friction products industry. The much greater risk of mesothelioma from exposure to processes in which even quite small quantities of amphiboles were used was also confirmed.