RESUMEN
PURPOSE: Patient specific virtual surgical planning is a useful tool in craniofacial reconstruction. The aim of this paper is to quantify the surgical accuracy of polyetheretherketone (PEEK) cranial implant placement by comparing a computer tomography (CT)-based plan with the measured postoperative position. MATERIALS AND METHODS: This is a retrospective case series. All patients who presented for evaluation and management of cranial defects at the University Health Sciences Center at San Antonio from June 2018 to July 2021 were eligible for the study. For each patient, we assessed accuracy by comparing the planned PEEK implant position, defined by a 3-dimensional mesh, to the measured postoperative position at multiple mesh vertices. The primary outcome variable in our study is the root mean square error (RMSE) between the planned position and the actual position of the implant. RESULTS: Twelve patients (7 men, 5 women, mean age: 25.6, median age: 30.5, range 6-74) were identified who underwent cranioplasty procedures with custom-made PEEK implants to reconstruct cranial defects. The RMSE of the vertex positions ranged between 0.66 and 3.1 millimeters (mm). Eleven of the twelve patients had an RMSE less than 2 mm. The Spearman rank-order correlation between the average error and the length and area of the implant were 0.59 (P = .04, significant) and 0.42 (P = .17, nonsignificant), respectively. The Pearson correlation between age and RMSE was -0.18 (P = .57), and not significant. CONCLUSION: Patient specific implant planning can design and guide the implant placement with a typical accuracy within 2 mm. This level of accuracy suggests that we can place implants accurately enough to achieve good patient aesthetics. The quantitative analysis suggests that the key to accurate placement is understanding the number and spatial distribution of plates and fixation.
Asunto(s)
Implantes Dentales , Procedimientos de Cirugía Plástica , Masculino , Humanos , Femenino , Adulto , Estudios Retrospectivos , Resultado del Tratamiento , Complicaciones Posoperatorias , Estética Dental , Polietilenglicoles , Cetonas , Diseño Asistido por ComputadoraRESUMEN
Temporomandibular joint replacement (TJR) with an alloplastic (metal/ultra-high-molecular-weight polyethylene) device has proven to be a successful and predictable procedure. This paper describes a novel technique for performing TJR with an endaural incision alone. The technique we are describing uses only an endaural incision with supplemental trocar incision(s), to perform a TJR. There were 4 patients for a total of 8 temporomandibular joints that were selected. All 4 patients were assessed immediately following surgery, on postoperative days 1 and 7 and at 6 months following surgery. Maximal interincisal opening and subjective variables were assessed at each of the time points. Additionally, the total operative time was measured and compared to a previous age and diagnosis matched control group using the traditional 2 incisions TJR.There were 3 females and 1 male (ages 19-67) who underwent TJR with an endaural incision alone. There were 4 females (ages 19-68) who underwent traditional TJR surgery. None of the patients in either group had major complications and all patients were discharged on postoperative day 1. All patients in the endaural incision alone group had increased maximal interincisal opening and reported a quicker subjective decrease in pain and disability following surgery with less average time in the operating room. However, all patients in the endaural incision alone group had CN VII weakness that lasted longer than those in the traditional TJR group.The minimally invasive approach for TJR was successful in the present pilot study and could be used in specific situations to decrease the morbidity associated with additional incisions for this procedure. Ultimately, the endaural only incision approach offers promising outcomes for future patients undergoing temporomandibular joints TJR in the right patient population.