RESUMEN

BACKGROUND: Monoblock ceramic cups are designed to accommodate large-diameter femoral heads. This has the potential to offer the advantages of an increased range of motion and enhanced joint stability. These features could benefit younger and high-demand patients in need of total hip arthroplasty. The aim of this study was to assess the survival rate and the reasons for revision of the DeltaMotion cup. METHODS: Data from the AOANJRR were analyzed for all patients who had undergone a primary conventional THA performed between January 1, 2001 and December 31, 2021. Only prostheses with ceramic/ceramic, ceramic/XLPE, metal/XLPE, or CM/XLPE bearing surfaces were included. The primary outcome measure was the cumulative percent revision for all causes. Secondary outcome measures were revision for dislocation/instability, ceramic breakage, or noise. A subanalysis for cup size was also performed. RESULTS: There were 486,946 primary conventional THA procedures undertaken for any reason. Of these, 4,033 used the DeltaMotion cup and 482,913 were modular designs. The DeltaMotion cup had the lowest CPR for all diagnoses compared to the modular bearings at all time points, had a significantly lower revision rate for prosthesis dislocation and no revisions for squeaking compared to other modular bearings. There were 175 ceramic breakages recorded in the modular bearing group and 1 ceramic breakage in the DeltaMotion group. CONCLUSIONS: The DeltaMotion cup had a low rate of all-cause revision, and for dislocation, ceramic breakage, and noise. Although this cup is no longer manufactured, ongoing follow-up of newer monoblock ceramic cups will determine their suitability for younger and more active patients.

Asunto(s)

RESUMEN

Background: All-suture anchors (ASAs) are noted to cause various bone reactions when used in upper limb surgery but clinical implications are unknown. Methods: 88 shoulders and 151 elbows with a mean follow-up of 47.1 ± 17.7 months were invited for follow-up including clinical examination, questionnaires and radiographs. The anchor drill holes were radiographically assessed. Results: At final follow up, mean DASH was 12.9 ± 13.8 and mean VAS 2.2 ± 2.4 in the shoulder population. In the elbow group mean MEPS was 91.8 ± 12.7 and mean VAS 1.5 ± 1.9. Implant-specific complications were seen in 10 elbow cases but none in the shoulder group. The mean diameter of the 1.4 mm all-suture anchor drill hole was enlarged to 2.5 ± 1.4 mm in the shoulder group and to 2.9 ± 1.0 mm in the elbow group. 50% of the 1.4 mm anchor drill holes showed abnormal morphology but these morphologic changes did not correlate with clinical outcome, complications or reoperation rate. Discussion: Satisfying clinical outcomes are found in upper limb surgery using ASAs. Various bone changes are seen after implantation of an ASA, but these are not clinically relevant. Long-term consecutive follow-up data is required.

RESUMEN

Primary bone and soft tissue tumours are rare in a non-referral teaching department. The incidence varies greatly among the different subtypes and every Orthopaedic surgeon will encounter one or more benign or malignant lesions during their careers. History, clinical examination and technical investigations are of great importance, but basic knowledge and basic principles are necessary for a correct clinical practice. It was the purpose of this study to raise awareness towards such pathology by exemplifying our cases from a two-year period in our community-based hospital and if necessary, to refer patients to specialised sarcoma centres.

Asunto(s)