RESUMEN
The spin-Seebeck effect (SSE) is an advective transport process traditionally studied in bilayers composed of a ferromagnet (FM) and a non-magnetic metal (NM) with strong spin-orbit coupling. In a temperature gradient, the flux of magnons in the FM transfers spin-angular momentum to electrons in the NM, which by the inverse spin-Hall effect generates an SSE voltage. In contrast, the Nernst effect is a bulk transport phenomenon in homogeneous NMs or FMs. These effects share the same geometry, and we show here that they can be added to each other in a new combination of FM/NM composites where synthesis via in-field annealing results in the FM material (MnBi) forming aligned needles inside an NM matrix with strong spin-orbit coupling (SOC) (Bi). Through examination of the materials' microstructural, magnetic, and transport properties, we searched for signs of enhanced transverse thermopower facilitated by an SSE contribution from MnBi adding to the Nernst effect in Bi. Our results indicate that these two signals are additive in samples with lower MnBi concentrations, suggesting a new way forward in the study of SSE composite materials.
RESUMEN
Transverse thermoelectric devices produce electric fields perpendicular to an incident heat flux. Classically, this process is driven by the Nernst effect in bulk solids, wherein a magnetic field generates a Lorentz force on thermally excited electrons. The spin Seebeck effect also produces magnetization-dependent transverse electric fields. It is traditionally observed in thin metallic films deposited on electrically insulating ferromagnets, but the films' high resistance limits thermoelectric conversion efficiency. Combining Nernst and spin Seebeck effect in bulk materials would enable devices with simultaneously large transverse thermopower and low electrical resistance. Here we demonstrate experimentally that this is possible in composites of conducting ferromagnets (Ni or MnBi) containing metallic nanoparticles with strong spin-orbit interactions (Pt or Au). These materials display positive shifts in transverse thermopower attributable to inverse spin Hall electric fields in the nanoparticles. This more than doubles the power output of the Ni-Pt materials, establishing proof of principle that the spin Seebeck effect persists in bulk nanocomposites.
RESUMEN
Mesoporous carbons were synthesized via both soft and hard template methods and compared to a commercial powder activated carbon (PAC) for the adsorption ability of bisphenol-A (BPA) from an aqueous solution. The commercial PAC had a BET-surface of 1027 m²/g with fine pores of 3 nm and less. The hard templated carbon (CMK-3) material had an even higher BET-surface of 1420 m²/g with an average pore size of 4 nm. The soft templated carbon (SMC) reached a BET-surface of 476 m²/g and a pore size of 7 nm. The maximum observed adsorption capacity (qmax) of CMK-3 was the highest with 474 mg/g, compared to 290 mg/g for PAC and 154 mg/g for SMC. The difference in adsorption capacities was attributed to the specific surface area and hydrophobicity of the adsorbent. The microporous PAC showed the slowest adsorption, while the ordered mesopores of SMC and CMK-3 enhanced the BPA diffusion into the adsorbent. This difference in adsorption kinetics is caused by the increase in pore diameter. However, CMK-3 with an open geometry consisting of interlinked nanorods allows for even faster intraparticle diffusion.