RESUMEN
Layered double hydroxides (LDHs) act as catalysts in several reactions like in the cyanoethylation of alcohols with acrylonitrile to produce alkoxypropionitriles. Here we report an experimental and theoretical study in which it is shown that the experimental catalytic activity of LDHs in the cyanoethylation of 2-propanol and methanol correlates with the predicted strength of the basicity of the adsorbed surface species. First, it is shown that using activated LDHs containing Mg2+ and Al3+ (MgAl-LDH), Mg2+ and Ga3+ (MgGa-LDH), and Mg2+, Al3+ and Ga3+ (MgAlGa-LDH) great conversions to alkoxypropionitriles in high yields are obtained. Next, the basicity of these LDHs is estimated by means of the local softness, a local reactivity index calculated using density functional theory and appropriate surface models. For that, the adsorption of hydroxide and methoxide anions at the (001) surface of MgAl and MgGa-LDHs is investigated. We include LDHs containing Zn2+ and Al3+ (ZnAl-LDH) and Zn2+ and Ga3+ (ZnGa-LDH) in this part of the study to account for the effect of changing the divalent and trivalent metal composition on the basicity. It is found that hydroxide anions adsorbed on the MgGa-LDH surface and methoxide anions adsorbed on the MgAl-LDH surface are the most basic ones. This basicity trend correlates with our experimental findings about the catalytic activity of the activated LDHs. Further analyzing the connection between the LDH composition and the anion basicity, it is argued that the key steps dictating the LDH catalytic activity are the alcohol deprotonation in the cyanoethylation of 2-propanol, as it has been previously suggested, and the methoxide anion attack to the acrylonitrile double bond in the methanol cyanoethylation reaction.
RESUMEN
Adding a small quantity of K or Bi to a MoVTeNbO x via impregnation with inorganic solutions modifies its surface acid and redox properties and its catalytic performance in propa(e)ne partial oxidation to acrylic acid (AA) without detriment to its pristine crystalline structure. Bi-doping encourages propane oxydehydrogenation to propene, thus enlarging the net production rate of AA up to 35% more. The easier propane activation/higher AA production over the Bi-doped catalyst is ascribed to its higher content of surface V leading to a larger amount of total V5+ species, the isolation site effect of NbO x species on V, and its higher Lewis acidity. K-doping does not affect propane oxydehydrogenation to propene but mainly acts over propene once formed, also increasing AA to a similar extent as Bi-doping. Although K-doping lowers propene conversion, it is converted more selectively to acrylic acid owing to its reduced Brønsted acidity and the presence of more Mo6+ species, thereby favoring propene transformation via the π-allylic species route producing acrylic acid over that forming acetic acid and CO x via acetone oxidation and that yielding directly CO x .
RESUMEN
The role of iron in two modes of integration into alumina catalysts was studied at 0.39 wt% Fe and tested in trichloroethylene combustion. One modified alumina was synthesized using the sol-gel method with Fe added in situ during hydrolysis; another modification was performed using calcined alumina, prepared using the sol-gel method and impregnated with Fe. Several characterization techniques were used to study the level of Fe modification in the γ-Al2O3 phase formed and to correlate the catalytic properties during trichloroethylene (TCE) combustion. The introduction of Fe in situ during the sol-gel process influenced the crystallite size, and three iron species were generated, namely, magnetite, maghemite and hematite. The impregnated Fe-alumina formed hematite and maghemite, which were highly dispersed on the γ-Al2O3 surface. The X-ray photoelectron spectra (XPS), FT-IR and Mössbauer spectroscopy analyses revealed how Fe interacted with the γ-Al2O3 lattice in both catalysts. The impregnated Fe-catalyst showed the best catalytic performance compared to the catalyst that was Fe-doped in situ by the sol-gel method; both had better catalytic activity than pure alumina. This difference in activity was correlated with the accessibility of the reactants to the hematite iron species on the surface. The chlorine poisoning for all three catalysts was less than 1.8%.
RESUMEN
The carbonation process of a calcined Mg-Al layered double hydroxide (LDH) was systematically analyzed at low temperatures, varying the relative humidity. Qualitative and quantitative experiments were performed. In a first set of experiments, the relative humidity was varied while maintaining a constant temperature. Characterization of the rehydrated products by thermogravimetric analysis (TGA), Fourier transform infrared spectroscopy (FTIR) and solid-state NMR revealed that the samples did not recover the LDH structure; instead hydrated MgCO(3) was produced. The results were compared with similar experiments performed on magnesium oxide for comparison purposes. Then, in the second set of experiments, a kinetic analysis was performed. The results showed that the highest CO(2) capture was obtained at 50 °C and 70% of relative humidity, with a CO(2) absorption capacity of 2.13 mmol/g.
RESUMEN
The rehydration process of a calcined MgAl-layered double hydroxide (LDH) with a Mg/Al molar ratio of 3 was systematically analyzed at different temperatures and relative humidity. Qualitative and quantitative experiments were done. In the first set of samples, the temperature or the relative humidity was varied, fixing the second variable. Both adsorption and absorption phenomena were present; absorption process was associated to the LDH regeneration. Of course, in all cases the LDH regeneration was confirmed by other techniques such as TGA, solid state NMR, and SAXS. In the second set of experiments, a kinetic analysis was performed, the results allowed to obtain different activation enthalpies for the LDH regeneration as a function of the relative humidity. The activation enthalpies varied from 137.6 to 83.3 kJ/mol as a function of the relative humidity (50 and 80%, respectively). All these experiments showed that LDH regeneration is highly dependent on the temperature and relative humidity.
RESUMEN
Well crystallized silicalite-1 has been obtained from three sources of amorphous silica, namely, rice hull ashes, commercial Davisil, and a fume silica from Aldrich. The silicas were first dissolved in glycerol according to a recently described reaction. This reaction transforms rapidly and efficiently large surface area silicates into poly-alkoxide gels. It can be schematized as an etherification of an alcohol function of glycerol by the weakly acid surface silanol groups. The facile hydrolysis of the alkoxide permits the preparation of relatively pure and reactive silica, keeping the mesoporous character of the parent starting material. We insist on the mesoporous character of the solids obtained upon hydrolyzing the organo-silicic gel because we believe the gel plays a role of template in the secondary synthesis of mesoporous structures. The hydrolysis is carried out in presence of a structure directing agent, namely tetra-propylammonium hydroxide, TPAOH. After aging, the residue is dried and calcined. The first advantage of using the organo-silicic gel is probably related to the high degree of depolymerization of silica, witness by the C/Si ratio. The second one, more subtle to define, is to provide an intermediate silica with hydrophilic a hydrophobic regions, interfering differently with the surfactant. After calcination at 500 degrees C, well crystallized silicalite-1 is obtained. The texture of the starting silica influences the textural characteristics of the final silicalite-1.
RESUMEN
Phosphated alumina gels were prepared by the sol-gel method. Gels were aged from 1 to 8 days in air. Gel structure evolution, as time went on, was followed by 27Al magic angle spinning nuclear magnetic resonance, X-ray diffraction, and small-angle X-ray scattering. It is concluded that the aging time is a crucial parameter in the formation of coordinately unsaturated sites of aluminum (AlIV and AlV). The gel network is shown to have a fractal structure.
RESUMEN
The synthesis of samples by the sol-gel method with aluminum tri-sec-butoxide as cation precursor, 2-propanol as solvent, and sulfuric acid as hydrolysis catalyst gave rise to nanocapsules with an average diameter of 20 nm and a shell thickness of 3.5 nm. The analysis of the X-ray diffraction patterns and the 27Al MAS NMR spectra showed that the shell of the nanocapsules was made up of Al13 tridecamers ordered in a noncrystalline symmetry. The interaction between the capsule's shells opened the capsule structure, producing curved fibers, but maintaining the atomic local order. This opening of the capsules favored the reordering of the atomic local order of Al13 tridecamers into the one of crystalline boehmite, when the sample was aged at room temperature for several days; it also increased the pore volume and the specific surface area of the sample. The crystallization transformed the curved fibers into rods made of small crystalline boehmite bars. The capsule morphology was preserved after calcining the nonaged sample at 700 degrees C, indicating that the transformation of the phase made up of ordered Al13 tridecamers into a noncrystalline alumina was pseudomorphic. We describe and partially explain one of the possible atomic ordering evolutions from the one of an isolated Al13 tridecamer, to the phase forming the nanocapsules shell, until eventually coming to the ordering corresponding to boehmite crystalline rods.