RESUMEN
Meiotic maturation is essential for the reproduction procedure of many animals. During this process an oocyte produces a large egg cell and tiny polar bodies by highly asymmetric division. In this study, to fully understand the sophisticated spatiotemporal regulation of accurate oocyte meiotic division, we focused on the global and local changes in the tension at the surface of the starfish (Asterina pectinifera) oocyte in relation to the surface actin remodeling. Before the onset of the bulge formation, the tension at the animal pole globally decreased, and started to increase after the onset of the bulge formation. Locally, at the onset of the bulge formation, tension at the top of the animal pole began to decrease, whereas that at the base of the bulge remarkably increased. As the bulge grew, the tension at the base of the bulge additionally increased. Such a change in the tension at the surface was similar to the changing pattern of actin distribution. Therefore, meiotic cell division was initiated by the bulging of the cortex, which had been weakened by actin reduction, and was followed by contraction at the base of the bulge, which had been reinforced by actin accumulation. The force generation system is assumed to allow the meiotic apparatus to move just under the membrane in the small polar body. Furthermore, a detailed comparison of the tension at the surface and the cortical actin distribution indicated another sophisticated feature, namely that the contraction at the base of the bulge was more vigorous than was presumed based on the actin distribution. These features of the force generation system will ensure the precise chromosome segregation necessary to produce a normal ovum with high accuracy in the meiotic maturation.
Asunto(s)
División Celular/fisiología , Animales , Modelos Teóricos , Oocitos/citología , Análisis Espacio-Temporal , Estrellas de Mar/citologíaRESUMEN
The dermis of the sea cucumber body wall is a typical catch connective tissue that rapidly changes its mechanical properties in response to various stimuli. Dynamic mechanical properties were measured in stiff, standard, and soft states of the sea cucumber Actinopyga mauritiana. Sinusoidal deformations were applied, either at a constant frequency of 0.1 Hz with varying maximum strain of 2%-20% or at a fixed maximum strain of 1.8% with varying frequency of 0.0005-50 Hz. The dermis showed viscoelasticity with both strain and strain-rate dependence. The dermis in the standard state showed a J-shaped stress-strain curve with a stiffness of 1 MPa and a dissipation ratio of 60%; the curve of the stiff dermis was linear with high stiffness (3 MPa) and a low dissipation ratio (30%). Soft dermis showed a J-shaped curve with low stiffness (0.3 MPa) and a high dissipation ratio (80%). The strain-induced softening was observed in the soft state. Stiff samples had a higher storage modulus and a lower tangent delta than soft ones, implying a larger contribution of the elastic component in the stiff state. A simple molecular model was proposed that accounted for the mechanical behavior of the dermis. The model suggested that stiffening stimulation increased inter-molecular bonds, whereas softening stimulation affected intra-molecular bonds. The adaptive significance of each mechanical state in the behavior of sea cucumbers is discussed.