RESUMEN
The removal of boron by Donnan dialysis from aqueous solutions has been studied according to response surface methodology (RSM). First, a preliminary study was performed with two membranes (AFN and ACS) in order to determine the experimental field based on different parameters, such as the pH of the feed compartment, the concentration of counter-ions in the receiver compartment, and the concentration of boron in the feed compartment. The best removal rate of boron was 75% with the AFN membrane, but only 48% with the ACS membrane. Then, a full-factor design was developed to determine the influence of these parameters and their interactions on the removal of boron by Donnan dialysis. The pH of the feed compartment was found to be the most important parameter. The RSM was applied according to the Doehlert model to determine the optimum conditions ([B] = 66 mg/L, pH = 11.6 and [Cl-] = 0.5 mol/L) leading to 88.8% of boron removal with an AFN membrane. The use of the RSM can be considered a good solution to determine the optimum condition for 13.8% compared to the traditional "one-at-a-time" method.
RESUMEN
In this study the removal of phosphates from solution by Donnan dialysis and by adsorption onto calcium alginate beads were studied separately and then together. This hybrid process was conducted in order to benefit from each process, and it is an original and new combination. First, the Donnan dialysis process was performed with different parameters: the type of counter-ion, the concentration of the counter-ion, the initial phosphate concentration, the pH of the solution and the choice of anion-exchange membranes. Donnan dialysis achieved 68% and 12.5% phosphorus removal with AMX and AFN membranes respectively. Then a preliminary study into the adsorption of phosphate onto calcium alginate beads was carried out. A full factor design was applied in order to determine the effect of the main parameters and their mutual interactions for the adsorption process. The removal of phosphate onto calcium alginate beads reached 82.5%. Finally, coupling Donnan dialysis with adsorption onto calcium alginate beads for the removal of phosphate reached 89.5% with the AMX membrane. This hybrid process can be considered to be a solution for improving the contact time and for enhancing the removal of phosphate by 10% compared to adsorption onto calcium alginate.