RESUMEN

Husbandry trace gases that have climate change implications such as carbon dioxide (CO2), methane (CH4) and ammonia (NH3) can be quantified through remote sensing; however, many husbandry gases with health implications such as hydrogen sulfide (H2S), cannot. This pilot study demonstrates an approach to derive H2S concentrations by coupling in situ and remote sensing data. Using AMOG (AutoMObile trace Gas) Surveyor, a mobile air quality and meteorology laboratory, we measured in situ concentrations of CH4, CO2, NH3, H2S, and wind at a southern California university research dairy. Emissions were 0.13, 1.93, 0.022 and 0.0064 Gg yr-1; emission factors (EF) were 422, 6333, 74, and 21 kg cow-1 yr-1, respectively, for the 306 head herd. Contributing to these strong EF were spillway emissions from a grate between the main cowshed and the waste lagoon identified in airborne remote sensing data acquired by the hyperspectral thermal infrared imager, Mako. NH3 emissions from the Chino Dairy Complex, also in southern California, were calculated from Infrared Atmospheric Sounding Interferometer (IASI) satellite data for 2008-2017 using average morning winds, yielding a flushing time of 2.7 h, and 8.9 Gg yr-1. The ratio of EF(H2S) to EF(NH3) for the research dairy from AMOG data were applied to IASI NH3 emissions to derive H2S exposure concentration maps for the Chino area, which ranged to 10-30 ppb H2S for many populated areas. Combining remote sensing with in situ concentrations of multiple emitted gases can allow derivation of emissions at the sub-facility, facility, and larger scales, providing spatial and temporal coverage that can translate into exposure estimates for use in epidemiology studies and regulation development. Furthermore, with high fidelity information at the sub-facility level we can identify best practices and opportunities to sustainably and holistically reduce husbandry emissions.

RESUMEN

Mobile in situ concentration and meteorology data were collected for the Chino Dairy Complex in the Los Angeles Basin by AMOG (AutoMObile trace Gas) Surveyor on 25 June 2015 to characterize husbandry emissions in the near and far field in convoy mode with MISTIR (Mobile Infrared Sensor for Tactical Incident Response), a mobile upwards-looking, column remote sensing spectrometer. MISTIR reference flux validated AMOG plume inversions at different information levels including multiple gases, GoogleEarth imagery, and airborne trace gas remote sensing data. Long-term (9-yr.) Infrared Atmospheric Sounding Interferometer satellite data provided spatial and trace gas temporal context. For the Chino dairies, MISTIR-AMOG ammonia (NH3) agreement was within 5% (15.7 versus 14.9 Gg yr-1, respectively) using all information. Methane (CH4) emissions were 30 Gg yr-1 for a 45,200 herd size, indicating that Chino emission factors are greater than previously reported. Single dairy inversions were much less successful. AMOG-MISTIR agreement was 57% due to wind heterogeneity from downwind structures in these near-field measurements and emissions unsteadiness. AMOG CH4, NH3, and CO2 emissions were 91, 209, and 8200 Mg yr-1, implying 2480, 1870, and 1720 head using published emission factors. Plumes fingerprinting identified likely sources including manure storage, cowsheds, and a structure with likely natural gas combustion. NH3 downwind of Chino showed a seasonal variation of a factor of ten, three times larger than literature suggests. Chino husbandry practices and trends in herd size and production were reviewed and unlikely to add seasonality. Higher emission seasonality was proposed as legacy soil emissions, the results of a century of husbandry, supported by airborne remote sensing data showing widespread emissions from neighborhoods that were dairies 15 years prior, and AMOG and MISTIR observations. Seasonal variations provide insights into the implications of global climate change and must be considered when comparing surveys from different seasons.

Asunto(s)

RESUMEN

Methane (CH4) and ammonia (NH3) directly and indirectly affect the atmospheric radiative balance with the latter leading to aerosol generation. Both have important spectral features in the Thermal InfraRed (TIR) that can be studied by remote sensing, with NH3 allowing discrimination of husbandry from other CH4 sources. Airborne hyperspectral imagery was collected for the Chino Dairy Complex in the Los Angeles Basin as well as in situ CH4, carbon dioxide (CO2) and NH3 data. TIR data showed good spatial agreement with in situ measurements and showed significant emissions heterogeneity between dairies. Airborne remote sensing mapped plume transport for ∼20 km downwind, documenting topographic effects on plume advection. Repeated multiple gas in situ measurements showed that emissions were persistent on half-year timescales. Inversion of one dairy plume found annual emissions of 4.1 × 105 kg CH4, 2.2 × 105 kg NH3, and 2.3 × 107 kg CO2, suggesting 2300, 4000, and 2100 head of cattle, respectively, and Chino Dairy Complex emissions of 42 Gg CH4 and 8.4 Gg NH3 implying ∼200k cows, ∼30% more than Peischl et al. (2013) estimated for June 2010. Far-field data showed chemical conversion and/or deposition of Chino NH3 occurs within the confines of the Los Angeles Basin on a four to six h timescale, faster than most published rates, and likely from higher Los Angeles oxidant loads. Satellite observations from 2011 to 2014 confirmed that observed in situ transport patterns were representative and suggests much of the Chino Dairy Complex emissions are driven towards eastern Orange County, with a lesser amount transported to Palm Springs, CA. Given interest in mitigating husbandry health impacts from air pollution emissions, this study highlights how satellite observations can be leveraged to understand exposure and how multiple gas in situ emissions studies can inform on best practices given that emissions reduction of one gas could increase those of others.

Asunto(s)

RESUMEN

The typically weak cross-sections characteristic of Raman processes has historically limited their use in atmospheric remote sensing to nighttime application. However, with advances in instrumentation and techniques, it is now possible to apply Raman lidar to the monitoring of atmospheric water vapor, aerosols and clouds throughout the diurnal cycle. Upper tropospheric and lower stratospheric measurements of water vapor using Raman lidar are also possible but are limited to nighttime and require long integration times. However, boundary layer studies of water vapor variability can now be performed with high temporal and spatial resolution. This paper will review the current state-of-the-art of Raman lidar for high-resolution measurements of the atmospheric water vapor, aerosol and cloud fields. In particular, we describe the use of Raman lidar for mapping the vertical distribution and variability of atmospheric water vapor, aerosols and clouds throughout the evolution of dynamic meteorological events. The ability of Raman lidar to detect and characterize water in the region of the tropopause and the importance of high-altitude water vapor for climate-related studies and meteorological satellite performance are discussed.

Asunto(s)

RESUMEN

We discuss the spectroscopic requirements for a laser absorption spectrometer (LAS) approach to high-precision carbon dioxide (CO2) measurements in the troposphere. Global-scale, high-precision CO2 measurements are highly desirable in an effort to improve understanding and quantification of the CO2 sources and sinks and their impact on global climate. We present differential absorption sounding characteristics for selected LAS transmitter laser wavelengths, emphasizing the effects of atmospheric temperature profile uncertainties. Candidate wavelengths for lower-troposphere measurements are identified in the CO2 bands centered near 1.57, 1.60, and 2.06 microm.

RESUMEN

Concurrent measurements of sea-surface retroreflectance and associated wind velocity acquired with an airborne CO2 Doppler lidar are described. These observations provide further insight into thermal infrared optical phenomenology of air-sea interface processes, contribute to a greater understanding of radiation transfer between the atmosphere and the hydrosphere, and enable improved models of wind-driven ocean-surface stress applicable to other remote sensing applications. In particular, we present lidar measurements of azimuthally anisotropic reflectance behavior and discuss the implications to current understanding of sea-surface optical properties.

RESUMEN

Radiometric calibration of an airborne CO2 pulsed Doppler lidar has been accomplished with surface retroreflection signals from the White Sands National Monument, New Mexico. Two circular passes were made at altitudes of 6.3 and 9.3 km. The computed calibration factors for both altitudes are in excellent agreement with the value derived from standard ground-based measurements involving a fixed sandpaper target of known reflectance. This finding corroborates a previous study that successfully calibrated an airborne cw Doppler lidar with a variety of natural Earth surfaces. The present results indicate that relatively uniform Earth surface targets can be used for in-flight calibration of CO2 pulsed airborne and, in principal, other infrared lidars.