RESUMEN

Amorolfine (AOF) is a compound with fungicide activity based on the dual inhibition of growth of the fungal cell membrane, the biosynthesis and accumulation of sterols, and the reduction of ergosterol. In this work a sensitive kinetic and spectrophotometric method for the AOF quantitation based on the AOF oxidation by means of KMnO4 at 30 min (fixed time), pH alkaline, and ionic strength controlled was developed. Measurements of changes in absorbance at 610 nm were used as criterion of the oxidation progress. In order to maximize the sensitivity, different experimental reaction parameters were carefully studied via factorial screening and optimized by multivariate method. The linearity, intraday, and interday assay precision and accuracy were determined. The absorbance-concentration plot corresponding to tap water spiked samples was rectilinear, over the range of 7.56 × 10-6-3.22 × 10-5 mol L-1, with detection and quantitation limits of 2.49 × 10-6 mol L-1 and 7.56 × 10-6 mol L-1, respectively. The proposed method was successfully validated for the application of the determination of the drug in the spiked tap water samples and the percentage recoveries were 94.0-105.0%. The method is simple and does not require expensive instruments or complicated extraction steps of the reaction product.

RESUMEN

A method was developed for the identification and quantification of oxytetracycline residues present in salmon muscle and skin using UV-Vis derivative spectrophotometry. With this method, it was possible to reduce the number of steps in the procedure typically required for instrumental analysis of a sample. The spectral variables, order of the derivative, scale factor, smoothing factor, and analytical wavelength were optimized using standard solutions of oxytetracycline dissolved in 900 mg/L oxalic acid in methanol. The matrix effect was significant; therefore, quantification for oxytetracycline residues was carried out using drug-free salmon muscle and skin samples fortified with oxytetracycline. The LOD and LOQ were found to be 271 and 903 µg/kg, respectively. The precision and accuracy of the method were validated using drug-free salmon muscle and skin tissues fortified at three different concentrations (8, 16, and 32 mg/kg) on 3 different days. The recoveries at all fortified concentrations were between 90 and 105%, and RSDs in all cases were less than 6.5%. This method can be used to screen out compliant samples and thereby reduce the number of suspect positive samples that will require further confirmatory analysis.

Asunto(s)

RESUMEN

This study demonstrates the first use of polydimethylsiloxane (PDMS) immobilized on a rotating disk for the extraction of copper from aqueous matrices and its subsequent direct determination by solid phase UV-Visible spectrophotometry. To accomplish the solid-phase extraction and the direct solvent-free spectrophotometric measurement, sodium diethyldithiocarbamate (NaDDTC) was used as an analytical reagent to form the uncharged chromophore complex Cu(DDTC)2, which absorbs at 432 nm. Different physicochemical conditions (pH, temperature, reagent concentration, chemical modifiers) and hydrodynamic factors (rotation velocity, extraction time, sample volume) were optimized. Under the optimized conditions, extraction equilibrium times of 30, 53 and 90 min were obtained for 100, 500 and 1000 mL of sample, respectively, with preconcentration factors of 286, 712 and 1284, respectively. The methodology was precise (repeatability and reproducibility of 7.2 and 8.4%, respectively, as relative standard deviation) and accurate (recovery of 96.7%) when analyzing a multielement certified reference standard. The latter study also confirmed the high selectivity of the extraction and determination of the copper chromophore over other metal ions. The obtained limits of detection and quantification reached values lower than 12 µg L(-1), which can be reduced further by increasing the sample volume. Accuracy was also assessed using both recovery tests on drinking water matrices (95.5% recovery) and comparison with results obtained by an independent method using inductively coupled plasma-optical emission spectroscopy (ICP-OES); no significant differences were observed.

RESUMEN

The simultaneous determination of albendazole (ABZ) and praziquantel (PZQ) was performed by different mathematical approaches: second derivative spectrophotometry (SDS), classical least squares, regression of partial least squares and principal components regression based on spectral data of drugs dissolved in methanol-hydrochloric acid solution. The detection limits for multivariate calibrations were determined by creating a surrogate variable signal. SDS presented the best analytical features. The recoveries of ABZ and PZQ from the synthetic samples were near to 100 +/- 5%. The methods were applied in veterinary pharmaceutical formulation whose mass ratio ABZ:PZQ is 10:1; the results obtained were according to nominal content.

Asunto(s)

RESUMEN

The present study shows the formation and characterization of the ionic-pair between the antibiotic oxytetracycline and the dye crystal violet in ammonia solution pH 9.0+/-0.2 extracted into chloroform. The characterization was demonstrated using UV-vis spectrophotometry, (1)H NMR, measurement of relaxation times T(1) and IR spectroscopy, using a comparison between the signals of individual pure compounds with the signals with the mixture CV-OTC in different alkaline media. The formation of ionic-pair was also corroborated by new signals and chemical shifts. (2D) NMR spectroscopy experiments show that the interaction is electrostatic.

Asunto(s)

RESUMEN

In this work, a characterization of reagent chromophore 5-(4-sulphophenylazo)-8-aminoquinoline [SPA] by IR and 1H RMN was carried out and a pK(a) value of 3.55+/-0.03 was found as well. An 1:2 stoichiometry for the Cu(II)-SPA complex was determined at pH 9 by Job and molar ratio methods. A value of 1.4 x 10(14) for the stability constant was also found. Based on the formation of this complex a new method for the copper determination in presence of gold and silver was developed by derivative spectrophotometry using a previous preconcentration on solid phase. In this method, the analytical measures were executed directly in the solid phase containing the complex. The Cu(II) reacts with the reagent chromophore SPA previously retained in the anionic exchange DEAE Sephadex A25. In this determination, the first derivative at 605 nm was used. The quantification range was between (3.2+/-0.3 x 10(-1)) x 10(-8) and (94.4+/-0.9) x 10(-8) mol L(-1) (3.2+/-0.3 x 10(-1)) x 10(-8), and (94.4+/-0.9) x 10(-8) mol L(-1). The repeatability expressed as RSD was between 1.1 and 2.0%. The method was applied successfully for the copper determination in mineral residuals and natural water samples. The results were consistent with those provided by ICP-mass spectrometry.

Asunto(s)

RESUMEN

A simple, rapid, and sensitive method has been developed for the simultaneous determination of trace amounts of copper and silver using 1-phenyl-1,2-propanedione-2-oximethiosemicarbazone (PPDOT) as a chromogenic reagent. The proposed method was based on retention and preconcentration of the complexes Cu(III)-PPDOT and Ag(I)-PPDOT on a solid phase in acid medium. The complexes were quantitatively retained in the cation exchanger SP Sephadex C25, and the analytical measurements were executed directly in the solid phase by derivative spectrophotometry. In this simultaneous determination, the second derivative and the zero crossing method were used. The determination of copper and silver was carried out to 321.0 and 427.0 nm, respectively. In order to obtain quantitative recoveries of the metal ions, various experimental analytical parameters, such as pH, stirring time, volume, and amount of solid phase, were optimized. The effect of interfering ions on the determination was described. The recovery values for Cu(II) and Ag(I) were found to be > 98%, and the relative standard deviation was < or = 2%. The detection limits (3sigma criterion) for Cu(II) and Ag(I) were found to be 0.9 x 10(-8) and 13 x 10(-8) M, respectively. The developed method was utilized for preconcentration and determination of Cu(II) and Ag(I) in industrial effluents and natural water samples. The results were consistent with those provided by inductively coupled plasma/mass spectrometry.

Asunto(s)

RESUMEN

Chemical, electrochemical and flow variables were optimized to examine the effectiveness of the electrocoagulation process for the removal of copper, lead and cadmium. The electrochemical process, which uses electrodes of commercial laminate steel, was applied to simulated wastewater containing 12 mg dm(-3) of copper, 4 mg dm(-3) of lead and 4 mg dm(-3) of cadmium. The optimum conditions for the process were identified as pH=7, flow rate=6.3 cm(3) min(-1) and a current density between 31 and 54 A m(-2). When the electrode geometric area and time of electrolysis reached critical values, the copper removal reached a maximum value of 80%. A linear relationship was identified between the current density and the mass of generated sludge. In addition, a linear relationship was found between specific energy consumption and current density. The results of this investigation provide important data for the development of an industrial-scale electrolytic reactor.

Asunto(s)

RESUMEN

A simple continuous flow method is proposed to eliminate copper interference in arsenic speciation by hydride generation, based on the selective retention of this interfering ion in an iminodiacetate chelating resin previous to the hydride generation process. The arsines generated were cold trapped and measured by ICP/OES. The proposed method allows about 98% of the copper present in the samples to be removed. Minor co-retention of As(V) was observed as a result of electrostatic interaction between the arsenate anion and the nitrogen of the iminodiacetate group of the chelating resin Muromac A-1, the charge distribution of which is modified when copper is chelated. The species As(III), MMA and DMA were not retained in the microcolumn, probably because these species are mainly in the molecular form at the working pH value (4.5). In synthetic samples containing 50 microg l(-1) of each arsenic species together with 100 mg l(-1) copper, the recoveries obtained were: As(V) 97.6%, As(III) 100%, MMA 99.8%, and DMA 99.9%. The method was applied to arsenic speciation in river water samples containing high levels of copper.

RESUMEN

A new method for the sequential determination of attapulgite and nifuroxazide in pharmaceutical formulations by first- and second-derivative spectrophotometry, respectively, has been developed. In order to obtain the optimal conditions for nifuroxazide stability, studies of solvent, light, and temperature effects were performed. The results show that a previous hydrolysis of 2 h in 1.0 x 10(-1)M NaOH solution is necessary in order to obtain stable compounds for analytical purposes. Subsequently, the first- and second-derivative spectra were evaluated directly in the same samples. The sequential determination of the drugs can be performed using the zero-crossing method; the attapulgite determination was carried out using the first derivative at 278.0 nm and the nifuroxazide determination, using the second derivative at 282.0 nm. The determination ranges were 5.7 x 10(-6)-1.0 x 10(-4) and 3.7 x 10(-8) -1.2 x 10(-4)M for attapulgite and nifuroxazide, respectively. Repeatability (relative standard deviation) values of 1.2 and 3.0% were observed for attapulgite and nifuroxazide, respectively. The ingredients commonly found in commercial pharmaceutical formulations do not interfere. The proposed method was applied to the determination of these drugs in tablets. Further, infrared spectroscopy and cyclic voltammetry studies were carried out in order to obtain knowledge of the decomposition products of nifuroxazide.

Asunto(s)

RESUMEN

A simple and fast method was developed for the simultaneous determination of dapsone and pyrimethamine by first-order digital derivative spectrophotometry. Acetonitrile was used as a solvent to extract the drugs from the pharmaceutical formulations, and the samples were subsequently evaluated directly by digital derivative spectrophotometry. The simultaneous determination of both drugs was performed by the zero-crossing method at 249.4 and 231.4 nm for dapsone and pyrimethamine, respectively. The best signal-to-noise ratio was obtained when the first derivative of the spectrum was used. The linear range of determination for the drugs was from 6.6 x 10(-7) to 2.0 x 10(-4) and from 2.5 x 10(-6) to 2.0 x 10(-4) mol/L for dapsone and pyrimethamine, respectively. The excipients of commercial pharmaceutical formulations did not interfere in the analysis. Chemical and spectral variables were optimized for determination of both analytes. A good level of repeatability, 0.6 and 1.7% for dapsone and pyrimethamine, respectively, was observed. The proposed method was applied for the simultaneous determination of both drugs in pharmaceutical formulations.

Asunto(s)

RESUMEN

This paper reports a simple and fast method for the simultaneous determination of estradiol (ED) and medroxyprogesterone acetate (MP) in pharmaceutical formulations by second-derivative spectrophotometry. Methanol was used to extract the drugs from formulations, and subsequently the extracts were evaluated directly by derivative spectrophotometry. The drugs were determined simultaneously by using the graphic method at 297.4 nm for ED and the zero-crossing method at 273.4 nm for MP. If both compounds are present together in a sample, it is possible to quantitate one in the presence of the other. The best signal-to-noise ratio was found when the second derivative of the spectrum was used. The linear ranges for determination of the drugs were 4.7 x 10(-6) to 1.6 x 10(-4) and 7.2 x 10(-6) to 2.0 x 10(-4) mol/L for ED and MP, respectively. The ingredients commonly found in commercial pharmaceutical formulations do not interfere with the determination. Chemical and spectral variables were optimized for the determination of both analytes. Good levels of repeatability (relative standard deviation), 1.4 and 1.9%, were obtained for ED and MP, respectively. The proposed method was applied to the determination of these drugs in pharmaceutical formulations.

Asunto(s)

RESUMEN

A first derivative spectrophotometric method has been developed for the determination of parathion and p-nitrophenol in vegetable tissues. Ethanol was used as solvent for extracting the compounds from the tissues and subsequently the samples were evaluated against a vegetable tissue blank, directly by derivative spectrophotometry. The simultaneous determination of these compounds can be carried out using the zero-crossing approach for parathion at 253.0 nm and for p-nitrophenol at 273.1 nm. In the samples each analyte was determined in the presence of one another in the ranges between 4.9 to 3883.5 microg g(-1) for parathion and 4.9 to 3285.3 microg g(-1) for p-nitrophenol. The detection limits (3a) were found to be 1.5 and 1.4 microg g(-1) for parathion and p-nitrophenol, respectively. The relative standard deviations were in all instances less than 1.8%. The proposed method was applied to the determination of the analytes in spiked leaves of corn. The results show a good recovery and they are in agreement with those obtained by polarography.

Asunto(s)