RESUMEN
Heavy ion-beam therapy is a highly precise radiation therapy exploiting the characteristic interaction of ions with matter. The steep dose gradient of the Bragg curve allows the irradiation of targets with high-dose and a narrow dose penumbra around the target, in contrast to photon irradiation. This, however, makes heavy ion-beam therapy very sensitive to minor changes in the range calculation of the treatment planning system, as it has a direct influence on the outcome of the treatment. Our previous study has shown that ion radiography with an amorphous silicon flat-panel detector allows the measurement of the water equivalent thickness (WET) of an imaging object with good accuracy and high spatial resolution. In this study, the developed imaging technique is used to measure the WET distribution of a patient-like phantom, and these results are compared to the WET calculation of the treatment planning system. To do so, a measured two-dimensional map of the WET of an anthropomorphic phantom was compared to WET distributions based on x-ray computed tomography images as used in the treatment planning system. It was found that the WET maps agree well in the overall shape and two-dimensional distribution of WET values. Quantitatively, the ratio of the two-dimensional WET maps shows a mean of 1.004 with a standard deviation of 0.022. Differences were found to be concentrated at high WET gradients. This could be explained by the Bragg-peak degradation, which is measured in detail by ion radiography with the flat-panel detector, but is not taken into account in the treatment planning system. Excluding pixels exhibiting significant Bragg-peak degradation, the mean value of the ratio was found to be 1.000 with a standard deviation of 0.012. Employment of the amorphous silicon flat-panel detector for WET measurements allows us to detect uncertainties of the WET determination in the treatment planning process. This makes the investigated technique a very helpful tool to study the WET determination of critical and complex phantom cases.
Asunto(s)
Radioterapia de Iones Pesados/instrumentación , Planificación de la Radioterapia Asistida por Computador/instrumentación , Cabeza/diagnóstico por imagen , Humanos , Fantasmas de Imagen , Silicio/química , Tomografía Computarizada por Rayos XRESUMEN
High dose gradients are inherent to ion beam therapy. This results in high sensitivity to discrepancies between planned and delivered dose distributions. Therefore an accurate knowledge of the ion stopping power of the traversed tissue is critical. One proposed method to ensure high quality dose deposition is to measure the stopping power by ion radiography. Although the idea of imaging with highly energetic ions is more than forty years old, there is a lack of simple detectors suitable for this purpose. In this study the performance of an amorphous silicon flat-panel detector, originally designed for photon imaging, was investigated for quantitative carbon ion radiography and tomography. The flat-panel detector was exploited to measure the water equivalent thickness (WET) and water equivalent path length (WEPL) of a phantom at the Heidelberg Ion-Beam Therapy Center (HIT). To do so, the ambiguous correlation of detector signal to particle energy was overcome by active or passive variation of carbon ion beam energy and measurement of the signal-to-beam energy correlation. The active method enables one to determine the WET of the imaged object with an uncertainty of 0.5 mm WET. For tomographic WEPL measurements the passive method was exploited resulting in an accuracy of 0.01 WEPL. The developed imaging technique presents a method to measure the two-dimensional maps of WET and WEPL of phantoms with a simple and commercially available detector. High spatial resolution of 0.8 × 0.8 mm(2) is given by the detector design. In the future this powerful tool will be used to evaluate the performance of the treatment planning algorithm by studying WET uncertainties.
Asunto(s)
Carbono , Radiografía/instrumentación , Tomografía/instrumentación , Carbono/química , Fantasmas de Imagen , Fotones , Silicio/química , AguaRESUMEN
Increased accuracy in radiation delivery to a patient provided by scanning particle beams leads to high demands on quality assurance (QA). To meet the requirements, an extensive quality assurance programme has been implemented at the Heidelberg Ion Beam Therapy Center. Currently, high-resolution radiographic films are used for beam spot position measurements and homogeneity measurements for scanned fields. However, given that using this film type is time and equipment demanding, considerations have been made to replace the radiographic films in QA by another appropriate device. In this study, the suitability of the flat-panel detector RID 256 L based on amorphous silicon was investigated as an alternative method. The currently used radiographic films were taken as a reference. Investigations were carried out for proton and carbon ion beams. The detectors were irradiated simultaneously to allow for a direct comparison. The beam parameters (e.g. energy, focus, position) currently used in the daily QA procedures were applied. Evaluation of the measurements was performed using newly implemented automatic routines. The results for the flat-panel detector were compared to the standard radiographic films. Additionally, a field with intentionally decreased homogeneity was applied to test the detector's sensitivities toward possible incorrect scan parameters. For the beam position analyses, the flat-panel detector results showed good agreement with radiographic films. For both detector types, deviations between measured and planned spot distances were found to be below 1% (1 mm). In homogeneously irradiated fields, the flat-panel detector showed a better dose response homogeneity than the currently used radiographic film. Furthermore, the flat-panel detector is sensitive to field irregularities. The flat-panel detector was found to be an adequate replacement for the radiographic film in QA measurements. In addition, it saves time and equipment because no post-exposure treatment and no developer and darkroom facilities are needed.