RESUMEN
A new sensor for calcium based on a piezoelectric quartz crystal is presented. The selectivity depends on the ratio lipophilic salt/ionophore of the composition of the coating of the quartz crystal. A crystal coated with a THF solution of PVC (34.5% w/w), DOS (62.1% w/w) and 10,19-bis[(octadecylcarbamoyl) methoxyacetyl]-1,4,7,13,16-pentaoxa-10,19-diaza cycloheneicosane (3.4% w/w) and a salt/ionophore molar proportion of 60%, corresponding to a frequency decrease of the dry crystal of 6.0 kHz, showed a detection limit to calcium of 2.2 mg/L. Both a standard calcium chloride solution and a commercially balanced salt solution for tissue culture were analyzed subsequent to ion chromatographic separation. The results obtained with the sensor developed were compared with those obtained with a conductivity detector. Although the results from both detectors agreed for the standard solution, only the quartz crystal sensor was able to give reliable results for the tissue culture solution.
Asunto(s)
Calcio/análisis , Medios de Cultivo/química , Cloruro de Calcio , Técnicas de Cultivo , Ácido Edético , Electroquímica/métodos , Cuarzo , Reproducibilidad de los Resultados , Sensibilidad y EspecificidadRESUMEN
N,N'-dibenzyl-4,13-diaza-18-crown-6 (A) and bis[(benzo-15-crown-5)-4'-ylmethyl] pimelate (B) were tested as coatings for two piezoelectric crystals for potassium quantification. Both sensors showed stability, reversibility and sensitivity characteristics that allowed their use in quantitative analysis. However, compound A is much more sensitive to potassium than B. Compound A also shows a larger relative sensitivity for potassium with regard to sodium than B. A pharmaceutical sample of known composition was analysed both by an acoustic wave sensor with a crystal coated with compound A and by conductivity. No statistically significant difference in the median of the results was found (alpha = 0.05), although precision is superior for the conductivity methodology. Performance of the sensor in terms of frequency stability and selectivity was improved by the incorporation of PVC, a plasticizer and a lipophilic salt in the coating composition. Limits of detection found for potassium were 1.92 ppm, or 1.75 ppm for a crystal with a frequency decrease due to coating of 2.9 kHz or 3.9 kHz, respectively. Selectivity coefficients (fixed interference 80 ppm) for potassium over Na, Ca, Al, Zn, Mg, and Fe ranged from 0.103 to 0.332.