RESUMEN
BACKGROUND: Low birth weight (LBW) is a risk factor associated with endometriosis. Our study aimed to analyze the risk of endometriosis in women with a LBW history and the relationships of progesterone receptor B (PR-B) gene promoter methylation, DNA methyltransferase-1 (DNMT1) expression, PR-B expression, and vascular endothelial growth factors (VEGF) with endometriosis. METHODS: This study was conducted in two stages, a retrospective case-control design and a cross-sectional design, with 52 cases of endometriosis and 30 controls, which were further subdivided into LBW and non-LBW groups, at Hasan Sadikin General Hospital and its hospital networks from October 2017 to August 2021. Menstrual blood was taken from subjects and analyzed using pyrosequencing techniques to assess DNA methylation, while q-RT PCR was used to assess gene expression. RESULTS: There were significant differences in PR-B methylation, DNMT1 expression, PR-B expression, and VEGF expression (p < 0.001) between the case and control groups. There was a significant negative correlation between PR-B methylation and PR-B expression (r = -0.558; p = 0.047). Based on a multiple logistic analysis, the most dominant factor affecting endometriosis incidence is PR-B (OR 10.40, 95% CI 3.24-33.4, R2 = 45.8). We found that patients with a low birth weight history had a 1.41-times-higher risk of developing endometriosis (95% CI 0.57-3.49, p = 0.113), although the relationship was not statistically significant. CONCLUSION: Endometriosis is associated with PR-B gene promoter hypermethylation, decreased PR-B expression, and increased DNMT1 and VEGF expression. The methylation of PR-B is the most dominant factor affecting endometriosis incidence.
RESUMEN
We present a low-cost and simple method to fabricate a novel lock-and-key mixer microfluidics using an economic stereolithography (SLA) three-dimensional (3D) printer, which costs less than USD 400 for the investment. The proposed study is promising for a high throughput fabrication module, typically limited by conventional microfluidics fabrications, such as photolithography and polymer-casting methods. We demonstrate the novel modular lock-and-key mixer for the connector and its chamber modules with optimized parameters, such as exposure condition and printing orientation. In addition, the optimization of post-processing was performed to investigate the reliability of the fabricated hollow structures, which are fundamental to creating a fluidic channel or chamber. We found out that by using an inexpensive 3D printer, the fabricated resolution can be pushed down to 850 µm and 550 µm size for squared- and circled-shapes, respectively, by the gradual hollow structure, applying vertical printing orientation. These strategies opened up the possibility of developing straightforward microfluidics platforms that could replace conventional microfluidics mold fabrication methods, such as photolithography and milling, which are costly and time consuming. Considerably cheap commercial resin and its tiny volume employed for a single printing procedure significantly cut down the estimated fabrication cost to less than 50 cents USD/module. The simulation study unravels the prominent properties of the fabricated devices for biological fluid mixers, such as PBS, urine and plasma blood. This study is eminently prospective toward microfluidics application in clinical biosensing, where disposable, low-cost, high-throughput, and reproducible chips are highly required.
RESUMEN
BACKGROUND: Preeclampsia is a complication during pregnancy characterised by new-onset hypertension and proteinuria that develops after 20 weeks of gestation. Dyslipidemia in pregnancy is correlated with an increased risk of preeclampsia. However, the dynamic changes in lipid metabolic product, particularly fatty acid fraction, in preeclampsia maternal circulation, are not well understood. This study aimed to investigate fatty acid fraction in preeclampsia maternal blood compared with normotensive normal pregnancy. METHODS: A total of 34 women who developed preeclampsia and 32 women with normotensive normal pregnancy were included in our case-control study. Maternal blood samples were collected for serum fatty acid fractions analysis and other biochemical parameters. Serum fatty acid fractions included long-chain polyunsaturated fatty acid (LCPUFA), monounsaturated fatty acid (MUFA), saturated fatty acid, and total fatty acid, measured with gas chromatography-mass spectrometry (GC-MS). The mean difference of fatty acid level was analysed using parametric and non-parametric bivariate analysis based on normality distributed data, while the risk of preeclampsia based on fatty acid fraction was analysed using a logistic regression model. RESULTS: Women with preeclampsia have lower high-density lipoprotein (53.97 ± 12.82 mg/dL vs. 63.71 ± 15.20 mg/dL, p = 0.006), higher triglyceride (284.91 ± 97.68 mg/dL vs. 232.84 ± 73.69 mg/dL, p = 0.018) than that in the normotensive group. Higher palmitoleic acid was found in women with preeclampsia compared to normotensive normal pregnancy (422.94 ± 195.99 vs. 325.71 ± 111.03 µmol/L, p = 0.037). The binary logistic regression model showed that pregnant women who had total omega-3 levels within the reference values had a higher risk of suffering preeclampsia than those with the higher reference value (odds ratio OR (95% CI): 8,5 (1.51-48.07), p = 0.015). Pregnant women who have saturated fatty acid within reference values had a lower risk for suffering preeclampsia than those in upper reference value (OR (95% CI): 0.21 (0.52-0.88), p = 0.032). CONCLUSION: Overall, palmitoleic acid was higher in women with preeclampsia. Further analysis indicated that reference omega-3 in and high saturated fatty acid serum levels are characteristics of women with preeclampsia.