RESUMEN
In this paper the pulse thermovision (photothermal) detection and quantification methods of C60 and C70 fullerenes are presented. Quantification results are compared with optical and fluorescence measurements. Target components were separated under isothermal conditions (30 °C) on micro-TLC plates (RP18WF254S) using n-hexane as the mobile phase. The principle of described analytical protocol is based on sensitive measurement of the temperature contrast generated within TLC stationary phase and fullerenes spots after white light pulse excitation. It has been demonstrated that observed temperature contrast is mainly driven by the optical properties of fullerenes (UV-vis absorption spectra). Contrary to the commonly applied optical reflection or transmission techniques the proposed thermovision method involves dissipated light. The results of presented experimental work have revealed that both types of quantitative measurements provide similar outcome despite the key differences in the signal origin. However, it has been found that thermovision method was characterized by smaller value of LOD, particularly for C60 molecule. We demonstrated that application of correlation technique to post-acquisition analysis of the sequence of temperature contrast images significantly increase detection limits of fullerenes, even in comparison to fluorescence quenching detection mode. Moreover, the thermal contrast images and particularly, computed correlation image, allow detection of stationary phase layer nonuniformities, including changes in the adsorbent thickness and thermal conductivity. Therefore, invented pulsed thermovision methodology can be additionally used for fast quality screening of home made and commercially available TLC plates.
Asunto(s)
Fulerenos/análisis , Temperatura , Cromatografía en Capa Delgada , Procesos FotoquímicosRESUMEN
The main goal of this paper is to demonstrate capability of pulse thermovision (thermal-wave) methodology for sensitive detection of photothermal non-uniformities within light scattering and semi-transparent planar stationary phases. Successful visualization of stationary phases defects required signal processing protocols based on wavelet filtration, correlation analysis and k-means 3D segmentation. Such post-processing data handling approach allows extremely sensitive detection of thickness and structural changes within commercially available planar chromatographic layers. Particularly, a number of TLC and HPTLC stationary phases including silica, cellulose, aluminum oxide, polyamide and octadecylsilane coated with adsorbent layer ranging from 100 to 250µm were investigated. Presented detection protocol can be used as an efficient tool for fast screening the overall heterogeneity of any layered materials. Moreover, described procedure is very fast (few seconds including acquisition and data processing) and may be applied for fabrication processes online controlling. In spite of planar chromatographic plates this protocol can be used for assessment of different planar separation tools like paper based analytical devices or micro total analysis systems, consisted of organic and non-organic layers.