RESUMEN
X-ray diffraction/scattering computed tomography (XRS-CT) was used to create two-dimensional images, with 20 µm resolution, of passivated Co/TiO2/Mn Fischer-Tropsch catalyst extrudates postreaction after 300 h on stream under industrially relevant conditions. This combination of scattering techniques provided insights into both the spatial variation of the different cobalt phases and the influence that increasing Mn loading has on this. It also demonstrated the presence of a wax coating throughout the extrudate and its capacity to preserve the Co/Mn species in their state in the reactor. Correlating these findings with catalytic performance highlights the crucial phases and active sites within Fischer-Tropsch catalysts required for understanding the tunability of the product distribution between saturated hydrocarbons or oxygenate and olefin products. In particular, a Mn loading of 3 wt % led to an optimum equilibrium between the amount of hexagonal close-packed Co and Co2C phases resulting in maximum oxygenate selectivity. XRS-CT revealed Co2C to be located on the extrudates' periphery, while metallic Co phases were more prevalent toward the center, possibly due to a lower [CO] ratio there. Reduction at 450 °C of a 10 wt % Mn sample resulted in MnTiO3 formation, which inhibited carbide formation and alcohol selectivity. It is suggested that small MnO particles promote Co carburization by decreasing the CO dissociation barrier, and the Co2C phase promotes CO nondissociative adsorption leading to increased oxygenate selectivity. This study highlights the influence of Mn on the catalyst structure and function and the importance of studying catalysts under industrially relevant reaction times.
RESUMEN
Chlorpyrifos (CPF) is a widely used pesticide; however, limited experimental work has been completed on its thermal decomposition. CPF is known to decompose into 3,5,6-trichloro-2-pyridinol (TCpyol) together with ethylene and HOPOS. Under oxidative conditions TCpyol can decompose into the dioxin-like 2,3,7,8-tetrachloro-[1,4]-dioxinodipyridine (TCDDPy). With CPF on the cusp of being banned in several jurisdictions worldwide, the question might arise as to how to safely eliminate large stockpiles of this pesticide. Thermal methods such as incineration or thermal desorption of pesticide-contaminated soils are often employed. To assess the safety of thermal methods, information about the toxicants arising from thermal treatment is essential. The present flow reactor study reports the products detected under inert and oxidative conditions from the decomposition of CPF representative of thermal treatments and of wildfires in CPF-contaminated vegetation. Ethylene and TCpyol are the initial products formed at temperatures between 550 and 650 °C, although the detection of HOPOS as a reaction product has proven to be elusive. During pyrolysis of CPF in an inert gas, the dominant sulfur-containing product detected from CPF is carbon disulfide. Quantum chemical analysis reveals that ethylene and HOPOS undergo a facile reaction to form thiirane (c-C2H4S) which subsequently undergoes ring opening reactions to form precursors of CS2. At elevated temperatures (>650 °C), TCpyol undergoes both decarbonylation and dehydroxylation reactions together with decomposition of its primary product, TCpyol. A substantial number of toxicants is observed, including HCN and several nitriles, including cyanogen. No CS2 is observed under oxidative conditions - sulfur dioxide is the fate of S in oxidation of CPF, and quantum chemical studies show that SO2 formation is initiated by the reaction between HOPOS and O2. The range of toxicants produced in thermal decomposition of CPF is summarised.