RESUMEN
The fretting fatigue performance of laminated, unidirectional (UD), pin-loaded, carbon fibre-reinforced polymer (CFRP) straps that can be used as bridge hanger cables was investigated at a sustained service temperature of 60 °C. The aim of this paper is to elucidate the influence of the slightly elevated service temperature on the tensile fatigue performance of CFRP straps. First, steady state thermal tests at ambient temperature and at 60 °C are presented, in order to establish the behaviour of the straps at these temperatures. These results indicated that the static tensile performance of the straps is not affected by the increase in temperature. Subsequently, nine upper stress levels (USLs) between 650 and 1400 MPa were chosen in order to establish the S-N curve at 60 °C (frequency 10 Hz; R = 0.1) and a comparison with an existing S-N curve at ambient temperature was made. In general, the straps fatigue limit was slightly decreased by temperature, up to 750 MPa USL, while, for the higher USLs, the straps performed slightly better as compared with the S-N curve at ambient temperature.
RESUMEN
The performance of pretensioned, laminated, unidirectional (UD), carbon fiber reinforced polymer (CFRP) straps, that can potentially be used for example as bridge deck suspender cables or prestressed shear reinforcements for reinforced concrete slabs and beams, was investigated at elevated temperatures. This paper aims to elucidate the effects of elevated temperature specifically on the tensile performance of pretensioned, pin-loaded straps. Two types of tests are presented: (1) steady state thermal and (2) transient state thermal. Eight steady-state target temperatures in the range of 24 °C to 600 °C were chosen, based on results from dynamic mechanical thermal analysis (DMTA) and thermogravimetric analysis (TGA). Transient state thermal tests were performed at three sustained tensile load levels, namely 10, 15, and 20 kN, corresponding to 25%, 37%, and 50% of the ultimate tensile strength of the pin-loaded straps at ambient temperature. In general, the straps were able to retain about 50% of their ambient temperature ultimate tensile strength (UTS) at 365 °C.
RESUMEN
The inhibition of GABAA can be used in general anesthesia. Although, barbiturates and thiobarbiturates are used in anesthesia, the mechanism of their action hasn't been established. QSAR modeling is a wieldy used technique in these cases and this study presents the QSAR modeling for a group of barbiturates and thiobarbiturates with determined anesthetic activity. Developed QSAR models were based on conformation independent and 2D descriptors as well as field contribution. As descriptors used for developing conformation independent QSAR models, (SMILES) notation and local invariants of the molecular graph were used. Monte Carlo optimization method was applied for building QSAR models for two defined activities. Methodology for developing QSAR models capable of dealing with the small dataset that integrates dataset curation, "exhaustive" double cross-validation and a set of optimal model selection techniques including consensus predictions was used. Two-dimensional descriptors with definite physicochemical meaning were used and modeling was done with the application of both partial least squares and multiple linear regression models with three latent variables related to simple and interpretable 2D descriptors. Different statistical methods, including novel method - the index of ideality of correlation, were used to test the quality of the developed models, especially robustness and predictability and all obtained results were good. In this study, obtained results indicate that there is a very good correlation between all developed models. Molecular fragments that account for the increase/decrease of a studied activity were defined and further used for the computer-aided design of new compounds as potential anesthetics.