RESUMEN
The electrical and optoelectronic properties of materials are determined by the chemical potentials of their constituents. The relative density of point defects is thus controlled, allowing to craft microstructure, trap densities and doping levels. Here, we show that the chemical potentials of chalcogenide materials near the edge of their existence region are not only determined during growth but also at room temperature by post-processing. In particular, we study the generation of anion vacancies, which are critical defects in chalcogenide semiconductors and topological insulators. The example of CuInSe2 photovoltaic semiconductor reveals that single phase material crosses the phase boundary and forms surface secondary phases upon oxidation, thereby creating anion vacancies. The arising metastable point defect population explains a common root cause of performance losses. This study shows how selective defect annihilation is attained with tailored chemical treatments that mitigate anion vacancy formation and improve the performance of CuInSe2 solar cells.
RESUMEN
An accurate determination of the net dopant concentration in photovoltaic absorbers is critical for understanding and optimizing solar cell performance. The complex device structure of multilayered thin-film solar cells poses challenges to determine the dopant concentration. Capacitance-voltage ( C- V) measurements of Cu(In,Ga)Se2 thin-film solar cells typically yield depth-dependent apparent doping profiles and are not consistent with Hall measurements of bare absorbers. We show that deep defects cannot fully explain these discrepancies. We instead find that the space charge region capacitance follows the model of a linearly graded junction in devices containing a CdS or Zn(O,S) buffer layer, indicating that elemental intermixing at the absorber/buffer interface alters the dopant concentration within the absorber. For absorbers covered with MgF2, C- V measurements indeed agree well with Hall measurements. Photoluminescence measurements of Cu(In,Ga)Se2 absorbers before and after deposition of a CdS layer provide further evidence for a significant reduction of the near-surface net dopant concentration in the presence of CdS. We thus demonstrate that interdiffusion at the absorber/buffer interface is a critical factor to consider in the correct interpretation of doping profiles obtained from C- V analysis in any multilayered solar cell and that the true bulk dopant concentration in thin-film devices might be considerably different.
RESUMEN
Copper indium gallium diselenide-based technology provides the most efficient solar energy conversion among all thin-film photovoltaic devices. This is possible due to engineered gallium depth gradients and alkali extrinsic doping. Sodium is well known to impede interdiffusion of indium and gallium in polycrystalline Cu(In,Ga)Se2 films, thus influencing the gallium depth distribution. Here, however, sodium is shown to have the opposite effect in monocrystalline gallium-free CuInSe2 grown on GaAs substrates. Gallium in-diffusion from the substrates is enhanced when sodium is incorporated into the film, leading to Cu(In,Ga)Se2 and Cu(In,Ga)3Se5 phase formation. These results show that sodium does not decrease per se indium and gallium interdiffusion. Instead, it is suggested that sodium promotes indium and gallium intragrain diffusion, while it hinders intergrain diffusion by segregating at grain boundaries. The deeper understanding of dopant-mediated atomic diffusion mechanisms should lead to more effective chemical and electrical passivation strategies, and more efficient solar cells.