RESUMEN

BACKGROUND: Augmentation of the maxillary sinus increases the lost height of ridge in the posterior maxilla. Bony convolutions from the floor of the sinus called septa may be encountered during the procedure and significantly impact the outcome of the procedure. MATERIALS AND METHODS: For this retrospective study, 120 cone-beam computed tomography (CBCT) scans were collected from the archives of the department of oral radiology in the time period between January 2016 and August 2018. Planmeca Romexis® software version 3.2.7 was used to check for the incidence, and then among the septa, plane of orientation, location with respect to the wall of the sinus, and in terms of relation to tooth were examined. The average height and average width of all the septa were measured using a measuring tool in the software. RESULTS: Thirty-five of the total 88 patients showed septa in 40 sinuses, in which 36 sinuses showed one septum and 4 sinuses showed 2 septa. Forty-one septa were located on the floor of the sinus in the frontal orientation and 3 septa were located on the lateral wall of the sinus in the axial orientation. The mean height and mean width of the 41 septa on the floor of the sinus were 5.72 mm and 3.47 mm, respectively. The mean height of septa found on the lateral wall of the sinus was 5.59 mm. CONCLUSION: Septa had a higher tendency to be in bucco-palatal direction and on the floor of the sinus and frequent occurrence in the region of molars. A thorough prediagnostic evaluation using CBCT is necessary prior to sinus augmentation procedures.

RESUMEN

INTRODUCTION: The prevalence of group function and canine guided occlusion is common in natural dentition, but cross arch balance is not often seen. Hence, a study was carried out with following objectives: Analysis of incidence of cross arch balance in different age groups and working side occlusal wear facets in following subjects. MATERIALS AND METHODS: A total of 200 patients with natural dentition were included in the study. Subjects with cross arch balance were analyzed for working side occlusal wear facets. Data were analyzed statistically by Chi-square test. RESULTS: The incidence of cross arch balance in the study group was 0.7%. On examination, subjects with group function on the working side and cross arch balance on the non-working side had more occlusal wear facets. CONCLUSION: From the study, it was observed that there was no significant variation in the number and extent of wear facets between the cross arch and without cross arch subjects due the smaller sample size hence it was difficult to conclude the relationship non-working side contact as interference and its influence in wearing of dentition in this study.

Asunto(s)

RESUMEN

Implant placement has become a routine modality of dental care.Improvements in surgical reconstructive methods as well as increased prosthetic demands,require a highly accurate diagnosis, planning and placement. Recently,computer-aided design and manufacturing have made it possible to use data from computerised tomography to not only plan implant rehabilitation,but also transfer this information to the surgery.A review on one of this technique called Stereolithography is presented in this article.It permits graphic and complex 3D implant placement and fabrication of stereolithographic surgical templates. Also offers many significant benefits over traditional procedures.