RESUMEN
In adult patients with dental phobia, dental treatment may be difficult, or may not be possible. Depending on the level of fear or anxiety, non-pharmacological or pharmacological behavior management techniques are used in the dental treatment of such patients. Among the pharmacological behavior management techniques, minimal sedation, that is, the lowest depth of sedation, can be easily obtained in adult patients using oral sedatives, does not require special equipment or tools, and does not affect ventilatory and cardiovascular function. Diazepam is an anxiolytic drug belonging to the benzodiazepine family that, in addition to relieving anxiety, produces muscle relaxation, and is a representative drug used in adult patients with fear of dental treatment. Herein, we report the case of a 50-year-old woman with severe dental fear who successfully underwent long-term dental treatment in approximately 20 visits with minimal sedation using oral diazepam. In addition, we reviewed the considerations for the use of benzodiazepines for minimal sedation.
RESUMEN
This study aimed to analyze fracture strength in vitro by varying the axial height of the titanium insert and the labial height of the zirconia abutment in an internal connection implant to identify the titanium insert axial height with optimal mechanical stability. Sixty implants with an internal connection system were used. Two-piece zirconia abutments were used with the titanium inserts. Combinations of different titanium insert axial heights (mm) and zirconia abutment labial heights (mm) constituted five groups: Gr1 (1-3), Gr2 (3-3), Gr3 (3-5), Gr4 (5-3), and Gr5 (5-5). After thermocycling, a fracture load test was performed with a universal testing machine. The initial deformation load and the fracture load were measured and analyzed. The fractured surface and cross-section of the specimens were examined by scanning electron microscopy (SEM). The groups of titanium inserts with axial heights of 3 mm and 5 mm showed significantly greater initial deformation load and fracture load than the group with an axial height of 1 mm (p < 0.05), but there was no significant difference between the two groups with axial heights of 3 mm and 5 mm. The labial height of the zirconia abutment had no significant influence on the initial deformation load and fracture load. In some specimens in Gr4 and Gr5, cracking or bending of the titanium insert and abutment screw was observed on SEM. The axial height of the titanium insert should be designed to not be less than 3 mm to increase the fracture strength and promote the long-term stability of implants.