RESUMEN
Shortages of personal protective equipment (PPE) at the start of the COVID-19 pandemic caused medical workers to reuse medical supplies such as N95 masks. While ultraviolet germicidal irradiation (UVGI) is commonly used for sterilization, UVGI can also damage the elastomeric components of N95 masks, preventing effective fit and thus weakening filtration efficacy. Although PPE shortage is no longer an acute issue, the development of sterilizable and reusable UV-resistant elastomers remains of high interest from a long-term sustainability and health perspective. Here, graphene nanosheets, produced by scalable and sustainable exfoliation of graphite in ethanol using the polymer ethyl cellulose (EC), are utilized as UV-resistant additives in polyurethane (PU) elastomer composites. By increasing the graphene/EC loading up to 1 wt %, substantial UV protection is imparted by the graphene nanosheets, which strongly absorb UV light and hence suppress photoinduced degradation of the PU matrix. Additionally, graphene/EC provides mechanical reinforcement, such as increasing Young's modulus, elongation at break, and toughness, with negligible changes following UV exposure. These graphene/EC-PU composites remain mechanically robust over at least 150 sterilization cycles, enabling safe reuse following UVGI. Beyond N95 masks, these UVGI-compatible graphene/EC-PU composites have potential utility in other PPE applications to address the broader issue of single-use waste.
Asunto(s)
COVID-19 , Grafito , Humanos , Elastómeros , Poliuretanos , Rayos Ultravioleta , PandemiasRESUMEN
We investigated polydimethylsiloxane/poly(methyl methacrylate) (PDMS/PMMA) interpenetrating polymer networks (IPNs) by both sequential and simultaneous syntheses. In the sequential IPN, the PDMS network was first thermally cured after which methyl methacrylate was swelled in and UV photopolymerized in situ. The simultaneous IPN consists of a one-pot, single-step UV cure of both components. Pure shear fracture and tensile tests were used to extract the Young's modulus, critical fracture strain, and fracture energy of the materials at varying PMMA fractions (up to 50 wt %). At high PMMA fractions, a maximum increase in Young's modulus (42×) and fracture energy (21×) was observed with little sacrifice in the optical properties and the extensibility of notched samples. The Krieger-Dougherty model for particle reinforcement was fit to the modulus data as a function of the PMMA fraction and showed good agreement. The optical properties and microstructure of the IPNs were investigated by UV-visible light transmission, small-angle X-ray scattering (SAXS), and atomic force microscopy (AFM). As the weight fraction of PMMA increased, the simultaneous IPN became less transparent, while the sequential material showed the opposite trend. In the sequential IPN, the minority phase size decreased with increasing PMMA fraction, while it was constant for the simultaneous IPN. Therefore, it was concluded that the sequential IPN transparency is controlled by the size of the PMMA domains, but the simultaneous IPN transparency is controlled by the PMMA fraction. SAXS and AFM also showed evidence of bicontinuous network formation in the simultaneous IPN, which may affect the optical and mechanical properties.