RESUMEN

This study aims to further develop the 14C-PMMA porosity calculation method with a novel autoradiography technique, the Micro-pattern gas detector autoradiography (MPGDA). In this study, the MPGDA is compared with phosphor screen autoradiography (SPA). A set of rock samples from Martinique Island exhibiting a large range of connected porosities was used to validate the MPGDA method. Calculated porosities were found to be in agreement with ones from the SPA and the triple-weight method (TW). The filmless nature of MPGDA as well as straightforward determination of C-14 radioactivity from the source rock makes the porosity calculation less uncertain. The real-time visualization of radioactivity from C-14 beta emissions by MPGDA is a noticeable improvement in comparison to SPA.

RESUMEN

In highly permeable sedimentary rock formations, U extraction by in-situ leaching techniques (ISR - In-Situ Recovery) is generally considered to have a limited environmental impact at ground level. Significantly, this method of extraction produces neither mill tailings nor waste rocks. Underground, however, the outcome for 238U daughter elements in aquifers is not well known because of their trace concentrations in the host rocks. Thus, understanding the in-situ mobility of these elements remains a challenge. Two samples collected before and after six months of ISR experiments (Dulaan Uul, Mongolia) were studied with the help of a digital autoradiography technique (DA) of alpha particles, bulk alpha spectrometry, and complementary petrographic observation methods. These techniques demonstrate that before and after leaching, the radioactivity is concentrated in altered and microporous Fe-Ti oxides. Most of the daughter elements of U remain trapped in the rock after the leaching process. DA confirms that the alpha activity of the Fe-Ti oxides remains high after uranium leaching, and the initial secular equilibrium of the 238U series for 230Th to 210Po daughter elements (including 226Ra) of the fresh rocks is maintained after leaching. While these findings should be confirmed by more systematic studies, they already identify potential mechanisms explaining why the U-daughter concentrations in leaching water are low.

Asunto(s)

RESUMEN

We set out to study connected porosity of crystalline rock using X-ray microtomography and scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM-EDS) with caesium chloride as a contrast agent. Caesium is an important radionuclide regarding the final deposition of nuclear waste and also forms dense phases that can be readily distinguished by X-ray microtomography and SEM-EDS. Six samples from two sites, Olkiluoto (Finland) and Grimsel (Switzerland), where transport properties of crystalline rock are being studied in situ, were investigated using X-ray microtomography and SEM-EDS. The samples were imaged with X-ray microtomography, immersed in a saturated caesium chloride (CsCl) solution for 141, 249 and 365 days and imaged again with X-ray microtomography. CsCl inside the samples was successfully detected with X-ray microtomography and it had completely penetrated all six samples. SEM-EDS elemental mapping was used to study the location of caesium in the samples in detail with quantitative mineral information. Precipitated CsCl was found in the connected pore space in Olkiluoto veined gneiss and in lesser amounts in Grimsel granodiorite. Only a very small amount of precipitated CsCl was observed in the Grimsel granodiorite samples. In Olkiluoto veined gneiss caesium was found in pinitised areas of cordierite grains. In the pinitised areas caesium was found in notable excess compared to chloride, possibly due to the combination of small pore size and negatively charged surfaces. In addition, elevated concentrations of caesium were found in kaolinite and sphalerite phases. The findings concerning the location of CsCl were congruent with X-ray microtomography.

RESUMEN

An out-diffusion laboratory experiment using a non-reactive tracer was fitted using the Time Domain Diffusion (TDD) method. This rapid particle tracking method allows simulation of the heterogeneous diffusion based on pore-scale images and local values of diffusivities. The superimposed porosity and mineral 2D maps act as computation grids to condition diffusion pathways. We focused on a Palmottu granite sample, in which the connected pore space has a composite microstructure with cracks linking microporous minerals and is above the percolation threshold. Three main results were achieved: (i) When compared to the fitting obtained with one coefficient (best mean square residual R = 1.6 x 10(-2)), diffusion is shown to be suitably characterised with two coefficients related to cracks and microporous minerals (best R = 6.5 x 10(-4)), (ii) rather than imposing a local apparent diffusion coefficient D(a) independent of the local porosity Phi, a best fit is obtained by applying Archie's relationship D(a) = D(0) x G with G = Phi(m) to each pixel of the calculation grids (G is the geometry factor, D(0) is the diffusion coefficient in free fluid, and m is Archie's exponent), and (iii) the order of magnitude of the fitted diffusion coefficient or Archie's exponents (m=0 for microcracks and m=1.82 for microporous minerals) is physically realistic.

Asunto(s)

RESUMEN

Different approaches for measuring the interaction between radionuclides and rock matrix are needed to test the compatibility of experimental retardation parameters and transport models used in assessing the safety of the underground repositories for the spent nuclear fuel. In this work, the retardation of sodium, calcium and strontium was studied on mica gneiss, unaltered, moderately altered and strongly altered tonalite using dynamic fracture column method. In-diffusion of calcium into rock cubes was determined to predict retardation in columns. In-diffusion of calcium into moderately and strongly altered tonalite was interpreted using a numerical code FTRANS. The code was able to interprete in-diffusion of weakly sorbing calcium into the saturated porous matrix. Elution curves of calcium for the moderately and strongly altered tonalite fracture columns were explained adequately using FTRANS code and parameters obtained from in-diffusion calculations. In this paper, mass distribution ratio values of sodium, calcium and strontium for intact rock are compared to values, previously obtained for crushed rock from batch and crushed rock column experiments. Kd values obtained from fracture column experiments were one order of magnitude lower than Kd values from batch experiments.

Asunto(s)