RESUMEN
This paper presents an empirical mode decomposition (EMD) and refined generalized zero crossing (rGZC) approach to achieve frequency recognition in steady-stated visual evoked potential (SSVEP)-based brain computer interfaces (BCIs). Six light emitting diode (LED) flickers with high flickering rates (30, 31, 32, 33, 34, and 35 Hz) functioned as visual stimulators to induce the subjects' SSVEPs. EEG signals recorded in the Oz channel were segmented into data epochs (0.75 s). Each epoch was then decomposed into a series of oscillation components, representing fine-to-coarse information of the signal, called intrinsic mode functions (IMFs). The instantaneous frequencies in each IMF were calculated by refined generalized zero-crossing (rGZC). IMFs with mean instantaneous frequencies (f(GZC)) within 29.5 Hz and 35.5 Hz (i.e., 29.5≤f(GZC)≤35.5 Hz) were designated as SSVEP-related IMFs. Due to the time-locked and phase-locked characteristics of SSVEP, the induced SSVEPs had the same frequency as the gazing visual stimulator. The LED flicker that contributed the majority of the frequency content in SSVEP-related IMFs was chosen as the gaze target. This study tests the proposed system in five male subjects (mean age=25.4±2.07 y/o). Each subject attempted to activate four virtual commands by inputting a sequence of cursor commands on an LCD screen. The average information transfer rate (ITR) and accuracy were 36.99 bits/min and 84.63%. This study demonstrates that EMD is capable of extracting SSVEP data in SSVEP-based BCI system.
Asunto(s)
Encéfalo/fisiología , Potenciales Evocados Visuales/fisiología , Reconocimiento en Psicología/fisiología , Interfaz Usuario-Computador , Adulto , Algoritmos , Simulación por Computador , Electroencefalografía , Fijación Ocular/fisiología , Humanos , Masculino , Modelos Neurológicos , Estimulación Luminosa , Percepción Visual/fisiología , Análisis de Ondículas , Adulto JovenRESUMEN
This study presents a new steady-state visual evoked potential (SSVEP) for brain computer interface (BCI) systems. The goal of this study is to increase the number of selections using fewer stimulation frequencies. This study analyzes the SSVEPs induced by six groups of light-emitting diodes (LEDs). The proposed method produces more selections than the number of stimulation frequencies through a suitable combination of dual frequencies for stimulation. Further, the six groups of LEDs are generated by four frequencies. The symmetric harmonic phenomena in this study helps increase recognition efficiency. This study tests seven subjects to verify the feasibility of the proposed method.
Asunto(s)
Potenciales Evocados Visuales/fisiología , Interfaz Usuario-Computador , Adulto , Encéfalo/fisiología , Electroencefalografía , Femenino , Humanos , MasculinoRESUMEN
This study presents a new steady-state visual evoked potential (SSVEP)-based brain computer interface (BCI). SSVEPs, induced by phase-tagged flashes in eight light emitting diodes (LEDs), were used to control four cursor movements (up, right, down, and left) and four button functions (on, off, right-, and left-clicks) on a screen menu. EEG signals were measured by one EEG electrode placed at Oz position, referring to the international EEG 10-20 system. Since SSVEPs are time-locked and phase-locked to the onsets of SSVEP flashes, EEG signals were bandpass-filtered and segmented into epochs, and then averaged across a number of epochs to sharpen the recorded SSVEPs. Phase lags between the measured SSVEPs and a reference SSVEP were measured, and targets were recognized based on these phase lags. The current design used eight LEDs to flicker at 31.25 Hz with 45 degrees phase margin between any two adjacent SSVEP flickers. The SSVEP responses were filtered within 29.25-33.25 Hz and then averaged over 60 epochs. Owing to the utilization of high-frequency flickers, the induced SSVEPs were away from low-frequency noises, 60 Hz electricity noise, and eye movement artifacts. As a consequence, we achieved a simple architecture that did not require eye movement monitoring or other artifact detection and removal. The high-frequency design also achieved a flicker fusion effect for better visualization. Seven subjects were recruited in this study to sequentially input a command sequence, consisting of a sequence of eight cursor functions, repeated three times. The accuracy and information transfer rate (mean +/- SD) over the seven subjects were 93.14 +/- 5.73% and 28.29 +/- 12.19 bits/min, respectively. The proposed system can provide a reliable channel for severely disabled patients to communicate with external environments.