RESUMEN
OBJECTIVES: The purpose of this study was to compare two different designs of three-dimensional osteosynthesis plates for their suitability in the treatment of mandibular angle fractures in terms of sufficient fracture healing and concomitant complications. MATERIALS AND METHODS: Retrospectively a total of 54 patients with 56 mandibular angle fractures were evaluated. Two different types of three-dimensional plates from the Medartis Trilock system were analyzed: (A) Square design plate (â-plate) with a thickness of 1.0 mm, and (B) triangular-shaped 3D-plate (â³-plate) with a thickness of 1.3 mm. Patient demographics, fracture mechanism and intraoperative details were recorded during an average follow-up period of 1 year. RESULTS: The utilization of â³-plates was observed to entail a considerably lengthier surgical time in contrast to â-plate systems (P = 0.037). The application of â³-plate showed a tendency of higher incidence of major complications than â-plate (P = 0.06), as evidenced by the occurrence of non-union in 2 out of 22 cases, resulting in higher surgical revision rate for â³-plate (P = 0.027). CONCLUSION: Sufficient treatment of mandibular angle fractures is feasible by using 1.0 mm thick, square shaped three-dimensional plate systems. The use of thicker three-dimensional osteosynthesis plates seems to significantly increase the operating time and complication rates, whereby the geometry of the plate seems to have an influence. CLINICAL RELEVANCE: The plate design could have an impact on treatment outcomes of mandibular angle fractures. TRIAL REGISTRATION NUMBER: Not applicable.