RESUMEN
Magnetic domain walls (DWs) in perpendicularly magnetised thin films are attractive for racetrack memories, but technological progress still requires further reduction of the operationing currents. To efficiently drive these objects by the means of electric current, one has to optimize the damping-like torque which is caused by the spin Hall effect (SHE). This not only requires a high net spin Hall angle but also the presence of a Dzyaloshinskii-Moriya interaction (DMI) to produce magnetic textures sensitive to this type of the torque. In this work, we explore the coexistence and importance of these two phenomena in epitaxial Pt/Co/Pt1-x Au x films in which we control the degree of inversion symmetry-breaking between the two interfaces by varying x. Gold is used as a material with negligible induced magnetic moment and SHE and the interface between Co/Au as a source of a small DMI. We find no current-induced DW motion in the symmetric Pt/Co/Pt (x = 0) trilayer. By fitting a one-dimensional model to the DW velocity as a function of drive current density and in-plane applied field in samples with non-zero values of x, we find that both net DMI strength and spin Hall angle rise monotonically as Au is introduced. They reach values of 0.75 ± 0.05 mJ m-2 and 0.10 ± 0.01, respectively, for Pt/Co/Au (x = 1).
RESUMEN
The interfacial Dzyaloshinskii-Moriya interaction (DMI) is important for chiral domain walls (DWs) and for stabilizing magnetic skyrmions. We study the effects of introducing increasing thicknesses of Ir, from zero to 2 nm, into a Pt/Co/Ta multilayer between the Co and Ta layers. There is a marked increase in magnetic moment, due to the suppression of the dead layer at the interface with Ta, but the perpendicular anisotropy is hardly affected. All samples show a universal scaling of the field-driven DW velocity across the creep and depinning regimes. Asymmetric bubble expansion shows that DWs in all of the samples have the left-handed Néel form. The value of in-plane magnetic field at which the creep velocity shows a minimum drops markedly on the introduction of Ir, as does the frequency shift of the Stokes and anti-Stokes peaks in Brillouin light scattering (BLS) measurements. Despite this qualitative similarity, there are quantitative differences in the DMI strength given by the two measurements, with BLS often returning higher values. Many features in bubble expansion velocity curves do not fit simple models commonly used, namely a lack of symmetry about the velocity minimum and no difference in velocities at high in-plane fields. These features are explained by the use of a new model in which the depinning field is allowed to vary with in-plane field in a way determined from micromagnetic simulations. This theory shows that the velocity minimum underestimates the DMI field, consistent with BLS giving higher values. Our results suggest that the DMI at an Ir/Co interface has the same sign as the DMI at a Pt/Co interface.
RESUMEN
Magnetic skyrmions are knot-like quasiparticles. They are candidates for non-volatile data storage in which information is moved between fixed read and write terminals. The read-out operation of skyrmion-based spintronic devices will rely on the electrical detection of a single magnetic skyrmion within a nanostructure. Here we present Pt/Co/Ir nanodiscs that support skyrmions at room temperature. We measured the Hall resistivity and simultaneously imaged the spin texture using magnetic scanning transmission X-ray microscopy. The Hall resistivity is correlated to both the presence and size of the skyrmion. The size-dependent part matches the expected anomalous Hall signal when averaging the magnetization over the entire disc. We observed a resistivity contribution that only depends on the number and sign of skyrmion-like objects present in the disc. Each skyrmion gives rise to 22 ± 2 nΩ cm irrespective of its size. This contribution needs to be considered in all-electrical detection schemes applied to skyrmion-based devices. Not only the area of Néel skyrmions but also their number and sign contribute to their Hall resistivity.