RESUMEN
In order to assess sites for a deep geological repository for storing high-level nuclear waste safely in Germany, various numerical models and tools will be in use. For their interaction within one workflow, their reproducibility, and reliability version-controlled open-source solutions and careful documentation of model setups, results and verifications are of special value. However, spatially fully resolved models including all relevant physical and chemical processes are neither computationally feasible for large domains nor is the data typically available to parameterize such models. Thus, simplified models are crucial for the pre-assessment of possible sites to narrow down the list of suitable candidates for which detailed site investigations and fully resolved models will be done at a later stage. Still, the accuracy of these simplified models is of importance as the pre-assessment of suitable sites will be based on them. In this study, we compare the modelling capabilities of TransPyREnd, a one-dimensional transport code based on finite differences, specifically developed for the fast estimation of radionuclide transport by the German federal company for radioactive waste disposal (BGE), with OpenGeoSys, which is a modelling platform based on finite elements in up to three spatial dimensions. Both codes are used in the site selection procedure for the German nuclear waste repository. The comparison of the model results of TransPyREnd and OpenGeoSys is augmented by comparisons with an analytical solution for a homogeneous material. For the purpose of numerical benchmarking, we consider a geological profile located in southern Germany as an example where the hypothetical repository is located in a clay-stone formation. TransPyREnd and OpenGeoSys yield overall similar results. However, both codes use different discretizations which impact is the highest for strongly sorbing compounds, while the difference gets negligible for less sorbing and more diffusive compounds as higher diffusion tends to blur the initial conditions. Overall, the OpenGeoSys model is more exact whereas the TransPyREnd model has considerable faster run times. We found in our example, that significant substance amounts are only leaving the host rock formation, if apparent diffusion is high, for which case both codes give similar results, while relative differences are considerable for strongly sorbing compounds. However, in the latter case no significant substance amount of radionuclides leaves the host-rock formation, thus deeming the differences in the model results minor for the overall safety assessments of sites.
RESUMEN
The entomopathogenic fungus Metarhizium anisopliae is used as a biological pest control agent against various arthropod species, including ticks. However, the efficacy depends on tick species, tick stage and fungus strain. We studied the effect of M. anisopliae on engorged larvae and nymphs of Ixodes ricinus, the most abundant tick species in Europe, under laboratory and semi-field conditions. A significant reduction of engorged larvae and nymphs could be shown under laboratory as well as under semi-field conditions. Only 3.5% of the larvae treated in the lab and only 18.5% kept under semi-field conditions were able to develop into nymphs compared to the recovered nymphs of the control groups, which were regarded as 100%. Only 7.1% of nymphs were recovered as adult ticks after fungal treatment under semi-field conditions compared to the control (100%). The efficacy of blastospores of M. anisopliae against engorged larvae and nymphs of I. ricinus under semi-field conditions was demonstrated in this study, showing their high potential as a biological control agent of ticks. Further studies will have to investigate the effect of this agent against other stages of I. ricinus as well as other tick species before its value as a biological control agent against ticks can be fully assessed.