RESUMEN

Ion mobility mass spectrometry (ESI-tims-ToF-MS, syringe pump infusion) has been applied to glucose and oligosaccharide ethers derived from hydroxyethyl-methyl celluloses (HEMC) and hydroxyethyl celluloses (HEC) after permethylation and partial depolymerization: by hydrolysis without or with subsequent reductive amination with m-amino benzoic acid (mABA) or by reductive cleavage. As model compounds without tandem substitution methoxyethylated methylcellulose was used. Regioisomeric glucose ethers were separated according to their ion mobility, and positions of substitution could be assigned. Glucose ethers including isomers with tandem substitution showed additional signals with a smaller collision cross-section (CCS) than core-substituted isomers. Positional isomers of cellobiose ethers were only partly resolved due to too high complexity but showed a characteristic fingerprint that might allow classifying samples. Relative intensities of signals of glucose ether isomers could only be quantified in case of ABA derivatives with its fixed charge, while sodium adducts of methoxyethyl ethers showed an influence of the MeOEt position on ion yield. Results were in very good agreement with reference analysis. [M + Na]+ adducts of α- and ß-anomers of glucose derivatives were separated in IM, complicating position assignment. This could be overcome by reductive cleavage of the permethylated HE(M)C yielding 1,5-anhydroglucitol-terminated oligosaccharides, showing the best resolved fingerprints of the cellobiose ethers of a particular cellulose ether. With this first application of ion mobility MS to the analysis of complex cellulose ethers, the promising potential of this additional separation dimension in mass spectrometry is demonstrated and discussed.

RESUMEN

The methyl substitution along and among the polymer chains of methyl cellulose (MC) is commonly analyzed by ESI-MS after perdeuteromethylation of the free-OH groups and partial hydrolysis to cello-oligosaccharides (COS). This method requires a correct quantification of the molar ratios of the constituents belonging to a particular degree of polymerization (DP). However, isotopic effects are most pronounced for H/D since their mass difference is 100%. Therefore, we investigated whether more precise and accurate results could be obtained for the methyl distribution of MC by MS of 13CH3 instead of CD3-etherified O-Me-COS. Internal isotope labeling with 13CH3 makes the COS of each DP chemically and physically much more similar, reducing mass fractionation effects, but at the same time requires more complex isotopic correction for evaluation. Results from syringe pump infusion ESI-TOF-MS with 13CH3 and CD3 as isotope label were equal. However, in the case of LC-MS with a gradient system, 13CH3 was superior to CD3. In the case of CD3, the occurrence of a partial separation of the isotopologs of a particular DP resulted in slight distortion of the methyl distribution since the signal response is significantly dependent on the solvent composition. Isocratic LC levels this problem, but one particular eluent-composition is not sufficient for a series of oligosaccharides with increasing DP due to peak broadening. In summary, 13CH3 is more robust to determine the methyl distribution of MCs. Both syringe pump and gradient-LC-MS measurements are possible, and the more complex isotope correction is not a disadvantage.

RESUMEN

The Arabidopsis thaliana genome harbors more than 450 nuclear genes encoding pentatricopeptide repeat (PPR) proteins that operate in the RNA metabolism of mitochondria and/or plastids. To date, the molecular function of many PPR proteins is still unknown. Here we analyzed the nucleus-encoded gene At4g19440 coding for a P-type PPR protein. Knockout of this gene interferes with normal embryo development and seed maturation. Two experimental approaches were applied to overcome lethality and to investigate the outcome of At4g19440 knockout in adult plants. These studies revealed changes in the abundance of several mitochondria-encoded transcripts. In particular, steady-state levels of dicistronic rpl5-cob RNAs were markedly reduced, whereas levels of mature ccmC and rpl2-mttB transcripts were clearly increased. Predictions according to the one repeat to one nucleotide code for PPR proteins indicate binding of the At4g19440 protein to a previously detected small RNA at the 3' termini of the dicistronic rpl5-cob transcripts. This potential interaction indicates a function of this protein in 3' end formation and stabilization of these RNA species, whereas the increase in the levels of the ccmC mRNA along with other mitochondria-encoded RNAs seems to be a secondary effect of At4g19440 knockout. Since the inactivation of At4g19440 influences the stability of several mitochondrial RNAs we call this gene MITOCHONDRIAL TRANSCRIPT STABILITY FACTOR 4 (MTSF4). This factor will be an interesting subject to study opposing effects of a single nucleus-encoded protein on mitochondrial transcript levels.

Asunto(s)

RESUMEN

The hydroxyethyl substitution along and among the polymer chains of respective cellulose ethers (HEC and HEMC) can be analyzed by ESI-IT-MS after permethylation of the free OH-groups, partial hydrolysis, and mABA labeling. This method requires the correct quantification of the molar ratios of the constituents belonging to a particular degree of polymerization (DP) with respect to their numbers of MeOEt and Me groups without any discrimination along the MS analysis pathway. The influence of the chemistry on the ionization and the impact of the voltages controlling the ion transport (Cap Exit, Octopoles) and the ion storage efficiency (Trap Drive, TD) on a relative quantification were studied using binary equimolar mixtures of cellobiose with increasing number of methoxyethyl and decreasing number of methyl groups (Δ m/z 88, 2× MeOEt). No suppression effects were observed in concentration-dependent measurements. Choice of Cap Exit is especially crucial for low m/z with less MeOEt residues. An equation describing the relationship between Oct 2 DC, m/z, and TDmax (TD at maximum intensity) was established from the experimental data and applied to calculate TDmax for higher DPs (larger COS). Optimized conditions allowed to determine the correct molar ratio of binary mixtures. Measurements of overlapping m/z segments and subsequent interrelation of the data gave complete substitution profiles for MeOEt/Me celluloses in accordance with reference data. The study generally makes aware of potential erroneous quantification in ESI-IT-MS analysis using internal standards of similar chemistry or in relative quantification of analytes, even for those with related structures.

Asunto(s)

RESUMEN

Exact quantification of the molar ratios of isotopologous mixed O-methyl-O-methyl-d3-cellooligosaccharides (COS) comprising all combinations from fully methylated to fully deuteromethylated constituents within an individual degree of polymerization (DP) is the key step in the analysis of the substituent distribution over the polymer chains in methyl celluloses (MC). Deuteromethylation of MC is performed to level chemical differences, but due to a m/z range of 3 DP·ΔMe/Me-d3, bias during MS measurement cannot certainly be excluded. Therefore, ionization, ion transportation, and ion storage were studied with an electrospray ionization ion trap mass spectrometer (ESI-IT-MS) using binary equimolar mixtures of per-O-Me- and per-O-Me-d3-COS, defining the border cases of a particular Me/Me-d3-profile. Reference data of their molar ratio were determined after reductive amination with m-amino benzoic acid by HPLC-UV. COS of DP2-6 were measured as their sodium adducts at c = 10-6 M by syringe pump infusion. The impact of the RF voltage of the ion trap (TD), the octopole RF and DC voltages, and the Cap Exit potential on absolute and relative ion intensities were studied. Adapting the Cap Exit voltage was essential for correct quantification of DP2, while all COS of higher DP behaved insensitive with respect to bias. To check whether any bias occurs in the electrospray ionization process of the isotopologs, concentration-dependent measurements were performed with optimized instrumental settings for each DP. Intensity ratios IR = I (Me-d3)/I (Me) did not show any concentration-dependent trend and no selective ion suppression. Its decrease with DP observed under usually applied standard conditions (smart mode) is a consequence of discrimination according to m/z and can be overcome by appropriate instrumental settings of Oct 2 DC and TD. IR between 0.971 ± 0.008 and 1.040 ± 0.009 with no trend for DP (2-6) were obtained by averaging all measurements in the range 2 · 10-7 to 2 · 10-5 M total concentration. The DP-related optimized settings were applied to two MCs and compared with the results obtained under so far applied standard conditions.

RESUMEN

KEY MESSAGE: RNA PROCESSING FACTORs 1 AND 8 (RPF1 and RPF8), both restorer of fertility like pentatricopeptide repeat proteins, are required for processing of dicistronic nad4L-atp4 and nad3-rps12 transcripts in Arabidopsis mitochondria. In mitochondria of Arabidopsis thaliana (Arabidopsis), the 5' termini of many RNAs are generated on the post-transcriptional level. This process is still poorly understood in terms of both the underlying mechanism as well as proteins required. Our studies now link the generation of polymorphic 5' extremities of the dicistronic nad3-rps12 and nad4L-atp4 transcripts to the function of the P-type pentatricopeptide repeat proteins RNA PROCESSING FACTORs 8 (RPF8) and 1 (RPF1). RPF8 is required to generate the nad3-rps12 -141 5' end in ecotype Van-0 whereas the RPF8 allele in Col has no function in the generation of any 5' terminus of this transcript. This observation strongly suggests the involvement of an additional factor in the generation of the -229 5' end of nad3-rps12 transcripts in Col. RPF1, previously found to be necessary for the generation of the -228 5' end of the major 1538 nucleotide-long nad4 mRNAs, is also important for the formation of nad4L-atp4 transcripts with a 5' end at position -318 in Col. Many Arabidopsis ecotypes contain inactive RPF1 alleles resulting in the accumulation of various low abundant nad4L-atp4 RNAs which might represent precursor and/or degradation products. Some of these ecotypes accumulate major, but slightly smaller RNA species. The introduction of RPF1 into these lines not only establishes the formation of the major nad4L-atp4 dicistronic mRNA with the -318 5' terminus, the presence of this gene also suppresses the accumulation of most alternative nad4L-atp4 RNAs. Beside RPF1, several other factors contribute to nad4L-atp4 transcript formation.

Asunto(s)

RESUMEN

In plant mitochondria, the 5' ends of many transcripts are generated post-transcriptionally. We show that the pentatricopeptide repeat (PPR) protein RNA PROCESSING FACTOR 4 (RPF4) supports the generation of extra 5' ends of ccmB transcripts in Landsberg erecta (Ler) and a number of other Arabidopsis thaliana ecotypes. RPF4 was identified in Ler applying a forward genetic approach supported by complementation studies of ecotype Columbia (Col), which generates the Ler-type extra ccmB 5' termini only after the introduction of the RPF4 allele from Ler. Studies with chimeric RPF4 proteins composed of various parts of the RPF4 proteins from Ler and Col identified differences in the N-terminal and central PPR motifs that explain ecotype-specific variations in ccmB processing. These results fit well with binding site predictions in ccmB transcripts based on the known determinants of nucleotide base recognition by PPR motifs.

Asunto(s)