RESUMEN
Lignin utilization in value-added co-products is an important component of enabling cellulosic biorefinery economics. However, aqueous dilute acid pretreatments yield lignins with limited applications due to significant modification during pretreatment, low solubility in many solvents, and high content of impurities (ash, insoluble polysaccharides). This work addresses these challenges and investigates the extraction and recovery of lignins from lignin-rich insoluble residue following dilute acid pretreatment and enzymatic hydrolysis of corn stover using three extraction approaches: ethanol organosolv, NaOH, and an ionic liquid. The recovered lignins exhibited recovery yields ranging from 30% for the ionic liquid, 44% for the most severe acid ethanol organosolv condition tested, and up to 86% for the most severe NaOH extraction condition. Finally, the fractional solubilities of different recovered lignins were assessed in a range of solvents and these solubilities were used to estimate distributions of Hildebrand and Hansen solubility parameters using a novel approach.
Asunto(s)
Líquidos Iónicos , Lignina , Lignina/química , Zea mays/química , Hidróxido de Sodio , Solventes , Etanol/química , Ácidos , HidrólisisRESUMEN
Corn stover was subjected to dilute sulfuric acid pretreatment to assess the impact of pretreatment conditions on lignin extractability, properties, and utility as a phenol replacement in wood phenol-formaldehyde (PF) adhesives. It was identified that both formic acid and NaOH could extract and recover 60-70% of the lignin remaining after pretreatment and enzymatic hydrolysis under the mildest pretreatment conditions while simultaneously achieving reasonable enzymatic hydrolysis yields (>60%). The availability of reaction sites for the incorporation of lignins into the PF polymer matrix (i.e., unsubstituted phenolic hydroxyl groups) was shown to be strongly impacted by the pretreatment time and the recovery. Finally, a lignin-based wood adhesive was formulated by replacing 100% of the phenol with formic-acid-extracted lignin, which exhibited a dry shear strength exceeding a conventional PF adhesive. These findings suggest that both pretreatment and lignin extraction conditions can be tailored to yield lignins with properties targeted for this co-product application.
Asunto(s)
Lignina , Fenol , Adhesivos , Madera , Fenoles , Ácidos , Formaldehído , HidrólisisRESUMEN
Prior work has identified that lignins recovered from dilute acid-pretreated corn stover exhibit superior performance in phenol-formaldehyde resins used in wood adhesive applications when compared to diverse process-modified lignins derived from other sources. This improved performance is hypothesized to be due to the higher content of unsubstituted phenolic groups specifically p-coumarate lignin esters. In this work, a diverse set of corn stover samples are employed that exhibit diversity in p-coumarate content and total lignin content to explore the relationship between dilute acid pretreatment conditions, p-coumarate ester hydrolysis, xylan solubilization, and the resulting glucose enzymatic hydrolysis yields. The goal of this study is to identify pretreatment conditions that preserve a significant fraction of the p-coumarate esters while simultaneously achieving high enzymatic hydrolysis yields. Kinetic parameters for p-coumarate ester hydrolysis were quantified and pretreatment-biomass combinations were identified that result in glucose hydrolysis yields of more than 90% while retaining nearly 50 mg p-coumarate/g lignin.