RESUMEN
The supramolecular structures and their constituents essentially determine the optoelectronic properties of thin films. The introduction of amphiphilicity to the constituents and interface assembly is one established technique to control supramolecular structures and resulting material properties. To yield amphiphilicity, rather hydrophobic chromophores are linked to hydrophilic head groups via flexible alkyl chains. In the present work, we investigate whether replacement of the alkyl linkers by a phenylene linker, that is, replacing an electrically isolating moiety with a potentially semiconducting one, increases the conductivity through the resulting layers. After investigating the influence of the linker on molecular properties of the 2-(4- N, N-dimethylaminophenyl)-4-hydroxy-5-nitrophenyl-1,3 thiazoles exemplarily used in this work, we produce supramolecular structures by means of the Langmuir-Blodgett (LB) technique. Atomic force microscopy (AFM) and UV-vis absorption spectroscopy reveal that thin films made from the more rigid thiazole bearing the arylic linker feature a more homogeneous and stable supramolecular structure as compared to those made from the thiazole dye containing the flexible alkylic linker. Finally, conductive AFM (cAFM) results disclose that the LB films made from the thiazole bearing the π-conjugated arylic linker are less conductive than their counterparts based on the alkylic linkers. In the latter layers, the alkylic linkers provide sufficient motional degrees of freedom to allow for supramolecular rearrangement upon electrical operation during cAFM measurements, hence yielding supramolecular structures featuring increased conductivity with successive cAFM measurements. This work highlights the importance of supramolecular structures for optoelectronic properties by presenting a case where supramolecular effects excel the property changes introduced by molecular modifications.
RESUMEN
We report the preparation and characterization of a matrix-free carboxylated surface plasmon resonance (SPR) sensor chip with high sensing efficiency by functionalizing a bare gold thin film with a self-assembled monolayer of 16-mercaptohexadecanoic acid (SAM-MHDA chip). The self assembled monolayer surface coverage of the gold layer was carefully evaluated and the SAM was characterized by infrared reflection absorption spectroscopy, X-ray photoemission spectroscopy, atomic force microscopy, X-ray reflectivity-diffraction, and SPR experiments with bovine serum albumin. We compared the SPR signal obtained on this chip made of a dense monolayer of carboxylic acid groups with commercially available carboxylated sensor chips built on the same gold substrate, a matrix-free C1 chip, and a CM5 chip with a ~100 nm dextran hydrogel matrix (GE Healthcare). Two well-studied interaction types were tested, the binding of a biotinylated antibody (immunoglobulin G) to streptavidin and an antigen-antibody interaction. For both interactions, the well characterized densely functionalized SAM-MHDA chip gave a high signal-to-noise ratio and showed a gain in the availability of immobilized ligands for their partners injected in buffer flow. It thus compared favourably with commercially available sensor chips.