RESUMEN

α-Diketones such as diacetyl (2,3-butanedione) and 2,3-pentanedione are generated during the roasting and fermentation of foods and are also used as flavoring compounds. Exposure to these compounds has been associated with obliterative bronchiolitis in workers. We report indoor air concentrations of diacetyl and 2,3-pentanedione, as well as acetoin (3-hydroxy-2-butanone), in several small coffee roasteries and breweries using standard integrated air sampling sorbent tubes followed by gas chromatography tandem mass spectrometry as well as the first use of on-site continuous real-time proton-transfer reaction time-of-flight mass spectrometry (PTR-ToF-MS). Diacetyl and 2,3-pentanedione were detected in most of the sorbent samples at concentrations between 0.02 and 8 ppbv, and in general were higher in coffee roasteries compared with breweries. Three integrated air samples, all from the barista area at one facility, exceeded the NIOSH recommended exposure limit (REL) of 5 ppbv for diacetyl. 2,3-Pentanedione concentrations in these three samples were greater than 50% of its REL, but did not exceed it. Acetoin, a precursor to diacetyl, was also detected at concentrations between 0.03 and 5 ppbv in most sorbent tube samples, with concentrations generally higher in breweries. PTR-ToF-MS measurements exhibited similar trends and provided continuous real-time volatile organic compound data that showed episodic excursions with peak concentrations of diacetyl and 2,3-pentanedione between 15 and 20 ppbv. Examination of the time series data identified specific activities associated with peak diketone emissions, including transfer of freshly roasted coffee beans to the cooling tray, or the opening of a brew kettle. Additional indoor air quality parameters including CO2, NO2, and PM2.5 were also assessed on-site. Airway inflammation was assessed in 19 workers before and after each work shift using online measurements of fractional exhaled nitric oxide (FENO). The pre-shift mean FENO was 3.7 (95% confidence interval: -3.6, 11.0) ppbv higher and the post-shift FENO was 7.1 (-1.9, 16.1) ppbv higher for workers at coffee roasteries compared with breweries. The cross-shift change in FENO was 3.4 (-2.8, 9.6) ppbv higher for workers at coffee roasteries compared with breweries. However, none of these differences were statistically significant, and the cross-shift change in FENO was not statistically different from zero for either group of workers. The findings from this pilot study demonstrate that α-diketones and related compounds are present in the indoor air of both breweries and coffee roasteries and may exceed health protective guidelines in coffee roasteries. Additional studies are required to fully characterize worker exposures in these settings and to identify specific work activities and processes associated with high exposures. Engineering controls, including targeted exhaust ventilation and the use of low-cost sensors, are recommended as an approach to protect workers from exposure to hazardous levels of α-diketones.

Asunto(s)

RESUMEN

Microplastics in the environment are an emerging concern due to impacts on human and environmental health. In addition to direct effects on biota, microplastics influence the fate and distribution of trace organic contaminants through sorption and transport. Environmental weathering may influence the rate and extent of chemical sorption. Changes in the surface characteristics of four common plastics including low-density polyethylene (LDPE), high-density polyethylene (HDPE), polypropylene (PP), and polystyrene (PS) were followed under the influence of both artificial light (UV-B) and natural sunlight for up to six months. Attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectra were collected at regular intervals. Principal component analysis (PCA) of the full dataset of UV-B weathered samples (n >500 spectra) simultaneously discriminated plastic type and extent of photochemical weathering. The magnitude of PCA scores correlated with exposure time and the loadings were consistent with surface chemistry changes including photooxidation. Projecting sunlight and UV-C exposed samples onto this PCA model demonstrated that similar chemical changes occurred, albeit at different rates. The results were compared to the carbonyl index (CI) with similar weathering trends indicating PP weathered at a faster initial rate than LDPE and HDPE. We propose that a multivariate approach is more widely applicable than CI as illustrated by PS, which lacked a stable reference peak. Kinetic analysis of the time series indicated that outdoor weathering occurred 5-12 times slower than the artificial exposure used here, depending on the plastic and the light source employed. The results provide unique insights into weathering processes and the photochemical age of naturally weathered plastics.

Asunto(s)

RESUMEN

Crude oil spills have well-documented, deleterious impacts on the hydrosphere. In addition to macroscopic effects on wildlife and waterscapes, several classes of petroleum derived compounds, such as naphthenic acids (NAs) and polycyclic aromatic hydrocarbons (PAHs), may be released into the water and present aquatic contamination hazards. The concentrations of these contaminants may be affected by both oil type and water chemistry. We characterize the concentrations of NAs and PAHs in natural and constructed waters, spanning a range of pH and salinity, and directly compare the influence of diluted bitumen (DB) and conventional crude (CC) oil, using condensed-phase membrane introduction mass spectrometry (CP-MIMS) as a direct sampling, on-line technique. The concentration and isomer class profiles of classical NAs in the aqueous phase were assessed using electrospray ionization in negative-ion mode as [M-H]- whereas PAH concentrations were monitored using liquid electron ionization (LEI) in positive-ion mode as [M+•]. NA concentrations (0.03-25 ppm) were highly pH-dependent, and an order of magnitude greater in water samples contaminated with DB than CC. Conversely, concentrations of naphthalene (10-130 ppb) and alkyl-naphthalenes (10-90 ppb) were three to four-fold higher in water samples exposed to CC. We demonstrate that naturally occurring dissolved organic matter does not bias results from the membrane sampling approach employed, and that DB and CC contaminated waters can be differentiated using principal component analysis of the NA isomer class distribution in both constructed and natural waters. Finally, we describe the first demonstration of the concurrent analysis of trace NAs and PAHs in the same water sample by controlling perm-selectivity at the membrane and the ionization mode of the mass spectrometer. The techniques employed here for trace analysis of petroleum derived compounds in water can be applied to rapid screening and real-time monitoring of contamination and remediation processes.

RESUMEN

The application of direct mass spectrometry techniques to the analysis of complex samples has a number of advantages including reduced sample handling, higher sample throughput, in situ process monitoring, and the potential for adaptation to on-site analysis. We report the application of a semi-permeable capillary hollow fibre membrane probe (immersed directly into an aqueous sample) coupled to a triple quadrupole mass spectrometer by a continuously flowing methanol acceptor phase for the rapid analysis of naphthenic acids with unit mass resolution. The intensity of the naphthenic acid-associated peaks in the mass spectrum are normalized to an internal standard in the acceptor phase for quantitation and the relative abundance of the peaks in the mass spectrum are employed to monitor compositional changes in the naphthenic acid mixture using principle component analysis. We demonstrate the direct analysis of a synthetic oil sands process-affected water for classical naphthenic acids (CnH2n+zO2) as they are attenuated through constructed wetlands containing sedge (Carex aquatilis), cattail (Typha latifolia), or bulrush (Schoenoplectus acutus). Quantitative results for on-line membrane sampling compare favourably to those obtained by solid-phase extraction high-resolution mass spectrometry. Additionally, chemometric analysis of the mass spectra indicates a clear discrimination between naphthenic acid-influenced and natural background waters. Furthermore, the compositional changes within complex naphthenic acid mixtures track closely with the degree of attenuation. Overall, the technique is successful in following changes in both the concentration and composition of naphthenic acids from synthetic oil sands process-affected waters, with the potential for high throughput screening and environmental forensics.

Asunto(s)