RESUMEN

The structural and adsorption characteristics of polymer adsorbent LiChrolut EN and the behavior of adsorbed water and water/organic mixtures were studied using adsorption, microcalorimetry, transmission and scanning electron microscopy, mass spectrometry, infrared spectroscopy, 1H NMR spectroscopy with layer-by-layer freezing-out of liquids (190-273 K), and thermally stimulated depolarization current method (90-265 K). This adsorbent is characterized by large specific surface area (approximately 1500 m2/g) and pore volume (0.83 cm3/g) with a major contribution of narrow pores (R<10 nm) of a complicated shape (long hysteresis loop is in nitrogen adsorption-desorption isotherm). The adsorbent includes aromatic and aliphatic structures and oxygen-containing functionalities and can effectively adsorb organics and water/organic mixtures. On co-adsorption of water and organics (dimethyl sulfoxide, chloroform, methane), there is a weak influence of one on another adsorbate due to their poor mixing in pores. Weakly polar chloroform displaces a fraction of water from narrow pores. These effects can explain high efficiency of the adsorbent in solid-phase extraction of organics from aqueous solutions. The influence of structural features of several carbon and polymer adsorbents on adsorbed nitrogen, water and water/organics is compared on the basis of the adsorption and 1H NMR data.

RESUMEN

A variety of fumed oxides such as silica, alumina, titania, silica/alumina (SA), silica/titania (ST), and alumina/silica/titania (AST) were characterized. These oxides have different specific surface areas and different primary particle composition in the bulk and at the surface. These materials were studied by FTIR, NMR, Auger electron spectroscopy, one-pass temperature-programmed desorption with mass spectrometry control (OP TPDMS), microcalorimetry, and nitrogen adsorption. Nonlinear changes in the surface content of alumina in SA and AST and titania in ST and AST samples with increasing oxide content along with simultaneous changes in their specific surface area cause complex dependencies of the heat of immersion in water and desorption of water on heating on the structural parameters. Simultaneous analysis of changes in the surface phase composition, in the concentration of hydroxyls, and in the structural characteristics reveals that at a low content of the second phase the structural characteristics (e.g., S(BET)) are predominant; however, at a large content of these oxides the phase composition plays a more important role.

Asunto(s)

RESUMEN

Interaction of poly(vinyl alcohol) (PVA) with fumed silica was investigated in the gas phase and aqueous media using adsorption, broadband dielectric relaxation spectroscopy (DRS), thermally stimulated depolarization current (TSDC), infrared spectroscopy, thermal analysis, and one-pass temperature-programmed desorption (OPTPD) mass-spectrometry (MS) methods. PVA monolayer formation leads to certain textural changes in the system (after suspension and drying) because of strong hydrogen bonding of the polymer molecules to silica nanoparticles preventing strong interaction between silica particles themselves. This strong interaction promotes associative desorption of water molecules at lower temperatures than in the case of silica alone. Interaction of PVA with silica and residual water leads to depression of glass transition temperature (T(g)). There are three types of dipolar relaxations at temperatures lower and higher than the T(g) value. A small amount of adsorbed water leads to significant conductivity with elevating temperature.

Asunto(s)

RESUMEN

Applications of thermally stimulated depolarisation current (TSDC) technique to a variety of systems with different dispersion phases such as disperse and porous metal oxides, polymers, liquid crystals, amorphous and crystalline solids, composites, solid solutions, biomacromolecules, cells, tissues, etc. in gaseous or liquid dispersion media are analysed. The effects of dipolar, direct current (dc) and space charge relaxations are linked to the temperature dependent mobility of molecules, their fragments, protons, anions, and electrons and depend on thermal treatment, temperature and field intensity of polarisation, heating rate on depolarisation or cooling rate on polarisation. Features of the relaxation mechanisms are affected not only by the mentioned factors but also by morphological, structural and chemical characteristics of materials. The interfacial phenomena, especially the role of interfacial water, received significant attention on analysis of the TSDC data. Comparison of the data of TSDC and dielectric relaxation spectroscopy (DRS), differential scanning calorimetry (DSC), 1H NMR spectroscopy with layer-by-layer freezing-out of bulk and interfacial water, adsorption/desorption of nitrogen, water and dissolved organics demonstrates high sensitivity and information content of the TSDC technique, allowing a deeper understanding of interfacial phenomena.