RESUMEN
A growing environmental concern is increasing the search for new sustainable materials. In this scenario, natural lignocellulosic fibers (NLFs) became an important alternative to replace synthetic fibers commonly used as composites reinforcement. In this regard, unknown NLFs such as the caranan fiber (Mauritiella armata) found in South American rain forests revealed promising properties for engineering applications. Thus, for the first time, the present work conducted a technical characterization of caranan fiber-incorporated composites. Epoxy matrix composites with 10, 20 and 30 vol% of continuous and aligned caranan fibers were investigated by tensile tests, thermogravimetric analysis (TGA) and differential scanning calorimetry (DSC). Composites with more than 10% vol of caranan fibers significantly increase the elastic modulus and toughness in comparison to the neat epoxy. Indeed, the composite with 30 vol% was 50% stiffer, 130% tougher, and 100% stronger, which characterized an effective reinforcement. As for the elastic modulus, total strain and tensile toughness, there is a clear tendency of improvement with the amount of caranan fiber. The TGA disclosed the highest onset temperature of degradation (298 °C) with the least mass loss (36.8%) for the 30 vol% caranan fiber composite. It also displayed a higher degradation peak at 334 °C among the studied composites. The lowest glass transition temperature of 63 °C was obtained by DSC, while the highest of 113 °C by dynamic mechanical analysis (DMA) for the 30 vol% caranan composite. These basic technical findings emphasize the caranan fiber potential as reinforcement for polymer composites.
RESUMEN
Composites reinforced with natural lignocellulosic fibers (NLFs) are gaining relevance as the worldwide demand for renewable and sustainable materials increases. To develop novel natural composites with satisfactory properties, less common NLFs should also be investigated. Among these, the Cyperus malaccensis (CM), a type of sedge fiber, is already used in simple items like ropes, furniture, and paper, but has not yet been investigated as composite reinforcement for possible engineering applications. Therefore, the present work evaluated for the first time the properties of novel epoxy composites incorporated with 10, 20, and 30 vol.% of CM sedge fibers. Tensile, Izod-impact, and ballistic impact tests were performed, as well as Fourier transform infrared (FT-IR) spectroscopy and thermal analysis of the composites. Results disclosed a decrease (-55%) in tensile strengths as compared to the neat epoxy. However, the elastic modulus of the 30 vol.% sedge fiber composite increased (+127%). The total strain and absorbed ballistic energy did not show significant variation. The Izod impact energy of the 30 vol.% composite was found to be 181% higher than the values obtained for the neat epoxy as a control sample. An increase in both stiffness and toughness characterized a reinforcement effect of the sedge fiber. The thermal analysis revealed a slight decrease (-15%) in the degradation temperature of the CM sedge fiber composites compared to the neat epoxy. The glass-transition temperatures were determined to be in the range of 67 to 81 °C.