RESUMEN

Recently, the idea of generating radon map of Brazil has emerged. First attempts of coordinating radon surveys--carried out by different groups across the country--and initial discussions on how to proceed on a larger scale were made at the First Brazilian Radon Seminary, Natal, September 2012. Conventionally, it is believed that indoor radon is no major problem in Brazil, because the overall benign climate usually allows high ventilation rates. Nevertheless, scattered measurements have shown that moderately high indoor radon concentrations (up to a few hundred Bq m⁻³) do occur regionally. Brazilian geology is very diverse and there are regions where an elevated geogenic radon potential exists or is expected to exist. Therefore, a Brazilian Radon Survey is expected to be a challenge, although it appears an important issue, given the rising concern of the public about the quality of its environment.

Asunto(s)

Contaminación del Aire Interior/análisis , Monitoreo de Radiación , Contaminantes Radiactivos/análisis , Radón/análisis , Brasil , Recolección de Datos , Ambiente , Fenómenos Geológicos , Vivienda , Humanos

RESUMEN

This work presents the results of radon concentration measurements of construction materials used in the Brazilian industry, such as clay (red) bricks and concrete blocks. The measurements focused on the detection of indoor radon activity during different construction stages and the analysis of radionuclides present in the construction materials. For this purpose, sealed chambers with internal dimensions of approximately 60×60×60 cm3 were built within a protected and isolated laboratory environment, and stable air humidity and temperature levels were maintained. These chambers were also used for radon emanation reduction tests. The chambers were built in four major stages: (1) assembly of the walls using clay (red) bricks, concrete blocks, and mortar; (2) installation of plaster; (3) finishing of wall surface using lime; and (4) insulation of wall surface and finishing using paint. Radon measurements were performed using polycarbonate etched track detectors. By comparing the three layers applied to the masonry walls, it was concluded that only the last step (wall painting using acrylic varnish) reduced the radon emanation, by a factor of approximately 2. Samples of the construction materials (clay bricks and concrete blocks) were ground, homogenized, and subjected to gamma-ray spectrometry analysis to evaluate the activity concentrations of 226Ra, 232Th and 40K. The values for the index of the activity concentration (I), radium equivalent activity (Raeq), and external hazard index (Hext) showed that these construction materials could be used without restrictions or concern about the equivalent dose limit (1 mSv/year).

RESUMEN

Since the earliest works proposing the use of protons for imaging, the main advantage of protons over X-rays was expected to be a result of the specific property of the proton flux dropping off very steeply at the end of the particle range. This idea was declared but was not checked. In the present work, this assumption was investigated using the Monte Carlo simulation for the case of registration of protons with a thin detector.