RESUMEN
Agro-waste having lignocellulosic biomass is considered most effective (heating value 16 MJ/kg) for energy production through anaerobic digestion (AD). However, recalcitrant lignocellulosic fraction in agro-waste obstructs its biotransformation and is a rate-limiting step of the process. This study investigated the effects of hydrothermal and thermal-alkaline pretreatment on anaerobic co-digestion of wheat straw (WS). The hydrothermal pretreatment of WS revealed that 60 min was the best pretreatment time to achieve the highest substrate solubilization. It was employed for thermal-alkali pretreatment at variable temperatures and NaOH doses. Thermal-alkali pretreatment at 125°C-7% NaOH shows the highest (34%) biogas yield of 662 mL/gVS, followed by 646 mL/gVS biogas yield at 150°C-1% NaOH assay (31% higher) over control. Although the 125°C-7% NaOH assay achieved the highest biogas yield, the 150°C-1% NaOH assay was found more feasible considering the cost of a 6% higher chemical used in the earlier assay. The thermal-alkali pretreatment was observed to reduce the formation of recalcitrant compounds (HMF, Furfural) and increase the buffering capacity of the slurry over hydrothermal pretreatment. Principal component analysis (PCA) of the various pretreatment and AD operational parameters was carried out to study their in-depth correlation. Moreover, a kinetic study of the experimental data was performed to observe the biodegradation trend and compare it with the Modified Gompertz (MG) and First Order (FO) models.
Asunto(s)
Biocombustibles , Triticum , Triticum/química , Anaerobiosis , Álcalis , Metano , Hidróxido de Sodio , DigestiónRESUMEN
In this study, four batch assays were performed to ensure the synergic effects of co-digestion and find out the best inoculums to substrate ratio (ISR), carbon to nitrogen ratio (C:N), and total solid (TS) percentage in sequence. The co-digestion of three feedstocks had a 20% higher biogas yield (416 mL/gVS added) than mono-digestion with 21% volatile solids (VS) degradation. The ISR of 2 leads to the highest biogas yield (431 mL/gVS added) and VS removal (30.3%) over other ISRs (0.5, 1.0, 2.5) studied. The lower ISR (<2) tended to have lower pH due to insufficient anaerobes inside the digester. The C:N 35 (with ISR 2) yielded 17.4% higher biogas (443.5 mL/gVS added) than mono-digestion and was the highest among the C:N ratios studied with 36.6% VS removal. The VFA, alkalinity, and pH in C:N 35 assay were more stable than in other C:N assays. In the fourth batch assay, varying TS% (5, 7.5, 10, 12.5) were used with optimized ISR (2) and C:N (35). Higher TS% (10 and 12.5) had some lag phase but later achieved higher biogas production. The 12.5% TS assay achieved 80% higher biogas yield (679 mL/gVS added) over mono-digestion, i.e., highest among the TS% studied, with 48% VS removal. In conclusion, co-digestion of mixed feedstocks with ISR 2, C:N 35, and TS 12.5% could degrade almost half of the substrate available for biodegradation. Further biodegradation may require pretreatment of the recalcitrant WS. Modified Gompertz, first-order, transference, and logistic models were used for kinetic study and curve fitting of experimental data. For the optimized batch assays, the estimated specific rate constants were 0.08, 0.12, 0.083, and 0.084. The data fits well in all the models, with the coefficient of discrimination (R2) ranging from 0.882 to 0.999.