RESUMEN
Background: This report describes two original echocardiographic approaches to measure right ventricular (RV) mass (RVM).Methods: In the bullet formula (5/24 D1 D2 L), where D1 and D2 are short axes and L the log axis, the RVM is obtained by subtracting the cavity volume from the RV total volume and subsequently multiplying the difference by myocardium density. The second method uses 3 endocardium segments measured at: (1) short axis plane of the aortic valve and left atrium (b1); (2) short axis plane at the midpoint between the tricuspid valve annulus and the apex (b2); and (3) 4-chamber view (h). Thosesegment lengths are applying in the formula A [(b1 b2)/2] h. The result is multiplied by the wallthickness and by myocardium density. Results: Both formulas were primarily tested in 30 mongrel dogs and have shown good correlation with the true mass (r 0.869 with the segments formula and r 0.819 with the bullet formula). The same method was used in 20 human patients before heart transplant with similar results (r 0.810 with the segments formula and r 0.836 with the bulletformula).Conclusions: The RVM can be satisfactorily estimated by 2-dimensional echocardiography. The linear regression between the calculated mass (using the smoothest and thinner myocardium thickness) and the actual mass may provide the correction factor for the RVM calculation.Two echocardiographic methods were used to measure right ventricular mass. One of them used a bullet formula variant (5/24 D1 D2 L). The second method used 3 endocardium segments measured in 3 2-dimensional echocardiographic planes (short axis of aortic valve and left ventricle, and 4-chamber view), and applied in the formula A [(b1 b2)/2] h. Both formulas have shown good correlation with the true mass in 30 mongrel dogs (r 0.869 with the segments formula and r 0.819 with thebullet formula) and in 20 human patients before heart transplant (r 0.810 and r 0.836, respectively).