RESUMEN
A systematic study is reported on the physicochemical characteristics of two branched chain polymers (based on a poly-L-lysine backbone) with a general formula poly[Lys-(DL-Alam-Xi)], where X = Orn (OAK) or N-acetyl-Glu (Ac-EAK) and m approximately equal to 3, using surface pressure and fluorescence polarization methods. These data are compared with those of the linear poly(L-Lys) from which OAK and Ac-EAK are derived. These two polymers show a moderate surface activity, able to form stable monomolecular layers at the air-water interface. Poly(L-Lys), the most hydrophilic, has the lowest surface activity. The interaction of these polymers with phospholipid bilayers either neutral or negatively charged was studied with vesicles labeled with two fluorescent probes: ANS and DPH. Results indicate that these polymers are able to accommodate in their internal structure, mainly through electrostatic interactions, a certain amount of ANS marker molecules, but fluorescence increases of the ANS-polypeptide complexes were so low that its influence in further polarization measurements could be discarded. After interaction with liposomes, these polymers induce an increase in the polarization of the probes, thus indicating a rigidification of the bilayers. Electrostatic forces seem to be very important in this interaction; cationic polymers are clearly more active, with PG-containing liposomes, than Ac-EAK. Moreover, in these assays poly(L-Lys) behaves as the more active compound. This fact is probably due to its major ability to form alpha-helical structures that could insert easily in the bilayers. These results indicate that the polymeric structures studied can be used as carriers for biologically active molecules, because their interactions with bilayers remain soft and have a positive effect on the stability of the membranes.
Asunto(s)
Péptidos/química , Polilisina/análogos & derivados , Polarización de Fluorescencia , Membrana Dobles de Lípidos/química , Fosfolípidos/química , Presión , Propiedades de SuperficieRESUMEN
This report provides a detailed analysis on the influence of phosholipid bilayers on the conformation of poly[Lys(X(i)-DL-Ala(m))] (XAK, where X = Ser, Orn, Glu, or AcGlu) type branched polypeptides and their peptide conjugates. CD spectra of polycationic (SAK, OAK), amphoteric (EAK), or polyanionic (Ac-EAK) polylysine derivatives were recorded in 0.25M acetate buffer at pH 7.4 as well as in the presence of DPPC or DPPC/PG (95/5, 80/20 mol/mol) liposomes. Based on these data, two groups of polypeptides are described. Group one contains polypeptides with significantly ordered conformation even in buffer solution (SAK, AcEAK), which is essentially not altered by phospholipids. Group two, branched polypeptides (OAK, EAK), with only partially ordered conformation in aqueous solution in the presence of phospholipid bilayers with high PG content, could adopt more (EAK) or less (OAK) ordered alpha-helical structure depending on their charge properties. In addition, we report on the synthesis of two new sets of oligopeptide-branched polypeptide conjugates. Studies with selected conjugates suggest that these compounds are highly ordered in buffer solution almost regardless from the helix-forming ability of the carrier (AK, SAK, EAK) and from the hydrophilic/hydrophobic character of peptides attached (AVKDEL vs FWRGDLVFDFQV). Addition of phospholipid bilayers with different composition essentially had no modifying effect on conformation of conjugates. From this we can conclude that the covalently coupled oligopeptides has a predominant effect of the conformational properties of conjugates.
Asunto(s)
Péptidos/química , Secuencia de Aminoácidos , Dicroismo Circular , Membrana Dobles de Lípidos/química , Fosfolípidos/química , Conformación Proteica , SolucionesRESUMEN
In this communication we describe a novel procedure for the preparation and purification of diethylenetriaminepentaacetic (DTPA)-acylated and (115)In(3+)-labeled oligopeptides using 8-hydroxyquinoline for the removal and quantification of nonbound indium ions. First the N(alpha)- or N(alpha),N(epsilon)-DTPA oligopeptides containing C-terminal KDEL signal motif were produced by solid-phase synthesis. For this the free carboxyl group of DTPA dianhydride was activated in situ for a short period of time yielding a major product. Reversed-phase HPLC-purified DTPA oligopeptides were labeled with (115)In(3+) in aqueous buffer solution at pH 3.8. For the removal as well as for the detection of uncoordinated (115)In(3+) ions we have utilized the (115)In(3+) complex-forming ability of 8-hydroxyquinoline in chloroform. Following an optimized extraction procedure the free indium ion content was measured by spectrophotometry in the organic phase. Data obtained by this method and verified by total-reflection X-ray fluorescence spectroscopy and thin-layer chromatography demonstrated that free (115)In(3+) could be efficiently removed and sensitively detected in the presence of DTPA oligopeptide chelator. No release of (115)In(3+) from its DTPA complex was observed. This method could be useful for the preparation of indium complexes of peptides and perhaps proteins containing a DTPA moiety and nonradioactive isotope ligand.
Asunto(s)
Indio , Marcaje Isotópico/métodos , Oligopéptidos/síntesis química , Oxiquinolina/química , Ácido Pentético/síntesis química , Tampones (Química) , Cromatografía Líquida de Alta Presión , Cromatografía en Capa Delgada , Oligopéptidos/aislamiento & purificación , Ácido Pentético/aislamiento & purificación , Control de Calidad , Sensibilidad y Especificidad , Espectrometría por Rayos X , Factores de TiempoRESUMEN
To establish correlation between structural properties (charge, composition, and conformation) and membrane penetration capability, the interaction of epitope peptide-carrier constructs with phospholipid model membranes was studied. For this we have conjugated a linear epitope peptide, (110)FWRGDLVFDFQV(121) (110-121), from VP3 capside protein of the Hepatitis A virus with polylysine-based branched polypeptides with different chemical characteristics. The epitope peptide elongated by one Cys residue at the N-terminal [C(110-121)] was attached to poly[Lys-(DL-Ala(m)()-X(i)())] (i < 1, m approximately 3), where x = ø(AK), Ser (SAK), or Glu (EAK) by the amide-thiol heterobifunctional reagent, 3-(2-pyridyldithio)propionic acid N-hydroxy-succinimide ester. The interaction of these polymer-[C(110-121)] conjugates with phospholipid monolayers and bilayers was studied using DPPC and DPPC/PG (95/5 mol/mol) mixture. Changes in the fluidity of liposomes induced by these conjugates were detected by using two fluorescent probes 1,6-diphenyl-1,3, 5-hexatriene (DPH) and sodium anilino naphthalene sulfonate (ANS). The binding of conjugates to the model membranes was compared and the contribution of the polymer component to these interactions were evaluated. We found that conjugates with polyanionic/EAK-[C(110-121)] or polycationic/SAK-[C(110-121)], AK-[C(110-121)]/character were capable to form monomolecular layers at the air/water interface with structure dependent stability in the following order: EAK-[C(110-121)] > SAK-[C(110-121)] > AK-[C(110-121)]. Data obtained from penetration studies into phospholipid monolayers indicated that conjugate insertion is more pronounced for EAK-[C(110-121)] than for AK-[C(110-121)] or SAK-[C(110-121)]. Changes in the fluorescence intensity and in polarization of fluorescent probes either at the polar surface (ANS) or within the hydrophobic core (DPH) of the DPPC/PG liposomes suggested that all three conjugates interact with the outer surface of the bilayer. Marked penetration was documented by a significant increase of the transition temperature only with the polyanionic compound/EAK-[C(110-121)]. Taken together, we found that the binding/penetration of conjugates to phospholipid model membranes is dependent on the charge properties of the constructs. Considering that the orientation and number of VP3 epitope peptides attached to branched polypeptides were almost identical, we can conclude that the structural characteristics (amino acid composition, charge, and surface activity) of the carrier have a pronounced effect on the conjugate-phospholipid membrane interaction. These observations suggest that the selection of polymer carrier for epitope attachment might significantly influence the membrane activity of the conjugate and provide guidelines for adequate presentation of immunogenic peptides to the cells.
Asunto(s)
Proteínas de la Cápside , Cápside/química , Proteínas Portadoras/química , Epítopos/química , Hepatovirus/química , Inmunoconjugados/química , Fragmentos de Péptidos/química , Péptidos/química , Fosfolípidos/química , 1,2-Dipalmitoilfosfatidilcolina/química , 1,2-Dipalmitoilfosfatidilcolina/metabolismo , Secuencia de Aminoácidos , Naftalenosulfonatos de Anilina , Cápside/síntesis química , Cápside/inmunología , Cápside/metabolismo , Proteínas Portadoras/síntesis química , Proteínas Portadoras/metabolismo , Reactivos de Enlaces Cruzados/química , Disulfuros/química , Epítopos/metabolismo , Colorantes Fluorescentes , Hepatovirus/inmunología , Inmunoconjugados/metabolismo , Membrana Dobles de Lípidos/química , Membrana Dobles de Lípidos/metabolismo , Liposomas , Datos de Secuencia Molecular , Fragmentos de Péptidos/síntesis química , Fragmentos de Péptidos/inmunología , Fragmentos de Péptidos/metabolismo , Péptidos/metabolismo , Fosfolípidos/metabolismo , Propiedades de SuperficieRESUMEN
A series of succinate-derived hydroxamic acids incorporating a macrocyclic ring were designed, synthesized, and evaluated as inhibitors of matrix metalloproteinases. The inhibitors were designed based on the published X-ray crystal structure of batimastat (1) complexed with human neutrophil collagenase (MMP-8). The synthesized compounds were shown to inhibit selected MMPs in vitro with low nanomolar potency.