RESUMEN
Through various studies on thermoelectric (TE) materials, thin film configuration gives superior advantages over conventional bulk TEs, including adaptability to curved and flexible substrates. Several different thin film deposition methods have been explored, yet magnetron sputtering is still favorable due to its high deposition efficiency and scalability. Therefore, this study aims to fabricate a bismuth telluride (Bi2Te3) and antimony telluride (Sb2Te3) thin film via the radio frequency (RF) magnetron sputtering method. The thin films were deposited on soda lime glass substrates at ambient temperature. The substrates were first washed using water and soap, ultrasonically cleaned with methanol, acetone, ethanol, and deionized water for 10 min, dried with nitrogen gas and hot plate, and finally treated under UV ozone for 10 min to remove residues before the coating process. A sputter target of Bi2Te3 and Sb2Te3 with Argon gas was used, and pre-sputtering was done to clean the target's surface. Then, a few clean substrates were loaded into the sputtering chamber, and the chamber was vacuumed until the pressure reached 2 x 10-5 Torr. The thin films were deposited for 60 min with Argon flow of 4 sccm and RF power at 75 W and 30 W for Bi2Te3 and Sb2Te3, respectively. This method resulted in highly uniform n-type Bi2Te3 and p-type Sb2Te3 thin films.
Asunto(s)
Antimonio , Bismuto , Telurio , Bismuto/química , Antimonio/química , Telurio/química , Ondas de RadioRESUMEN
Uric acid is a waste product of the human body where high levels of it or hyperuricemia can lead to gout, kidney disease and other health issues. In this paper, Finite Difference Time Doman (FDTD) simulation method was used to develop a plasmonic optical sensor to detect uric acid with molarity ranging from 0 to 3.0 mM. A hybrid layer of gold-zinc oxide (Au-ZnO) was used in this Kretschmann-based Surface Plasmon Resonance (K-SPR) technique with angular interrogation at 670 nm and 785 nm visible optical wavelengths. The purpose of this study is to observe the ability of the hybrid material as a sensing performance enhancer for differentiating between healthy and unhealthy uric acid levels based on the refractive index values from previous study. Upon exposure to 670 nm wavelength, the average sensitivity of this sensor was found to be 0.028°/mM with a linearity of 98.67 % and Q-factor value of 0.0053 mM-1. While at 785 nm, the average sensitivity is equal to 0.0193°/mM with slightly lower linearity at 94.46 % and Q-factor value of 0.0076 mM-1. The results have proven the ability of hybrid material Au-ZnO as a sensing performance enhancer for detecting uric acid when compared with bare Au and can be further explored in experimental work.