RESUMEN
Organic amendments are important sources of nitrous oxide (N2O) emissions from agricultural soils. In 2020, the total amount of N in organic amendments applied to Japanese agricultural soils (440 ktN) was larger than that of synthetic fertilizer (374 ktN). However, N2O emissions from organic amendments were estimated by using the country-specific N2O emission factor (EF) for synthetic fertilizer (0.31 % for rice paddy, 2.9 % for tea, and 0.62 % for other crops) in the National Greenhouse Gas Inventory Report of Japan. Thus, we conducted a N2O flux measurement campaign at 12 different experimental sites across Japan to estimate fertilizer-induced N2O EFs for major organic amendments in Japan, that is, poultry manure compost, swine manure compost, cattle manure compost, and organic fertilizer pellets. In addition, we conducted systematic review of N2O emissions and EFs for organic amendments, including data from our measurement campaign and published data from peer-reviewed papers in Japan. The final dataset, including the field measurement campaign and published data, resulted in 404 observations (including synthetic fertilizer and zero-N control) in 29 sites. Results showed that soil type affected EFs, that is, the mean EF of Andosols was lower than that of non-Andosols, which is similar to the case of EFs for synthetic fertilizer. Mean EFs for poultry manure compost, swine manure compost, cattle manure (compost and slurry), and non-animal manure organic fertilizers were 0.83 % (uncertainty range of 2.5th and 97.5th percentile: 0.09 % to 3.46 %), 0.70 % (0.02 % to 2.45 %), 0.39 % (0.00 % to 1.62 %), and 1.16 % (0.41 % to 3.03 %), respectively, when weighted by area of soil types. The mean EF of all organic amendments was 0.84 % (0.00 % to 2.91 %), when the area of soil type and amount of organic amendment used in Japan were considered. Our study provides country-specific EFs to estimate N2O emission from organic amendments in Japan.
RESUMEN
A hybrid NiCrAl pressure cell was fabricated to measure magnetic quantities under high pressure above 3 GPa. A pressure of 4.0 GPa was achieved and the pressure cell was found to be reusable even after a pressurizing trial up to 4.0 GPa. Pressure was monitored using (63)Cu nuclear quadrupole resonance of Cu(2)O and ruby fluorescence. The pressure efficiency of a fresh cell was maintained at 96%, and no appreciable deformation was observed at pressures below 3 GPa; on the other hand, the efficiency after pressurizing trials decreased gradually and reached 75% at 4 GPa accompanied by a maximum expansion inside the cylinder of 2%.
Asunto(s)
Aleaciones de Cromo/química , Manometría/instrumentación , Estimulación Física/instrumentación , Manejo de Especímenes/instrumentación , Transductores , Diseño de Equipo , Análisis de Falla de Equipo , Manometría/métodos , Estimulación Física/métodos , Presión , Reproducibilidad de los Resultados , Sensibilidad y Especificidad , Manejo de Especímenes/métodosRESUMEN
Pressure-induced superconductivity in a spin-ladder cuprate Sr2Ca12Cu24O41 has not been studied on a microscopic level thus far although the superconductivity was already discovered in 1996. We have improved the high-pressure technique using a large high-quality crystal, and succeeded in studying the superconductivity using 63Cu nuclear magnetic resonance. We found that the anomalous metallic state reflecting the spin-ladder structure is realized and the superconductivity possesses an s-wave-like character in the meaning that a finite gap exists in the quasiparticle excitation: At a pressure of 3.5 GPa, we observed two excitation modes in the normal state from the relaxation rate T-11. One gives rise to an activation-type component in T-11, and the other T-linear component linking directly with the superconductivity. This gapless mode likely arises from free motion of holon-spinon bound states appearing by hole doping, and the pairing of them likely causes the superconductivity.