RESUMEN

BACKGROUND: The use of postoperative MRI to assess the healing status of repaired menisci is a long-standing issue. This study evaluates and compares functional and MRI outcomes following an arthroscopic meniscus repair procedure with the aim of postoperative MRI diagnostic accuracy clarification in young patients. METHODS: A total of 35 patients under 18 years old who underwent isolated meniscus repair were included. The Pedi-IKDC score, Lysholm score, and Tegner activity index (TAS) were compared between the groups formed according to the Stroller and Crues three-grade classification of postoperative MRI-based evaluations. Grade 3 MRI views were classified as unhealed, grade 2 as partially healed, and grade 1 as fully healed within the repaired meniscus, whereas grade 3 cases were considered unsuccessful due to MRI evaluation. RESULTS: MRI assessment revealed 4 cases of grade 1 (11.4%), 14 cases of grade 2 (40.8%), and 17 cases of grade 3 (48.0%) lesions. Pedi-IKDC and TAS scores were significantly higher among MRI grade 2 patients than among MRI grade 3 patients (p < 0.05). Weak negative correlations between MRI grades and all functional scales were found (p < 0.05). ROC analysis showed that Pedi-IKDC and TAS scores could correctly classify 77% and 71% of MRI grade 3 patients, respectively. The optimal cut-off values to detect grade 3 patients were 88.74 for the Pedi-IKDC score and 4.5 for the TAS score. CONCLUSIONS: To conclude, established functional score cut-off values may help identify unhealed meniscus repair patients.

RESUMEN

INTRODUCTION: The selection of an appropriate PROM is a crucial aspect in assessing outcomes. Questionnaires that have not been designed or validated for a paediatric population are routinely used. Using a questionnaire requires translation, cultural adaptation, and testing the psychometric properties of the translated questionnaire. There is no applicable questionnaire in our country for children with knee-specific conditions in sports orthopaedics. Therefore, this study aims to translate, culturally adapt, and assess the psychometric properties of the Paediatric IKDC (Pedi-IKDC) questionnaire within the Lithuanian paediatric population. METHODS: The translation was conducted in accordance with international standards. Patients aged 11-17 years with various knee disorders participated in three surveys and completed the Pedi-IKDC, Lysholm, and PedsQL questionnaires. Interviews with patients following the translation process, in addition to floor and ceiling effects, were used to assess content validity. Cronbach alpha (α) statistics and the intraclass correlation coefficient (ICC) were applied to measure internal consistency and reproducibility, respectively. The standard error of measurement (SEM) and smallest detectable change (SDC) were calculated to assess reliability. Pearson correlations were calculated between Pedi-IKDC and Lysholm PedsQL scores to determine criteria validity. The effect size (ES) and standardised response mean (SRM) were calculated to assess the responsiveness to change. RESULTS: Cronbach's alpha (α) was 0.91 for the total score, 0.75 for symptoms, and 0.92 for the sport/function component. The ICC for overall scores was 0.98, with each question ranging from 0.87 to 0.98. The SEM was 2.97, and the SDC was 8.23. Lysholm and PedsQL physical functioning domain scores had moderate correlations (0.8 > r > 0.5), and the overall PedsQL score had a weak correlation (0.5 > r > 0.2) to the Pedi-IKDC score. The floor and ceiling effects were 3.3% and 1.6%, respectively. The SRM was 1.72 and the ES was 1.98. CONCLUSIONS: The Lithuanian Pedi-IKDC version is an appropriate evaluation instrument for assessing outcomes in children with knee disorders. All of the psychometric features produced acceptable results.

RESUMEN

PURPOSE: 3D-printed models rapidly evolving in orthopaedic. Studies show that 3D-printed models used for preoperative planning improve a better understanding of fracture morphology and reduce operative time, blood loss and frequency of fluoroscopy, but there are no studies that investigated possible advantages in the outcomes and complications for the treatment of distal radius fracture (DRF). Our study aims to evaluate short-term functional results and complications between two groups treated DRF using 3D-printed models for preoperative planning and without. We hypothesize that the addition of 3D-printed models would improve functional outcomes and reduce complication rates. METHODS: 66 randomized cases of DRF AO/OTA C type were enrolled and divided into "Control group" (n = 33) and "3D-printed model group" (n = 33). Personalized 3D-printed models were created. The primary outcomes were: Patient-Rated Wrist Evaluation questionnaire, Quick Disabilities of the Arm, Shoulder and Hand Score questionnaire, and complications. The secondary outcomes were: measurement of the range of motions, grip strength, radiological evaluation, and the visual analogue scale. Assessments were measured at 6 weeks, 3 months, and 6 months intervals. RESULTS: We found that the integration of the 3D-printed model in preoperative planning decreased complication incidence significantly - from 30.3% in the "Control group" to 6.1% in the "3D-printed model group", p = .022. But we did not find a difference in functional and radiological outcomes. CONCLUSION: The 3D-printed models for preoperative planning surgically treating DRF AO/OTA C type can help minimize the complication rate, however, they can't improve functional outcomes in the short-term results. LEVEL OF EVIDENCE: Level I randomized controlled study.

Asunto(s)

RESUMEN

OBJECTIVE: This study aimed to compare inter- and intra-observer agreement between radiographs with 2-dimensional and 3-dimensional computed tomography scans with and without 3-dimensional printed models in the evaluation of the distal radius fracture of Association for Osteo synth esis/ Ortho paedi c Trauma Association type C classification. METHODS: Fifteen consecutive cases with X-Rays, 2-dimensional and 3-dimensional computed tomography reconstructions views, and 3-dimensional printed models were selected. Three-dimensional printed models of the distal radius fractures were created using 2-dimensional computed tomography scan files in Digital Imaging and Communication in Medicine format, processed with the 3-dimensional Slicer software, and segmented, creating a 3-dimensional printed model in Standard Triangle Language format. Threedimensional models were printed using fused deposition modeling (FDM) type 3D printer Zortrax M200Plus using polylactic acid material on a scale of 1 : 1. Twenty observers were invited into the study. RESULTS: Intra- and inter-observer reliability was analyzed using Fleiss' kappa statistics. Overall kappa values for both groups in interobserver agreement range from 0.113 to 0.283 and in intra-observer agreement from 0.25 to 0.545. Generally, inter-observer agreement increased with additional 3-dimensional printed models from slight to fair, and intra-observer agreement increased from fair to moderate. Surgeons' opinions about 3-dimensional printed models with Likert scale-type questions show positive overall results ranging from 8.3± 2.1 to 8.6 ± 1.4. CONCLUSION: This study has shown that the inter- and intra-observer agreement with the addition of a 3-dimensional printed model for the evaluation of the distal radius fractures of Association For Osteo synth esis/ Ortho pedic Trauma Association C type for classification, fractures morphology, and preoperative planning tends to increase; however, improvements for an inter-observer agreement remain fair. LEVEL OF EVIDENCE: Level III Diagnostic Study.

Asunto(s)

Asunto(s)

RESUMEN

BACKGROUND: The optimal treatment of acute Achilles tendon ruptures (AATR) is still under debate. The purpose of this study was to evaluate outcomes of open repair comparing with percutaneous procedure for AATR. METHODS: 100 patients with AATR were randomized in two groups: open "crown" type (group A) and percutaneous Bunnell type repair (group B). 87 patients were available for the mean follow up of 27months RESULTS: No statistically significant difference was observed between groups in ATRS score, leg circumference, single heel rise, Achilles resting angle, time back to work and sports and overall patient satisfaction. Percutaneous technique was much faster. Overall 13 complications occurred in both groups (5 and 8 respectively). No deep infection occurred, no revisions were needed. CONCLUSIONS: Both techniques showed to be effective and safe when using absorbable suture material with a high patient satisfaction and a low complication rate, but percutaneous repair was significantly faster.

Asunto(s)