RESUMEN

The paper presents the preparation of new adsorbents based on silica gel (SiO2) impregnated with deep eutectic solvents (DESs) to increase benzene, toluene, ethylbenzene, and p-xylene (BTEX) adsorption efficiency from gas streams. The DESs were synthesized by means of choline chloride, tetrapropylammonium bromide, levulinic acid, lactic acid, and phenol. The physico-chemical properties of new sorbent materials, including surface morphology and structures, as well as porosity, were studied by means of thermogravimetric analysis, Fourier transform infrared spectroscopy, scanning electron microscopy, X-ray diffraction, and Brunauer-Emmett-Teller analysis. The effect of DESs type, flow rate, and initial concentration of BTEX were also investigated followed by regeneration and reusability of adsorbents. The results indicate that SiO2 impregnated with tetrapropylammonium bromide and lactic acid in a 1:2 molar ratio have great potential for the removal of BTEX from gas streams. Its adsorption capacity was higher than the pure SiO2 and other developed SiO2-DES adsorbents. This result can be explained by the specific interaction between DESs and BTEX, i.e., hydrogen bonds interaction.

RESUMEN

The paper is a review of the procedures for the determination of volatile and semivolatile oxygenated organic compounds (O-VOCs) in effluent samples by gas chromatography. Current trends and outlook for individual steps of the procedure for the determination of O-VOCs in effluents are discussed. The available sample preparation techniques and their limitations are described along with GC capillary columns used for O-VOCs separation and selective and universal detectors used for their determination. The results of determination of O-VOC content in various types of real effluents are presented. The lack of legal regulations regarding the presence of the majority of O-VOCs is pointed out as well as the availability of just a few procedures allowing a comprehensive evaluation of the O-VOC content in effluents.

Asunto(s)

RESUMEN

The paper presents novel nonionic and hydrophobic deep eutectic solvents which were synthesized from natural compounds, i.e., thymol, ±camphor, decanoic and 10-undecylenic acids. Fundamental physicochemical properties of the synthesized deep eutectic solvents were determined, followed by their application as extractants in ultrasound-assisted dispersive liquid-liquid microextraction to isolate and enrich polycyclic aromatic hydrocarbons from aqueous samples characterized by a complex matrix. The final determination was carried out by gas chromatography-mass spectrometry. The most important extraction parameters were optimized and the procedure was validated. The developed procedure is characterized by low limits of detection and quantitation, equal to 0.0039-0.0098 µg/L and 0.012-0.029 µg/L, respectively, good precision (RSD <6.09%), analyte recovery ranging from 73.5 to 126.2%, and a wide linear range. The procedure was applied to analysis of industrial effluents from the production of bitumens before and after treatment by advanced oxidation processes. A total of 16 PAHs at concentrations ranging from 0.12 to 46.2 µg/L were identified and determined.

Asunto(s)

RESUMEN

The paper presents a new procedure for the determination of organic acids in a complex aqueous matrix using ultrasound-assisted dispersive liquid-liquid microextraction followed by injection port derivatization and GC-MS analysis. A deep eutectic solvent (choline chloride: 4-methylphenol in a 1:2 mol ratio) was used both as an extracting solvent and as a derivatizing agent to yield ion pairs which were next converted to methyl esters of organic acids in a hot GC injection port. The procedure was optimized in terms of selection of a deep eutectic solvent, disperser solvent, and the ratio of their volumes, pH, salting out effect, extraction time, injection port temperature and time of opening the split valve. The developed procedure is characterized by low LOD (1.7-8.3 µg/L) and LOQ (5.1-25 µg/L) values, good repeatability (RSD ranging from 4.0 to 6.7%), good recoveries for most of the studied analyte (81,5-106%) and a wide linear range. The procedure was used for the determination of carboxylic acids in real effluents from the production of petroleum bitumens. A total of ten analytes at concentrations ranging from 0.33 to 43.3 µg/mL were identified and determined in the effluents before and after chemical treatment. The study revealed that in effluents treated by hydrodynamic cavitation an increase in concentration of benzoic acid and related compounds was observed.

Asunto(s)

RESUMEN

We present a new method for simultaneous determination of 22 monoaromatic and polycyclic aromatic hydrocarbons in postoxidative effluents from the production of petroleum bitumen using dispersive liquid-liquid microextraction coupled to gas chromatography and mass spectrometry. The eight extraction parameters including the type and volume of extraction and disperser solvent, pH, salting out effect, extraction, and centrifugation time were optimized. The low detection limit ranging from 0.36 to 28 µg/L, limit of quantitation (1.1-84 µg/L), good reproducibility, and wide linear ranges, as well as the recoveries ranging from 71.74 to 114.67% revealed that the new method allows the determination of aromatic hydrocarbons at low concentration levels in industrial effluents having a very complex composition. The developed method was applied to the determination of content of mono- and polycyclic aromatic hydrocarbons in samples of raw postoxidative effluents in which 15 compounds were identified at concentrations ranging from 1.21 to 1017.0 µg/L as well as in effluents after chemical treatment.

RESUMEN

The paper presents a new method for the determination of 15 carboxylic acids in samples of postoxidative effluents from the production of petroleum bitumens using ion-pair dispersive liquid-liquid microextraction and gas chromatography coupled to mass spectrometry with injection port derivatization. Several parameters related to the extraction and derivatization efficiency were optimized. Under optimized experimental conditions, the obtained limit of detection and quantification ranged from 0.0069 to 1.12µg/mL and 0.014 to 2.24µg/mL, respectively. The precision (RSD ranged 1.29-6.42%) and recovery (69.43-125.79%) were satisfactory. Nine carboxylic acids at concentrations ranging from 0.10µg/mL to 15.06µg/mL were determined in the raw wastewater and in samples of effluents treated by various oxidation methods. The studies revealed a substantial increase of concentration of benzoic acids, in samples of wastewater after treatment, which confirms the need of carboxylic acids monitoring during industrial effluent treatment processes.

Asunto(s)

RESUMEN

We present a new procedure for the determination of 32 volatile organonitrogen compounds in samples of industrial effluents with a complex matrix. The procedure, based on dispersive liquid-liquid microextraction followed by gas chromatography with nitrogen-phosphorus and mass spectrometric detection, was optimized and validated. Optimization of the extraction included the type of extraction and disperser solvent, disperser solvent volume, pH, salting out effect, extraction, and centrifugation time. The procedure based on nitrogen-phosphorus detection was found to be superior, having lower limits of detection (0.0067-2.29 µg/mL) and quantitation as well as a wider linear range. The developed procedure was applied to the determination of content of volatile organonitrogen compounds in samples of raw effluents from the production of bitumens in which 13 compounds were identified at concentrations ranging from 0.15 to 10.86 µg/mL and in samples of effluents treated by various chemical methods.

RESUMEN

We present a new procedure for the determination of volatile organosulfur compounds in samples of industrial effluents using dispersive liquid-liquid microextraction and gas chromatography with flame photometric detection. Initially, the extraction parameters were optimized. These included: type and volume of extraction solvent, volume of disperser solvent, salting out effect, pH, time and speed of centrifugation as well as extraction time. The procedure was validated for 30 compounds. The developed procedure has low detection limits of 0.0071-0.49 µg/L and a good precision (relative standard deviation values of 1.2-5.0 and 0.6-4.1% at concentrations of 1 and 10 µg/L, respectively). The procedure was used to determine the content of volatile organosulfur compounds in samples of effluents from the production of bitumens before and after chemical treatment, in which six compounds were identified, including 2-mercaptoethanol, thiophenol, thioanisole, dipropyl disulfide, 1-decanethiol, and phenyl isothiocyanate at concentrations ranging from 0.47 to 8.89 µg/L. Problems in the determination of organosulfur compounds related to considerable changes in composition of the effluents, increase in concentration of individual compounds and appearance of secondary pollutants during effluent treatment processes are also discussed.

RESUMEN

We present a new procedure for the determination of oxygenated volatile organic compounds in samples of postoxidative effluents from the production of petroleum bitumens using dispersive liquid-liquid microextraction and gas chromatography with mass spectrometry. The eight extraction parameters were optimized for 43 oxygenated volatile organic compounds. The detection limits obtained ranged from 0.07 to 0.82 µg/mL for most of the analytes, the precision was good (relative standard deviation below 2.91% at the 5 µg/mL level and 4.75% at the limit of quantification), the recoveries for the majority of compounds varied from 70.6 to 118.9%, and the linear range was wide, which demonstrates the usefulness of the procedure. The developed procedure was used for the determination of oxygenated volatile organic compounds in samples of raw postoxidative effluents and in effluents after chemical treatment. In total, 23 compounds at concentration levels from 0.37 to 32.95 µg/mL were identified in real samples. The same samples were also analyzed in the SCAN mode, which resulted in four more phenol derivatives being identified and tentatively determined. The studies demonstrated the need for monitoring volatile organic compounds content in effluents following various treatments due to the formation of secondary oxygenated volatile organic compounds.