RESUMEN
Triboelectric nanogenerator (TENG) represents an effective approach for the conversion of mechanical energy into electrical energy and has been explored to combine multiple technologies in past years. Self-powered sensors are not only free from the constraints of mechanical energy in the environment but also capable of efficiently harvesting ambient energy to sustain continuous operation. In this review, the remarkable development of TENG-based human body sensing achieved in recent years is presented, with a specific focus on human health sensing solutions, such as body motion and physiological signal detection. The movements originating from different parts of the body, such as body, touch, sound, and eyes, are systematically classified, and a thorough review of sensor structures and materials is conducted. Physiological signal sensors are categorized into non-implantable and implantable biomedical sensors for discussion. Suggestions for future applications of TENG-based biomedical sensors are also indicated, highlighting the associated challenges.
RESUMEN
With the continuously growing demand for wide-range applications, lithium-ion batteries (LIBs) are increasingly required to work under conditions that deviate from room temperature (RT). However, commercial electrolytes exhibit low thermal stability at high temperatures (HT) and poor dynamic properties at low temperatures (LT), hindering the operation of LIBs under extreme conditions. The bottleneck restricting the practical applications of LIBs has promoted researchers to pay more attention to developing a series of innovative electrolytes. This review primarily covers the design of electrolytes for LIBs from a temperature adaptability perspective. First, the fundamentals of electrolytes concerning temperature, including donor number (DN), dielectric constant, viscosity, conductivity, ionic transport, and theoretical calculations are elaborated. Second, prototypical examples, such as lithium salts, solvent structures, additives, and interfacial layers in both liquid and solid electrolytes, are presented to explain how these factors can affect the electrochemical behavior of LIBs at high or low temperatures. Meanwhile, the principles and limitations of electrolyte design are discussed under the corresponding temperature conditions. Finally, a summary and outlook regarding electrolytes design to extend the temperature adaptability of LIBs are proposed.
RESUMEN
Constructing an inorganic-rich and robust solid electrolyte interphase (SEI) is one of the crucial approaches to improving the electrochemical performance of sodium metal batteries (SMBs). However, the low conductivity and distribution of common inorganics in SEI disturb Na+ diffusion and induce nonuniform sodium deposition. Here, we construct a unique SEI with evenly scattered high-conductivity inorganics by introducing a self-sacrifice LiTFSI into the sodium salt-base carbonate electrolyte. The reductive competition effect between LiTFSI and FEC facilitates the formation of the SEI with evenly scattered inorganics. In which the high-conductive Li3N and inorganics provide fast ions transport domains and high-flux nucleation sites for Na+, thus conducive to rapid sodium deposition at a high rate. Therefore, the SEI derived from LiTFSI and FEC enables the Naâ¥Na3V2(PO4)3 cell to show 89.15% capacity retention (87.62 mA h g-1) at an ultrahigh rate of 60 C after 10,000 cycles, while the cell without LiTFSI delivers only 48.44% capacity retention even after 8000 cycles. Moreover, the Naâ¥Na3V2(PO4)3 pouch cell with the special SEI presents a stable capacity retention of 92.05% at 10 C after 2000 cycles. This unique SEI design elucidates a new strategy to propel SMBs to operate under extreme high-rate conditions.
RESUMEN
Zinc-ion storage is a promising electrochemical energy field due to loads of its advantages like easy preparation, environmental friendliness, high safety performance, and high capacity. Carbon materials have been widely studied for zinc-ion storage due to their extraordinary properties such as earth-abundancy, low-cost, good electrical conductivity, various structures, and good stability. This article reviews some widely used carbon materials in zinc ion storage devices, including hollow carbon spheres, activated carbon, N-doped porous carbon, graphene, and carbon nanotubes. The unique roles and advantages of these carbon materials in both zinc ion supercapacitors and zinc ion batteries are emphasized. Characteristics and functionalizations of different carbon materials are also comparatively discussed in view of zinc-ion energy storage devices. Finally, some challenges and perspectives of carbon materials in zinc-ion energy storage are outlined.
RESUMEN
Mesophyll conductance (gm), the total conductance of CO2 diffusion from substomatal cavity to the site of carboxylation within chloroplast, is a major limiting factor for photosynthesis and a key parameter for improving photosynthetic resource use efficiency of crops. Online 13C discrimination method is an important method for plant eco-physiological studies and a well-established method for measuring gm of C3 plants, although it has not been widely used due to challenges in methodology and high demands on experimental facilities. In this review, we summarized the characteristics of commonly used methods for gm, introduced the basic theory of the online 13C discrimination method, namely Farquhar's photosynthetic 13C discrimination model; systematically introduced the practical measurements, equations and the components of facilities; and reviewed the drivers for variation in gm of C3 plants. At the last part, we discussed the outlook of the development of methodology, new experimental protocols, and applications in measurement scenarios.