RESUMEN

Incessant increases in vehicles and massive road networks lead to traffic-related problems and noise pollution. Road tunnels are considered a more feasible and effective solution for solving traffic problems. Compared to other traffic noise abatement strategies, road tunnels also offer enormous benefits to urban mass transit systems. However, the road tunnels that are non-complying with the design and safety standards negatively impact commuters' health of being exposed to the high noise level inside the tunnel, particularly for road tunnels above 500 m in length. The study aims to evaluate the applicability of the ASJ RTN-Model 2013 by validating predicted data with the measurement data at the tunnel portal. The study also investigates the acoustic characteristics of noise inside the tunnel by analysing octave frequencies to inspect the correlation of noise spectrum for noise-induced hearing loss (NIHL) and discussed the possible health effect on the pedestrian and vehicle riders passing through the tunnel. The result shows that people are exposed to a high noise level inside the tunnel. The equivalent sound pressure levels at different locations inside the tunnel along the length observed between 78.9 to 86.5 dB(A), which exceeded the CPCB, recommended permissible limits for road traffic noise. The locations L1, L5, L6 and L7 found higher sound pressure levels at 4 kHz and relates to NIHL. The observed average difference between the measurement and predicted LAeq value at the tunnel portal was 2.8 dB(A) which is highly acceptable and confirms the ASJ RTN-2013 prediction model applicability for predicting tunnel portal noise in the Indian road conditions. The study recommends complete restriction of honking inside the tunnel. Considering the commuter's safety perspective, the road tunnels above 500 m must have separate walk sides for pedestrians with a barrier.

Asunto(s)

RESUMEN

Strategic noise maps are typically prepared for large-scale areas, towns and cities. However, some comparatively smaller industries are given less importance during preparation of noise maps. Very few studies have been reported worldwide providing insight on industrial noise mapping, and similar reports from India are negligible. This study provides a noise map of a forging plant and also investigates noise distribution pattern within 2 km of surrounding area. The complete study is evaluated in two types of scenario; in the first scenario all individual noise sources of the plant were considered as point sources whereas in the second scenario complete plant was treated as an area source. Furthermore, a regression graph is generated between the predicted and measured values for both scenarios individually which gives coefficients of determination of 0.4689 and 0.6382. This study reveals that the second scenario provides more precise noise prediction map than the first scenario.

Asunto(s)

RESUMEN

The microalgae Scenedesmus abundans cultivated in five identical airlift photobioreactors (PBRs) in batch and fed-batch modes at the outdoor tropical condition. The microalgae strain S. abundans was found to tolerate high temperature (35-45 °C) and high light intensity (770-1690 µmol m- 2 s- 1). The highest biomass productivities were 152.5-162.5 mg L- 1 day- 1 for fed-batch strategy. The biomass productivity was drastically reduced due to photoinhibition effect at a culture temperature of > 45 °C. The lipid compositions showed fatty acids mainly in the form of saturated and monounsaturated fatty acids (> 80%) in all PBRs with Cetane number more than 51. The fed-batch strategies efficiently produced higher biomass and lipid productivities at harsh outdoor conditions. Furthermore, the microalgae also accumulated omega-3 fatty acid (C18:3) up to 14% (w/w) of total fatty acid at given outdoor condition.

Asunto(s)

RESUMEN

INTRODUCTION: In open-cast mines, noise pollution has become a serious concern due to the extreme use of heavy earth moving machinery (HEMM). MATERIALS AND METHODS: This study is focused to measure and assess the effects of the existing noise levels of major operational mines in the Keonjhar, Sundergadh, and Mayurbhanj districts of Odisha, India. The transportation noise levels were also considered in this study, which was predicted using the modified Federal Highway Administration (FHWA) model. RESULT AND DISCUSSION: It was observed that noise induced by HEMM such as rock breakers, jackhammers, dumpers, and excavators, blasting noise in the mining terrain, as well as associated transportation noise became a major source of annoyance to the habitants living in proximity to the mines. The noise produced by mechanized mining operations was observed between 74.3 and 115.2 dB(A), and its impact on residential areas was observed between 49.4 and 58.9 dB(A). In addition, the noise contour maps of sound level dispersion were demonstrated with the utilization of advanced noise prediction software tools for better understanding. CONCLUSION: Finally, the predicted values at residential zone and traffic noise are correlated with observed values, and the coefficient of determination, R2, was calculated to be 0.6891 and 0.5967, respectively.

Asunto(s)

RESUMEN

In the present study, feasibility of biomethanation of vegetable market waste in a 4-chambered anaerobic baffled reactor (ABR) was investigated at 30d hydraulic retention time and organic loading rate of 0.5gVS/L/d for one year. Indicators of process stability viz., butyrate/acetate and propionate/acetate ratios were consistent with phase separation in the different chambers, which remained unaltered even during recirculation of effluent. Chemical oxygen demand (COD) and volatile solids (VS) removal efficiencies were observed to be consistently high (above 90%). Corresponding biogas and methane yields of 0.7-0.8L/g VS added/d and 0.42-52L/g VS added/d respectively were among the highest reported in case of AD of vegetable waste in an ABR. Process efficiency of the ABR for vegetable waste methanation, which is indicated by carbon recovery factor showed that, nearly 96.7% of the input carbon considered for mass balance was accounted for in the product.

Asunto(s)

RESUMEN

The bacteria and their phages are the most abundant constituents of the aquatic environment, and so represent an ideal model for studying carbon regulation in an aquatic system. The microbe-mediated interconversion of bioavailable organic carbon (OC) into dissolved organic carbon (DOC) by the microbial carbon pump (MCP) has been suggested to have the potential to revolutionize our view of carbon sequestration. It is estimated that DOC is the largest pool of organic matter in the ocean and, though a major component of the global carbon cycle, its source is not yet well understood. A key element of the carbon cycle is the microbial conversion of DOC into inedible forms. The primary aim of this study is to understand the phage conversion from organic to inorganic carbon during phage-host interactions. Time studies of phage-host interactions under controlled conditions reveal their impact on the total carbon content of the samples and their interconversion of organic and inorganic carbon compared to control samples. A total organic carbon (TOC) analysis showed an increase in inorganic carbon content by 15-25 percent in samples with bacteria and phage compared to samples with bacteria alone. Compared to control samples, the increase in inorganic carbon content was 60-70-fold in samples with bacteria and phage, and 50-55-fold for samples with bacteria alone. This study indicates the potential impact of phages in regulating the carbon cycle of aquatic systems.

RESUMEN

We attempted catalytic wet air oxidation (CWAO) of nanofiltration (NF)-reject using Pd based catalyst viz., Pd/activated charcoal (AC) and PdCl2 with the objective of degradation of refractory organic pollutants. Refractory organic pollutants in NF-reject before and after WAO and CWAO were confirmed by GC-MS analysis. Experiments were conducted to investigate the effects of temperature, catalyst dosage and air partial pressure on the rate of removal of total organic carbon (TOC). The reaction kinetics can be conveniently described by considering two-stage first order kinetics. The use of Pd/AC afforded 85% TOC removal, the corresponding rate constant (k) was 2.90 ± 0.075 × 10(-3)min(-1) (Pd/AC, 100mg/L; T, 473.15K; Pair, 0.69 MPa). On the other hand, 75% TOC was removed with k=2.31 ± 0.075 × 10(-3)min(-1) using Pd(2+) catalyst (Pd(2+), 16.66 mg/L; T, 473.15K; Pair, 0.69 MPa). The observed rate of mineralization under Pd-catalyzed conditions was significantly higher than that of the uncatalyzed oxidation (41%) under the similar experimental conditions. Catalyst stability experiments were performed and TEM, SEM, XRD, Raman and XPS characterization data collected. Despite some morphological transformation of support, Pd catalyst was stable under CWAO conditions.

Asunto(s)

RESUMEN

The effects of various stresses on the suitability of lipid synthesized by Chlorella pyrenoidosa for biodiesel production were investigated. Lipids were characterized for detailed fatty acid methyl ester profiling and biodiesel properties like cetane number (CN), iodine value, cold filter plugging point (CFPP). Maximum biomass productivity (106.63 mgL(-1)d(-1)) and lipid content (29.68%) were obtained at indoor cultivation (nitrate sufficient, pH 8-10, 24h illumination). However, compared to this condition, other nitrate sufficient cultures [pH 6-8 and 10-12 (24h illumination), and at ambient CO2 and 16:8h light:dark photoperiod (pH unadjusted)] showed ∼12-14% lower lipid productivity. Upon 50% nitrate depletion (at indoor and outdoor; pH unadjusted) lipid content has increased by 7.62% and 17%, respectively. Though stress conditions helped enhancing lipid accumulation, there was two-fold increase in PUFA content compared to that observed at pH 8-10. This resulted in fuel properties which did not comply with the biodiesel standards.

Asunto(s)