RESUMEN
A compressive strain applied to bilayer films (e.g. thin film adhered to a thick substrate) can lead to buckled or wrinkled morphologies, which has many important applications in stretchable electronics, anti-counterfeit technology, and high-precision micro and nano-metrology. A number of buckling-based metrology methods have been developed to quantify the residual stress and viscoelastic properties of polymer thin films. However, in some systems (e.g. solvent-induced swelling or thermal strain), the compressive strain is unknown or difficult to measure. We present a quantitative method of measuring the compressive strain of wrinkled polymer films and coatings with knowledge of the "skin" thickness, wrinkle wavelength, and wrinkle amplitude. The derived analytical expression is validated with a well-studied model system, e.g., stiff, thin film (PS) bonded to a thick, compliant substrate (PDMS). After validation, we use our expression to quantify the applied swelling strain of previously reported wrinkled poly(styrene-alt-maleic anhydride) brush surfaces. Finally, the applied strain is used to rationalize the observed persistence length of aligned wrinkles created during atomic force microscopy (AFM) lithography and subsequent solvent exposure.
RESUMEN
Thiolactone chemistry has garnered significant attention as a powerful post-polymerization modification (PPM) route to mutlifunctional polymeric materials. Here, we apply this versatile chemistry to the fabrication of ultrathin, multifunctional polymer surfaces via aminolysis and thiol-mediated double modifications of thiolactone-containing polymer brushes. Polymer brush surfaces were synthesized via microwave-assisted surface-initiated polymerization of DL-homocysteine thiolactone acrylamide. Aminolysis and thiol-Michael double modifications of the thiolactone-functional brush were explored using both sequential and one-pot reactions with bromobenzyl amine and 1H,1H-perfluoro-N-decyl acrylate. X-ray photoelectron spectroscopy and argon gas cluster ion sputter depth profiling enabled quantitative comparison of the sequential and one-pot PPM routes with regard to conversion and spatial distribution of functional groups immobilized throughout thickness of the brush. While one-pot conditions proved to be more effective in immobilizing the amine and acrylate within the brush, the sequenital reaction enabled the fabrication of multifunctional, micropattterned brush surfaces using reactive microcontact printing.
RESUMEN
We report a simple route to engineer ultrathin polymer brush surfaces with wrinkled morphologies using post-polymerization modification (PPM), where the length scale of the buckled features can be tuned from hundreds of nanometers to one micrometer using PPM reaction time. We show that partial crosslinking of the outer layer of the polymer brush under poor solvent conditions is critical to obtain wrinkled morphologies upon swelling. Characterization of the PPM kinetics and swelling behavior via ellipsometry and the through-thickness composition profile via time-of-flight secondary ion mass spectroscopy (ToF-SIMS) provided keys insight into parameters influencing the buckling behavior.