RESUMEN
The manuscript presents experimental research carried out on the wing model with the SD 7003 profile. A plasma actuator with DBD (Dielectric Barrier Discharge) discharges was placed on the wing surface to control boundary layer. The experimental tests were carried out in the AeroLab wind tunnel where the forces acting on the wing during the tests were measured. The conducted experimental research concerns the analysis of the phenomena that take place on the surface of the wing with the DBD plasma actuator turned off and on. The plasma actuator used during the experimental tests has a different structure compared to the classic plasma actuator. The commonly tested plasma actuator uses solid/impermeable electrodes, while in the research, the plasma actuator uses a new type of electrodes, two mesh electrodes separated by an impermeable Kapton dielectric. The experimental research was carried out for the angle of attack α = 15° and several air velocities V = 5-15 m/s with a step of 5 m/s for the Reynolds number Re = 87,500-262,500. The critical angle of attack at which the SD 7003 profile has the maximum lift coefficient is about 11°; during the experimental research, the angle was 15°. Despite the high angle of attack, it was possible to increase the lift coefficient. The use of a plasma actuator with two mesh electrodes allowed to increase the lift by 5%, even at a high angle of attack. During experimental research used high voltage power supply for powering the DBD plasma actuator in the voltage range from 7.5 to 15 kV.
RESUMEN
This paper describes airfield measurement of forces and moments that act on a landing gear wheel. For the measurement, a wheel force sensor was used. The sensor was designed and built based on strain gage technology and was embedded in the left landing gear wheel of a test aircraft. The sensor is capable of measuring simultaneously three perpendicular forces and three moments and sends data to a handheld device wirelessly. For the airfield tests, the sensor was installed on a PZL 104 Wilga 35A multipurpose aircraft. The aircraft was towed at a "marching man" speed and the measurements were performed at three driving modes: Free rolling, braking, and turning. The paper contains results obtained in the field measurements performed on a grassy runway of the Rzeszów Jasionka Aerodrome, Poland. Rolling resistance of aircraft tire, braking friction, as well as aligning moment were analyzed and discussed with respect to surface conditions.