RESUMEN
CONTEXT: Ammonium Tutton salts have been widely studied in recent years due to their thermostructural properties, which make them promising compounds for application in thermochemical energy storage devices. In this work, a detailed experimental study of the Tutton salt with the formula (NH4)2Zn(SO4)2(H2O)6 is carried out. Its structural, vibrational, and thermal properties are analyzed and discussed. Powder X-ray diffraction (PXRD) studies confirm that the compound crystallizes in a structure of a Tutton salt, with monoclinic symmetry and P21/a space group. The Hirshfeld surface analysis results indicate that the main contacts stabilizing the material crystal lattice are H···O/O···H, H···H, and O···O. In addition, a typical behavior of an insulating material is confirmed based on the electronic bandgap calculated from the band structure and experimental absorption coefficient. The Raman and infrared spectra calculated using DFT are in a good agreement with the respective experimental spectroscopic results. Thermal analysis in the range from 300 to 773 K reveals one exothermic and several endothermic events that are investigated using PXRD measurements as a function of temperature. With increasing temperature, two new structural phases are identified, one of which is resolved using the Le Bail method. Our findings suggest that the salt (NH4)2Zn(SO4)2(H2O)6 is a promising thermochemical material suitable for the development of heat storage systems, due to its low dehydration temperature (≈ 330 K), high enthalpy of dehydration (122.43 kJ/mol of H2O), and hydration after 24 h. METHODS: Computational studies using Hirshfeld surfaces and void analysis are conducted to identify and quantify the intermolecular contacts occurring in the crystal structure. Furthermore, geometry optimization calculations are performed based on density functional theory (DFT) using the PBE functional and norm-conserving pseudopotentials implemented in the Cambridge Serial Total Energy Package (CASTEP). The primitive unit cell optimization was conducted using the Broyden-Fletcher-Goldfarb-Shanno (BFGS) algorithm. The electronic properties of band structure and density of states, and vibrational modes of the optimized crystal lattice are calculated and analyzed.
RESUMEN
In this paper, novel mixed Tutton salts with the chemical formulas K2Mn0.03Ni0.97(SO4)2(H2O)6 and K2Mn0.18Cu0.82(SO4)2(H2O)6 were synthesized and studied as compounds for thermochemical heat storage potential. The crystallographic structures of single crystals were determined by X-ray diffraction. Additionally, a comprehensive computational study, based on density functional theory (DFT) calculations and Hirshfeld surface analysis, was performed to calculate structural, electronic, and thermodynamic properties of the coordination complexes [MII(H2O)6]2+ (MII = Mn, Ni, and Cu), as well as to investigate intermolecular interactions and voids in the framework. The axial compressions relative to octahedral coordination geometry observed in the crystal structures were correlated and elucidated using DFT investigations regarding Jahn-Teller effects arising from complexes with different spin multiplicities. The spatial distributions of the frontier molecular orbital and spin densities, as well as energy gaps, provided further insights into the stability of these complexes. Thermogravimetry, differential thermal analysis, and differential scanning calorimetry techniques were also applied to identify the thermal stability and physicochemical properties of the mixed crystals. Values of dehydration enthalpy and storage energy density per volume were also estimated. The two mixed sulfate hydrates reported here have low dehydration temperatures and high energy densities. Both have promising thermal properties for residential heat storage systems, superior to the Tutton salts previously reported.
RESUMEN
Tutton salts have been extensively explored in recent decades due to their attractive physical and chemical properties, which make them potential candidates for thermochemical heat storage systems and optical technologies. In this paper, a series of new mixed Tutton salts with the chemical formula (NH4)2Mn1-xZnx(SO4)2(H2O)6 is reported. Crystals are successfully grown by the solvent slow evaporation method and characterized by powder X-ray diffraction (PXRD) with Rietveld refinement. In particular, the crystal structure of the mixed (NH4)2Mn0.5Zn0.5(SO4)2(H2O)6 crystal is solved through PRXD data using the DICVOL06 algorithm for diffraction pattern indexing and the Le Bail method for lattice parameter and spatial group determination. The structure is refined using the Rietveld method implemented in TOPAS® and reported in the Cambridge Structural Database file number 2104098. Moreover, a computational study using Hirshfeld surface and crystal void analyses is conducted to identify and quantify the intermolecular interactions in the crystal structure as well as to determine the amount of free space in the unit cell. Furthermore, 2D-fingerprint plots are generated to evaluate the main intermolecular contacts that stabilize the crystal lattice. Density functional theory is employed to calculate the structural, thermodynamic, and electronic properties of the coordination [Zn(H2O)6]2+ and [Mn(H2O)6]2+ complexes present in the salts. Molecular orbitals, bond lengths, and the Jahn-Teller effect are also discussed. The findings suggest that in Mn-Zn salts several properties dependent on the electronic structure can be tuned up by modifying the chemical composition.
RESUMEN
Structural properties of binary CeAl, CeMn, NiAl, CeZr, SnTi and ZrMn nanocomposite oxide catalysts were monitored towards the Laser Raman spectroscopy investigations providing new insights to control catalytic applications upon temperature ranges at which the laser power was varied. The lattice vibrational properties were investigated by varying the incident laser power during Raman measurements from 0.017 mW to 4.0 mW. Structural changes in nanocomposites were achieved upon increasing laser power, which induced local heating disorder causing the sintering of CeMn, SnTi, and ZrMn nanocomposites. The laser-power dependence effects on the structural stability of CeAl, NiAl, and CeZr were observed with high amounts of oxygen vacancy defects over CeAl upon laser power heating. Both CeMn and ZrMn exhibited phase transitions from MnO2 to α-Mn2O3 being the use of the latter nanocomposites limited to work at 1.1 mW. The structure-activity correlations for the nanocomposite oxide catalysts were evaluated through the acetylation of glycerol with acetic acid reaction to produce valuable acetins. Remarkable shifts in the Raman bands wavenumbers and other spectral changes in the lattice mode were caused by laser-induced phenomena accounting for the undesired phase formation and particle growths, as well. This resulted in a low catalytic performance of the NiAl, SnTi, CeMn and ZrMn owing to the thermal effects. Contrary, CeAl and CeZr were more active for acetins products avoiding the phase transformations due to their structural stability at high temperatures, which in turn avoided leaching of the active Ce sites during the reaction.
RESUMEN
In the original publication, there was a mistake in Figure 1 as published [...].
RESUMEN
Effects of the incorporation of Cr, Ni, Co, Ag, Al, Ni and Pt cations in titanate nanotubes (NTs) were examined on the NOx conversion. The structural and morphological characterizations evidenced that the ion-exchange reaction of Cr, Co, Ni and Al ions with the NTs produced catalysts with metals included in the interlayer regions of the trititanate NTs whereas an assembly of Ag and Pt nanoparticles were either on the nanotubes surface or inner diameters through an impregnation process. Understanding the role of the different metal cations intercalated or supported on the nanotubes, the optimal selective catalytic reduction of NOx by CO reaction (SCR) conditions was investigated by carrying out variations in the reaction temperature, SO2 and H2O poisoning and long-term stability runs. Pt nanoparticles on the NTs exhibited superior activity compared to the Cr, Co and Al intercalated in the nanotubes and even to the Ag and Ni counterparts. Resistance against SO2 poisoning was low on NiNT due to the trititanate phase transformation into TiO2 and also to sulfur deposits on Ni sites. However, the interaction between Pt2+ from PtOx and Ti4+ in the NTs favored the adsorption of both NOx and CO enhancing the catalytic performance.
RESUMEN
High temperature and pressure effects on the physicochemical properties of binary oxides catalysts were investigated. The nanocomposites catalysts comprising of CeAl, CeMn and NiAl were characterized through various physicochemical techniques. A study of the temperature and pressure induced phenomena monitored by Raman spectroscopy was proposed and discussed. Spectral modifications of the Raman modes belonging to the CeMn suggest structural changes in the solid due to the MnO2 phase oxidation with increasing temperature. The thermal expansion and lattice anharmonicity effects were observed on CeMn due to lack of stability of the lattice vacancies. The CeAl and NiAl composites presented crystallographic stability at low temperatures however, undertake a phase transformation of NiO/Al2O3 into NiAl2O4, mostly without any deformation in its structure with increasing the temperature. It was also inferred that the binary oxides are more stables in comparison with monoxides. Detailed pressure-dependent Raman measurements of the T2g phonon mode of CeMn and NiAl revealed that the pressure contributes to modify bonds length and reduces the particles sizes of the solids. On the contrary, high pressure on CeAl sample improved the stability with addition of Al2O3 in the CeO2 lattice. The results then suggest a good stability of CeAl and NiAl composite catalysts at high pressure and low temperature and show how to prospect of tuning the catalysis for surface reactions entirely through in situ spectroscopic investigations means.
RESUMEN
We have fabricated thin erbium-doped amorphous silicon sub-oxide (a-SiOx