RESUMEN
Serum creatinine (CR) is regarded as one of the most sought out prognostic biomarkers in medical evaluation of chronic kidney disease (CKD). In light of the diagnostic significance of CR, the utility of a fluorescence biosensor for its detection in human urine specimens has been explored based on Förster resonance energy transfer (FRET) across nitrogen-doped carbon dots (N-CDs) and gold nanoparticles (GNPs). A straightforward microwave-assisted synthesis procedure has been adopted to prepare N-CDs (λexcitation = 400 nm, λemission = 540 ± 5 nm) with bright green emissions. On addition of pre-synthesized GNPs, the radiative emanation of the N-CDs is completely suppressed on account of FRET across the N-CDs and the GNPs. About 77 % of their fluorescence intensity is recovered after adding CR to GNPs@N-CDs nanocomposite. The limit of detection for CR sensing is estimated as 0.02 µgâ¢mL-1. This biosensor is selective enough to recognize CR in the existence of potential interfering substances (e.g., ascorbic acid, glucose, glutathione, urea, and electrolytes). Its practical utility for CR detection has been validated further on the basis of satisfactory correlation with the benchmark Jaffe method, as observed in artificial/human urine specimens. Consequently, this manuscript marks a pioneering report on employing CDs and GNPs-based FRET for identifying CR in urine specimens of CKD patients.
Asunto(s)
Carbono , Creatinina , Transferencia Resonante de Energía de Fluorescencia , Oro , Nanopartículas del Metal , Nitrógeno , Puntos Cuánticos , Humanos , Transferencia Resonante de Energía de Fluorescencia/métodos , Oro/química , Carbono/química , Nanopartículas del Metal/química , Puntos Cuánticos/química , Creatinina/orina , Nitrógeno/química , Límite de Detección , Técnicas Biosensibles/métodosRESUMEN
The underutilization of digestate-derived polymers presents a pressing environmental concern as these valuable materials, derived from anaerobic digestion processes, remain largely unused, contributing to pollution and environmental degradation when left unutilized. This study explores the recovery and utilization of biodegradable polymers from biomass anaerobic digestate to enhance the performance of solar photovoltaic (PV) cells while promoting environmental sustainability. The anaerobic digestion process generates organic residues rich in biodegradable materials, often considered waste. However, this research investigates the potential of repurposing these materials by recovering and transforming them into high-quality coatings or encapsulants for PV cells. The recovered biodegradable polymers not only improve the efficiency and lifespan of PV cells but also align with sustainability objectives by reducing the carbon footprint associated with PV cell production and mitigating environmental harm. The study involves a comprehensive experimental design, varying coating thickness, direct normal irradiance (DNI) (A), dry bulb temperature (DBT) (B), and relative humidity (C) levels to analyze how different types of recovered biodegradable polymers interact with diverse environmental conditions. Optimization showed that better result was achieved at A = 8 W/m2, B = 40 °C and C = 70% for both the coated material studied. Comparative study showed that for enhanced cell efficiency and cost effectiveness, EcoPolyBlend coated material is more suited however for improving durability and reducing environmental impact NanoBioCelluSynth coated material is preferable choice. Results show that these materials offer promising improvements in PV cell performance and significantly lower environmental impact, providing a sustainable solution for renewable energy production. This research contributes to advancing both the utilization of biomass waste and the development of eco-friendly PV cell technologies, with implications for a more sustainable and greener energy future. This study underscores the pivotal role of exploring anaerobic digestate-derived polymers in advancing the sustainability and performance of solar photovoltaic cells, addressing critical environmental and energy challenges of our time.Please confirm if the author names are presented accurately and in the correct sequence (given name, middle name/initial, family name). Author 7 Given name: [Ashok] Last name [Kumar Yadav]. Also, kindly confirm the details in the metadata are correct.correct.
Asunto(s)
Biomasa , Polímeros , Energía Solar , Polímeros/química , Reciclaje , AnaerobiosisRESUMEN
The development of bacterial resistance to chemical therapy poses a severe danger to efficacy of treating bacterial infections. One of the key factors for resistance to antimicrobial medications is growth of bacteria in biofilm. Quorum sensing (QS) inhibition was created as an alternative treatment by developing novel anti-biofilm medicines. Cell-cell communication is impeded by QS inhibition, which targets QS signaling pathway. The goal of this work is to develop newer drugs that are effective against Pseudomonas aeruginosa by decreasing QS and acting as anti-biofilm agents. In this investigation, N-(benzo[d]thiazol-2-yl)benzamide/N-(thiazol-2-yl)benzamide derivatives 3a-h were designed and synthesized in good yields. Further, molecular docking analyses revealed that binding affinity values were founded -11.2 to -7.6â kcal/mol that were moderate to good. The physicochemical properties of these prepared compounds were investigated through in-silico method. Molecular dynamic simulation was also used to know better understanding of stability of the protein and ligand complex. Comparing N-(benzo[d]thiazol-2-yl)benzamide 3a to salicylic acid (4.40±0.10) that was utilised as standard for quorum sensing inhibitor, the anti-QS action was found greater for N-(benzo[d]thiazol-2-yl)benzamide 3a (4.67±0.45) than salicylic acid (4.40±0.10). Overall, research results suggested that N-(benzo[d]thiazol-2-yl)benzamide/N-(thiazol-2-yl)benzamide derivatives 3a-h may hold to develop new quorum sensing inhibitors.
Asunto(s)
Pseudomonas aeruginosa , Percepción de Quorum , Simulación del Acoplamiento Molecular , Biopelículas , Ácido Salicílico/farmacología , Antibacterianos/farmacología , Antibacterianos/química , Proteínas Bacterianas/metabolismoRESUMEN
The effectiveness of treating bacterial infections is seriously threatened by the emergence of bacterial resistance to chemical treatment. Growth of microbes in biofilm is one of the main causes of resistance to antimicrobial drugs. Quorum sensing (QS) inhibition, which targets the QS signalling system by obstructing cell-cell communication, was developed as an alternative treatment by creating innovative anti-biofilm drugs. Therefore, the goal of this study is to develop novel antimicrobial drugs that are effective against Pseudomonas aeruginosa by inhibiting QS and acting as anti-biofilm agents. In this study, N-(2- and 3-pyridinyl)benzamide derivatives were selected to design and syntheses. Antibiofilm activity was revealed by all the synthesized compounds and the biofilm was visibly impaired, and the OD595nm readings of solubilized biofilm cells presented a momentous difference between the treated and untreated biofilms. The best anti-QS zone was observed for compound 5d and found to be 4.96â mm. Through inâ silico research, the physicochemical characteristics and binding manner of these produced compounds were examined. For the purpose of understanding the stability of the protein and ligand complex, molecular dynamic simulation was also carried out. The overall findings showed that N-(2- and 3-pyridinyl)benzamide derivatives could be the key to creating effective newer anti-quorum sensing drugs that are effective against different bacteria.
Asunto(s)
Antiinfecciosos , Pseudomonas aeruginosa , Antibacterianos/química , Percepción de Quorum , Biopelículas , Antiinfecciosos/farmacología , Proteínas Bacterianas/metabolismoRESUMEN
In the present research work, the effect of operating parameters such as molar ratio (3:1-7:1), catalyst concentration (0.5-1.5%), reaction time (5-25 min), and operating pressure (0-4 bar) on the rate of biodiesel conversion percentage for the transesterification reaction using hydrodynamic cavitation (HC) has been studied. Response surface methodology (RSM) and genetic algorithms (GA) were used to find the best condition. The best conditions for biodiesel generation were a molar ratio of 6.5:1, a catalyst concentration of 1.301 wt.%, a reaction period of 11.5 min, and operating pressure of 3.6 bar. The maximum yield of biodiesel obtained under optimal conditions was 97.3%. The reaction time for biodiesel produced by HC under similar conditions as the conventional technique was reduced by 85%. The HC approach is preferable to the conventional method due to its shorter processing time.
Asunto(s)
Biocombustibles , Microalgas , Algoritmos , Catálisis , Esterificación , Hidrodinámica , Aceites de PlantasRESUMEN
Vaccination is the most suitable and persuasive healthcare program for the prohibition of various deadly diseases. However, the higher production cost and purification strategies are out of reach for the developing nations. In this scenario, development of edible vaccine turns out to be the most promising alternative for remodeling the pharmaceutical industry with reduced production and purification costs. Generally, oral route of vaccination is mostly preferred due to its safety, compliance, low manufacturing cost and most importantly the ability to induce immunity in both systemic and mucosal sites. Genetically modified microorganisms and plants could efficiently be used as vehicles for edible vaccines. Edible vaccines are supposed to reduce the risk associated with traditional vaccines. Currently, oral vaccines are available in the market for several viral and bacterial diseases like cholera, hepatitis B, malaria, rabies etc. Herein, the review focuses on the breakthrough events in the area of edible vaccines associated with dietary microbes and plants for better control over diseases.