RESUMEN

In this paper, four treatment techniques commonly applied to Volatile Organic Compounds (VOC) removal from soil are compared in column experiments with pure sand containing a residual Light Non-Aqueous Phase Liquid (L-NAPL) contamination. Oxidation is tested through the injection of Fenton reagent, with persulfate, and combined with sparging with the injection of ozone. Surfactant treatment was conducted at low flow rates with Tween®80. Sparging was conducted by air injection but at a low flow rate of 1 mL min-1. Finally several columns were thermally treated at a temperature of 80 °C. The results showed high removal (>90%) for all techniques used, although only thermal treatment on BTEX (Benzene, Toluene, Ethylbenzene and Xylenes) reached 100% efficiency. The main limiting factors of each technique were: (i) for oxidation, the solubility of the substance limited the removal; (ii) for surfactant both the solubility in the surfactant and the type of surfactant are important; (iii) for sparging, the main factors are contaminant vapor pressure and porous media grain size; (iv) for thermal treatment, the limitation arises from the contaminant vapor pressure and the medium hydraulic conductivity. A comparison with literature data shows that the results are consistent with most of the studies conducted on one technique.

Asunto(s)

RESUMEN

This study compared four treatment techniques for the removal of a toluene/n-decane as NAPL (Non Aqueous Phase Liquid) phase mixture in identical 1 cubic meter tanks filled with different kind of sand. These four treatment techniques were: oxidation with persulfate, surfactant washing with Tween80®, sparging with air followed by ozone, and thermal treatment at 80°C. The sources were made with three lenses of 26×26×6.5cm, one having a hydraulic conductivity similar to the whole tank and the two others a value 10 times smaller. The four techniques were studied after conditioning the tanks with tap water during approximately 80days. The persulfate treatment tests showed average removal of the contaminants but significant flux decrease if density effects are considered. Surfactant flushing did not show a highly significant increase of the flux of toluene but allowed an increased removal rate that could lead to an almost complete removal with longer treatment time. Sparging removed a significant amount but suggests that air was passing through localized gas channels and that the removal was stagnating after removing half of the contamination. Thermal treatment reached 100% removal after the target temperature of 80°C was kept during more than 10d. The experiments emphasized the generation of a high-spatial heterogeneity in NAPL content. For all the treatments the overall removal was similar for both n-decane and toluene, suggesting that toluene was removed rapidly and n-decane more slowly in some zones, while no removal existed in other zones. The oxidation and surfactant results were also analyzed for the relation between contaminant fluxes at the outlet and mass removal. For the first time, this approach clearly allowed the differentiation of the treatments. As a conclusion, experiments showed that the most important differences between the tested treatment techniques were not the global mass removal rates but the time required to reach 99% decrease in the contaminant fluxes, which were different for each technique.

Asunto(s)

RESUMEN

We study the dynamics of two microfluidic droplets emitters placed in parallel. We observe complex dynamical behavior, including synchronization, quasiperiodicity, and chaos. This dynamics has a considerable impact on the properties of the resulting emulsions: chaotic and quasi-periodic regimes give rise to polydispersed emulsions with poorly controllable characteristics, whereas synchronized regimes generate well-controlled monodispersed emulsions. We derive a dynamical model that reproduces the trends observed in the experiment.

RESUMEN

Quantitative measurement of tumor blood flow with [15O]water can be used to evaluate the effects of tumor treatment over time. Since quantitative flow measurements require an input function, we developed the profile fitting method (PFM) to measure the input function from positron emission tomography images of the aorta. First, a [11C]CO scan was acquired and the aorta region was analyzed. The aorta diameter was determined by fitting the image data with a model that includes scanner resolution, the measured venous blood radioactivity concentration, and the spillover of counts from the background. The diameter was used in subsequent fitting of [15O]water dynamic images to estimate the aorta and background radioactivity concentrations. Phantom experiments were performed to test the model. Image quantification biases (up to 15%) were found for small objects, particularly for those in a large elliptical phantom. However, the bias in the PFM concentration estimates was much smaller (2%-6%). A simulation study showed that PFM had less bias and/or variability in flow parameter estimates than an ROI method. PFM was applied to human [11C]CO and [15O]water dynamic studies with left ventricle input functions used as the gold standard. PFM parameter estimates had higher variability than found in the simulation but with minimal bias. These studies suggest that PFM is a promising technique for the noninvasive measurement of the aorta [15O]water input function.

Asunto(s)

RESUMEN

BACKGROUND: An increasing carcinoembryonic antigen (CEA) level in the absence of disease on imaging studies can present a diagnostic challenge. We evaluated 2-[18F] fluoro-2-deoxy-D-glucose and positron emission tomography (FDG-PET) scan and CEA scan before second-look laparotomy as a means of localizing recurrent colorectal cancer. METHODS: Patients underwent computed tomography scan, bone scan, colonoscopy, and magnetic resonance imaging, and those without evidence of disease or resectable disease in the abdomen had FDG-PET and CEA scans. At second-look laparotomy, a surgeon blinded to the results of the FDG-PET and CEA scans performed an exploration and mapped findings. A second surgeon, with knowledge of the FDG-PET and CEA scans, then explored the patient; all lesions were biopsied or resected for pathology. RESULTS: In 28 patients explored, disease was found at operation in 26 (94%). Ten had unresectable disease. FDG-PET scans predicted unresectable disease in 90% of patients. CEA scans failed to predict unresectable disease in any patient. In 16 patients found to have resectable disease or disease that could be treated with regional therapy, FDG-PET scan predicted this in 81% and CEA scan in 13%. CONCLUSIONS: FDG-PET scan can predict those patients who would likely benefit from a laparotomy. If the FDG-PET scan indicates resectable disease, laparotomy can be considered. However, if the findings predict unresectable disease or the absence of disease, the patient should pursue systemic therapy or continued observation.

Asunto(s)

RESUMEN

Thallium-201 and technetium-99m-MIBI uptake are comparable in "maimed" (i.e., partially viable) and hibernating myocardium. The appreciation of myocardial viability should be based not only on the presence of a regional contractility improvement, but also on the evaluation of the initial level of contractility and of tracer uptake in the concerned area.

Asunto(s)