RESUMEN

A record tunability of 35 nm for the LP(11) cladding-mode resonance in a twisted mechanically induced long-period fiber grating using standard single-mode communication fiber is demonstrated. By forming the LP(11) resonance far away from its cut-off wavelength and modifying the grooves of the grating in the form of smooth semicircular humps, a high twist sensitivity of 8.75 nm/(rad/cm) and a controlled tunability of 35 nm is achieved. The fiber with its lacquer coating is not broken even at a severe twist rate of 5.44 rad/cm. The present design can be used as a novel variable optical selective wavelength attenuator since the bandwidth, rejection efficiency, and center wavelength can be controlled by changing the grating length, pressure over the grating, and fiber twist, respectively. Using the results, a cost-effective tunable variable optical attenuator for selective channel-blanking applications is also demonstrated. A fine tunability of 1.5 nm is achieved for a twist rate change of 0.1 rad/cm.

RESUMEN

FT-IR and FT-Raman spectra of 2,4-dichlorobenzonitrile at room temperature have been recorded in the regions 200-3500cm(-)(1) and 0-3400cm(-)(1), respectively. The observed vibrational bands were analyzed and assigned to different normal modes of the molecule according to the Wilson's notation. Density functional calculations were performed to support our frequency assignments. Specific scale equations deduced from the benzene molecule were employed to improve the calculated values. For the majority of the normal modes, the deviations between the corresponding experimental and scaled theoretical wavenumbers are located in the expected range. A correct characterization of each normal mode is of vital importance in the assignment of the observed bands, and the same has been successfully done by the aid of Potential Energy Distributions (PEDs) calculated separately for each normal mode of 2,4-dichlorobenzonitrile. The molecular structure was optimized and several thermodynamic parameters were determined. HOMO and LUMO orbital energy analysis were carried out.

Asunto(s)

RESUMEN

An accurate assignment of the IR spectrum in Ar matrix of 5-bromocytosine and of the IR and Raman spectra in the solid state was carried out. For this purpose Density functional calculations (DFTs) were performed to clarify wavenumber assignments of the experimental observed bands. The calculated values were scaled using scaling equations and they were compared with IR and Raman experimental data. Good reproduction of the experimental wavenumbers is obtained and the% error is very small in the majority of cases. In the isolated state all the tautomer forms of 5-bromocytosine were determined and optimized. The wavenumbers corresponding to C1 and C2b tautomers were identified and assigned in the IR experimental spectrum reported in Ar matrix. Our study confirms the existence of at least two tautomers, the amino-oxo and the amino-hydroxy in the isolated state. In the solid state the FT-IR and FT-Raman spectra of 5-bromocytosine in the powder form were recorded in the region 400-4000 cm(-1) and 50-3500 cm(-1), respectively. The unit cell found in the crystal was simulated as a tetramer form in three tautomers. Thus, it has been possible to assign all the 33 normal modes of vibration. The study indicates that the features, that are the characteristic of the vibrational spectra of cytosine, are retained by the spectra of 5-bromocytosine and it exists in the solid phase in the amino-oxo form.

Asunto(s)

RESUMEN

The confirmation of authenticity of essential oils and the detection of adulteration are problems of increasing importance in the perfumes, pharmaceutical, flavor and fragrance industries. This is especially true for 'value added' products like sandalwood oil. A methodical study is conducted here to demonstrate the potential use of Near Infrared (NIR) spectroscopy along with multivariate calibration models like principal component regression (PCR) and partial least square regression (PLSR) as rapid analytical techniques for the qualitative and quantitative determination of adulterants in sandalwood oil. After suitable pre-processing of the NIR raw spectral data, the models are built-up by cross-validation. The lowest Root Mean Square Error of Cross-Validation and Calibration (RMSECV and RMSEC % v/v) are used as a decision supporting system to fix the optimal number of factors. The coefficient of determination (R(2)) and the Root Mean Square Error of Prediction (RMSEP % v/v) in the prediction sets are used as the evaluation parameters (R(2) = 0.9999 and RMSEP = 0.01355). The overall result leads to the conclusion that NIR spectroscopy with chemometric techniques could be successfully used as a rapid, simple, instant and non-destructive method for the detection of adulterants, even 1% of the low-grade oils, in the high quality form of sandalwood oil.

Asunto(s)

RESUMEN

The effects on the geometry structure, atomic charges and vibrational wavenumbers of the main different substituents in the 5th position of the uracil ring were analysed, and relationships were established. The 5-monosubstituted derivatives studied were 5-XU (X=F, Cl, Br, I, CH(3), NH(2), NO(2)). The geometry and vibrational wavenumbers were determined in these molecules. The FT-IR and Raman spectra were studied with the support of B3LYP calculations using several basis sets. Several general conclusions were underlined.

Asunto(s)